Download report_697430079

Survey
yes no Was this document useful for you?
   Thank you for your participation!

* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project

Document related concepts
no text concepts found
Transcript
VERTICAL QOS MAPPING
OVER WIRELESS
INTERFACES
Marchese, M.; Mongelli, M.;
Wireless Communications, IEEE
Volume 16, Issue 2, April 2009 Page(s):37 - 43
Report : Jai- Shiarng Chen
Department of Communications Engineering CCU
CN Group
Outline
 Introduction
 The technology-independent service access
point
 TI-SAP model
 Vertical QoS mapping problem
 Reference scheme for dynamic QoS mapping
over TI-SAP interface
 Example results
 conclusions
2
CN Group
Introduction
 Modern telecommunication networks

Different portions and technologies
 The end-to-end Qos is challenged
Over heterogeneous
 Horizontal QoS




Source to the destination
The protocol used and the network features
Vertical QoS

Composed of layered architectures
3
CN Group
Introduction(cont.)
 Qos achieved at each layer of the network
 Define an interface between adjacent layers
4
CN Group
Introduction(cont.)
 Establish a QoS-oriented between layers
 A good example



European Telecommunications
Standards Institute (ETSI)
Broadband satellite multimedia(BSM)
Satellite-dependent(SD)


Satellite-independent(SI)


Physical , MAC and link control
IP and upper layers
Satellite independent –service
access point(SI_SAP)

Offer QoS service
 The architecture is generalized
Different physical supports
 Wire and wireless
CN Group

5
Introduction(cont.)
 The idea is to extend
Technology-dependent(TD)
 Technology-independent(TI)
 Technology independent-service access point(TI-SAP)



Use specific hardware/software solution, often covered by
patents
TD and TI communication without affecting TD-layer
implementation
 Dynamic bandwidth adaptation at TI-SAP

Vertical QoS mapping
6
CN Group
The technology-independent
service access point
 TI-SAP within a wireless portion

Overall IP-based heterogeneous
network composed of wide area
networks
 Wireless portion is located in the
middle

Between two generic WANs
 The lower must offer a QoS

Guarantee to the upper layer
7
CN Group
TI-SAP model
 TI-SAP include
Abstract queue
 Identifies a specific QoS level
 Transfer packets from the TI to the TD layer

 A battery of buffers at the TI-SAP
Any network node is implemented
 Different levels of QoS

 Different QoS service

TI layer can access and modify the abstract queue
8
CN Group
TI-SAP model
 TI resource management entry

Allocates and manage resource (IP)
 TD resource management entry


Physically allocates the required
resource
Network control center(NCC)

Bandwidth is allocated
–
Different remote stations
 QoS mapping management entry



Receive resource require from TI
The entry maps it on the lower layer
Applied at the TD layer

Translate the request(reservation ,
release and modification actions)
9
CN Group
Vertical QoS mapping problem
 Change of information unit


The information come from upper layer
Overhead


TI layer is encapsulated within new frame composed information
TD layer must consider the additional bits of the header
 Heterogeneous traffic aggregation

Bandwidth must be adapted at TD

Queue number decreases from upper
to lower layer
 Fading effect

Must handle time-vary-channel
condition

CN Group
Such as satellite and wireless links
Reference :M. Marchese, QoS over Heterogeneous
Networks, John Wiley & Sons, 2007.
10
Vertical QoS mapping problem
(cont.)
 Joint problem

Fading effect can be modeled




A multiplicative stochastic process
0(total outage)to 1(free error channel)
The model can be iterated
Bandwidth adaptation



Very challenging
RTD guarantee to TI layer queue
Equivalent bandwidth(EqB)
– Minimum service rate to guarantee a certain degree
of QoS
– Single QoS constraint

The complexity of overall input flow process
– Almost non-applicable
11
CN Group
Reference scheme for dynamic QoS
mapping over TI-SAP interface
 Allocate bandwidth periodically at the TD layer

After receiving the QoS constraints through TI-SAP
 RTD(tk) allocation the instant tk
 An information vector
TD buffer
 Simply the error e(tk)


Above 0, minimum additional amount of bandwidth
– Enable the satisfaction of QoS constraints

Below 0, over-provisioned bandwidth
– Maximum amount of bandwidth that can dropped without violating QoS

Minimum bandwidth that guarantees the QoS constraints

CN Group
In the interval [tk-1 , tk]
12
Reference scheme for dynamic QoS
mapping over TI-SAP interface(cont.)
 RTF(tk) = RTD(tk–1) + wk ⋅ e(tk)

wk is a weight
 Arrived and lost bits at the TD-layer
Compute the loss rate that can be tolerated
 Check the bandwidth under-provision or over-provision



Estimation of the bandwidth requirement
Allocate the bandwidth in the next interval consequently
 Reference chaser bandwidth controller(RCBC)

Use the sensitivity of the system performance


CN Group
Variations of the allocation bandwidth
Weight : Wk dynamically over time
13
 Trunk of 50 VoIP
 TI -> TI-SAP -> TD

Example results
ATM at TD layer
 Only one IP queue
and one ATM queue
 Performance metric

Packet loss


2 。10 -2
Packet delay

20 ms
 Bandwidth reallocation

Every minute
 Buffer size


TI : 1600bytes
(20 VoIP packet)
TD: 3710 byte
(70 ATM cell)
 Four peaks

Reduction factor
change
CN Group
 Quick reaction and bandwidth adaptation
14
Conclusion
 Dynamic schemes based on measure
Quickly to change in traffic
 Performance parameter

 Complex mathematical traffic models

Unsuitable for real network conditions
 Future research
Implementation detail of bandwidth adaptation
mechanisms
 Implement RCBC within a TI-SAP-based architecture

15
CN Group
Thank you
16
CN Group
BSM architecture
Broadband satellite multimedia
 CSF-1: The interface between the IETF protocols and the Client function (internal to
the IP layer).
 • CSF-2: The interface between the peer IETF Client [interworking] functions.
17
 • CSF-3: The interface between the Client function and the Server function(s).
CN Group
ETSI BSM protocol stack
CN Group
Reference : ETSI, Satellite Earth Stations and Systems (SES), Broadband Satellite Multimedia, IP
over Satellite, ETSI Technical Report, TR 101 985 V1.1.2, November 2002.
18