Download 6 - 10.5 CYU Suggested Answers - Tse

Survey
yes no Was this document useful for you?
   Thank you for your participation!

* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project

Document related concepts

Transistor–transistor logic wikipedia , lookup

Valve RF amplifier wikipedia , lookup

Integrating ADC wikipedia , lookup

Josephson voltage standard wikipedia , lookup

Test probe wikipedia , lookup

Negative resistance wikipedia , lookup

CMOS wikipedia , lookup

TRIAC wikipedia , lookup

Power electronics wikipedia , lookup

Operational amplifier wikipedia , lookup

Schmitt trigger wikipedia , lookup

Two-port network wikipedia , lookup

Switched-mode power supply wikipedia , lookup

Voltage regulator wikipedia , lookup

Power MOSFET wikipedia , lookup

Multimeter wikipedia , lookup

Surge protector wikipedia , lookup

Rectiverter wikipedia , lookup

Current source wikipedia , lookup

Electrical ballast wikipedia , lookup

Network analysis (electrical circuits) wikipedia , lookup

Current mirror wikipedia , lookup

Resistive opto-isolator wikipedia , lookup

Ohm's law wikipedia , lookup

Opto-isolator wikipedia , lookup

Transcript
10.5 CYU Suggested Answers pg. 325
1. The total voltage of resistors in series is equal to the sum of the individual voltages. The total voltage
of resistors in parallel is equal to the voltage of any one of the resistors (the resistors all have the same
voltage).
2. (a) Answers may vary. A sample circuit diagram is shown (the battery is made of six cells that each
have a voltage of 1.5 V).
(b) Since the resistors are in series, they each get 2.25 V (or one quarter of the 9 V). Using this and
Ohm’s law gives 0.10 A in each resistor.
(c) The total resistance is 22 Ω x 4 = 88 Ω.
3. (a) The voltage of each resistor is 120 V.
(b) The current in each resistor is 0.6 A.
(c) The resistance of each resistor is 200 Ω.
(d) The total resistance is 100 Ω.
4. (a) The current in the second light bulb is 280 mA.
(b) The light bulbs are not identical. Since they have equal voltages and different currents, according to
Ohm’s law they have different resistances.
(c) The resistance of the first light bulb is R1 = 19 Ω; the second light bulb is R2 = 11 Ω; and the total
resistance is RT = 6.8 Ω.
(d) There will be no voltage (or V2 = 0 V). The opened switch disconnects the light from the circuit—
there is no complete path.
(e) The voltage across the first bulb is still 3 V
(f) The current delivered by the battery is IT = 160 mA.
5. The total resistance of the three resistors in series is 180 Ω.
6. The diagram shows the placement of the meters.
7. The diagram shows the placement of the meters.
8. (a) The voltages of the resistors are V1 = 6 V, V2 = 6 V, and V3 12 V.
(b) The current in a resistor is inversely proportional to the resistance. Since the resistance of the first
branch is twice that of the second branch, the current will be half, or 250 mA.
(c) The total current delivered by the battery is 250 mA + 500 mA = 750 mA. Therefore, the total
resistance is 16 Ω.