Download TGMS Tool Signal Worksheet

TGMS Tool Signal Worksheet
Signal Type
Required?
Circuit Type
(dry contact,
NPN, PNP) *
Connector
Type
Form Number/Rev #
EHS-00031-F12 R1
Terminal or Pin
Numbers#
If other than
terminal block, is
mating connector
supplied?
TOOL OUTPUTS
On-Board Liquid Leak
Detector 1
On-Board Liquid Leak
Detector 2
On-Board Liquid Leak
Detector 3
EMO signals (output,
signal is active when tool is
in EMO state)
Abatement Alarm 1
Abatement Alarm 2
Abatement Alarm 3
Abatement Fault 1
Abatement Fault 2
Abatement Fault 3
Fire Detection/Suppression
1
Fire Detection/Suppression
2
Fire Detection/Suppression
3
Other Life Safety Devices
TOOL INPUTS
Tool Enable (dry contact
from TGMS)
* NOTE: Signals must be suitable for 24V circuit.); # If NPN or PNP, circle collector terminal
number.
Printed copies are considered uncontrolled. Verify revision prior to use.
DCN0451
CNSE Confidential When Completed
Page 1 of 1