Download 1004IFD and 1005IFD Satellite Signal Level Meters

Survey
yes no Was this document useful for you?
   Thank you for your participation!

* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project

Document related concepts

Pulse-width modulation wikipedia , lookup

Phone connector (audio) wikipedia , lookup

History of electric power transmission wikipedia , lookup

Ground loop (electricity) wikipedia , lookup

Current source wikipedia , lookup

Three-phase electric power wikipedia , lookup

Telecommunications engineering wikipedia , lookup

Electric battery wikipedia , lookup

Islanding wikipedia , lookup

Variable-frequency drive wikipedia , lookup

Schmitt trigger wikipedia , lookup

Surge protector wikipedia , lookup

Rectifier wikipedia , lookup

Stray voltage wikipedia , lookup

Regenerative circuit wikipedia , lookup

Ohm's law wikipedia , lookup

Multimeter wikipedia , lookup

Heterodyne wikipedia , lookup

Voltage regulator wikipedia , lookup

Power electronics wikipedia , lookup

Resistive opto-isolator wikipedia , lookup

Rechargeable battery wikipedia , lookup

Buck converter wikipedia , lookup

Metadyne wikipedia , lookup

Voltage optimisation wikipedia , lookup

Switched-mode power supply wikipedia , lookup

Alternating current wikipedia , lookup

Opto-isolator wikipedia , lookup

Mains electricity wikipedia , lookup

Low-noise block downconverter wikipedia , lookup

Transcript
1004IFD/1005IFD Satellite Signal Level Meters
The 1004IFD and the 1005IFD are intended to aid in the alignment of a satellite dish. They Include satellite
IF (950-2150 MHz) amplification and a broadband detector. The detector drives a meter and a variable
frequency audio tone. The dish is then aligned for maximum meter deflection or highest pitch tone. A gain
control allows a wide range of input signal levels, measurements of voltage on cable and LNBF current.
The units are connected to the LNB via a short coaxial cable. The 1004IFD output must be connected to the
satellite receiver in order to supply power meter output must be connected to the satellite receiver in order to
supply power. The units operate from 11-24 VDC on the coaxial cable. Connection to the receiver is
optional with the 1005IFD but extends battery life between charges.
All models allow measurement of voltage on the coaxial cable. The 1005IFD will also measure LNB current.
The 1005IFD includes an internal rechargeable NiCad battery pack, carrying strap and a wall plug
recharging unit.
The internal battery pack allows a dish to be aligned before it is connected to the satellite receiver. The
battery pack is switchable between 13V and 18V output, allowing either polarization to be selected when
used with a voltage switched LNB. In US DBS applications, LHCP is selected when the LNB voltage is
nominally 17V.
Specifications
Specifications
Frequency Range
1004 IFD
1005 IFD
950-2050 MHz
950-2050 MHz
Impedance
75 Ohm
75 Ohm
Connectors
"F" female
"F" female
Audio Tone
Yes
Yes
LNB Voltage Measurement
Yes
Yes
LNB Current Measurement
No
Yes
4.5 dB
4.5 dB
1 Transponder
-30 to +4
-30 to +4
8 Transponders
-39 to -5
-39 to -5
16 Transponders
-42 to -8
-42 to -8
Insertion Loss (dBm)
Input Level Range (dBm)
Dimensions (HxWxD)
Weight
5.8"x3.6"x2.8"
7.3”x4.8”x3.3”
147x92x72 mm 185x122x84 mm
17oz. (482 g)
36oz. (1020 g)
Wall Plug Charging Voltage
N/A
24 VDC
Battery Capacity (mA Hrs.)
N/A
600
Battery Life
(Hours Between Charge)
N/A
3