Download ppt - NOISE

Survey
yes no Was this document useful for you?
   Thank you for your participation!

* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project

Document related concepts

Deep packet inspection wikipedia , lookup

Recursive InterNetwork Architecture (RINA) wikipedia , lookup

Point-to-Point Protocol over Ethernet wikipedia , lookup

AppleTalk wikipedia , lookup

Multiprotocol Label Switching wikipedia , lookup

CAN bus wikipedia , lookup

IEEE 802.1aq wikipedia , lookup

Zero-configuration networking wikipedia , lookup

Telephone exchange wikipedia , lookup

Cracking of wireless networks wikipedia , lookup

Wake-on-LAN wikipedia , lookup

Spanning Tree Protocol wikipedia , lookup

Transcript
Interconnection: Switching and
Bridging
CS 4251: Computer Networking II
Nick Feamster
Fall 2008
In This Lecture
• How hosts find each other on a subnet
– Address Resolution Protocol (ARP)
– Broadcast
• Interconnecting subnets
– Switches: Forwarding and filtering
– Self-learning bridges
– Spanning tree protocols
• Switches vs. Hubs
• Swtiches vs. Routers
• Can Ethernet scale to a million nodes?
– VLANs
– Other alternatives
2
Bootstrapping: Networks of Interfaces
• LAN/Physical/MAC address
– Flat structure
– Unique to physical interface (no two alike)…how?
datagram
receiver
link layer protocol
sender
frame
frame
adapter
adapter
• Frames can be sent to a specific MAC address
or to the broadcast MAC address
What are the advantages to separating network layer from MAC layer?
3
ARP: IP Addresses to MAC addresses
• Query is IP address, response is MAC address
• Query is sent to LAN’s broadcast MAC address
• Each host or router has an ARP table
– Checks IP address of query against its IP address
– Replies with ARP address if there is a match
Potential problems with this approach?
• Caching on hosts is really important
– Try arp –a to see an ARP table
4
Life of a Packet: On a Subnet
• Packet destined for outgoing IP address arrives
at network interface
– Packet must be encapsulated into a frame with the
destination MAC address
• Frame is sent on LAN segment to all hosts
• Hosts check destination MAC address against
MAC address that was destination IP address of
the packet
5
Interconnecting LANs
• Receive & broadcast (“hub”)
• Learning switches
• Spanning tree (RSTP, MSTP,
etc.) protocols
6
Interconnecting LANs with Hubs
• All packets seen everywhere
– Lots of flooding, chances for collision
• Can’t interconnect LANs with heterogeneous
media (e.g., Ethernets of different speeds)
hub
hub
hub
hub
7
Problems with Hubs: No Isolation
• Scalability
• Latency
– Avoiding collisions requires backoff
– Possible for a single host to hog the medium
• Failures
– One misconfigured device can cause problems for
every other device on the LAN
8
Improving on Hubs: Switches
• Link-layer
– Stores and forwards Ethernet frames
– Examines frame header and selectively
forwards frame based on MAC dest address
– When frame is to be forwarded on segment,
uses CSMA/CD to access segment
• Transparent
– Hosts are unaware of presence of switches
• Plug-and-play, self-learning
– Switches do not need to be configured
9
Switch: Traffic Isolation
• Switch breaks subnet into LAN segments
• Switch filters packets
– Same-LAN-segment frames not usually forwarded
onto other LAN segments
– Segments become separate collision domains
switch
collision
domain
hub
collision domain
hub
collision domain
hub
10
Filtering and Forwarding
• Occurs through switch table
• Suppose a packet arrives destined
for node with MAC address x from
interface A
– If MAC address not in table, flood (act
like a hub)
– If MAC address maps to A, do nothing
(packet destined for same LAN segment)
– If MAC address maps to another
interface, forward
LAN
B
A
B
C
LAN
A
LAN
C
• How does this table get configured?
11
Advantages vs. Hubs
• Better scaling
– Separate collision domains allow longer distances
• Better privacy
– Hosts can “snoop” the traffic traversing their segment
– … but not all the rest of the traffic
• Heterogeneity
– Joins segments using different technologies
12
Disadvantages vs. Hubs
• Delay in forwarding frames
–
–
–
–
Bridge/switch must receive and parse the frame
… and perform a look-up to decide where to forward
Storing and forwarding the packet introduces delay
Solution: cut-through switching
• Need to learn where to forward frames
– Bridge/switch needs to construct a forwarding table
– Ideally, without intervention from network
administrators
– Solution: self-learning
13
Motivation For Self-Learning
• Switches forward frames selectively
– Forward frames only on segments that need them
• Switch table
– Maps destination MAC address to outgoing interface
– Goal: construct the switch table automatically
B
A
C
switch
D
14
(Self)-Learning Bridges
• Switch is initially empty
• For each incoming frame, store
– The incoming interface from which the frame arrived
– The time at which that frame arrived
– Delete the entry if no frames with a particular source address
arrive within a certain time
Switch learns
how to reach A.
B
A
C
D
15
Cut-Through Switching
• Buffering a frame takes time
– Suppose L is the length of the frame
– And R is the transmission rate of the links
– Then, receiving the frame takes L/R time units
• Buffering delay can be a high fraction of total
delay, especially over short distances
A
B
switches
16
Cut-Through Switching
• Start transmitting as soon as possible
– Inspect the frame header and do the look-up
– If outgoing link is idle, start forwarding the frame
• Overlapping transmissions
– Transmit the head of the packet via the outgoing link
– … while still receiving the tail via the incoming link
– Analogy: different folks crossing different intersections
A
B
switches
17
Limitations on Topology
• Switches sometimes need to broadcast frames
– Unfamiliar destination: Act like a hub
– Sending to broadcast
• Flooding can lead to forwarding loops and
broadcast storms
– E.g., if the network contains a cycle of switches
– Either accidentally, or by design for higher reliability
Worse yet, packets can be duplicated and proliferated!
18
Solution: Spanning Trees
• Ensure the topology has no loops
– Avoid using some of the links when flooding
– … to avoid forming a loop
• Spanning tree
– Sub-graph that covers all vertices but contains no cycles
– Links not in the spanning tree do not forward frames
19
Constructing a Spanning Tree
• Elect a root
– The switch with the smallest identifier
• Each switch identifies if its interface
is on the shortest path from the root
– And it exclude from the tree if not
– Also exclude from tree if same distance,
but higher identifier
root
• Message Format: (Y, d, X)
– From node X
– Claiming Y as root
– Distance is d
One hop
Three hops
20
Steps in Spanning Tree Algorithm
• Initially, every switch announces itself as the root
– Example: switch X announces (X, 0, X)
• Switches update their view of the root
– Upon receiving a message, check the root id
– If the new id is smaller, start viewing that switch as root
• Switches compute their distance from the root
– Add 1 to the distance received from a neighbor
– Identify interfaces not on a shortest path to the root and exclude
those ports from the spanning tree
21
Example From Switch #4’s Viewpoint
• Switch #4 thinks it is the root
– Sends (4, 0, 4) message to 2 and 7
• Switch #4 hears from #2
1
– Receives (2, 0, 2) message from 2
– … and thinks that #2 is the root
– And realizes it is just one hop away
• Switch #4 hears from #7
–
–
–
–
Receives (2, 1, 7) from 7
And realizes this is a longer path
So, prefers its own one-hop path
And removes 4-7 link from the tree
3
5
2
4
7
6
22
Switches vs. Routers
Switches
• Switches are automatically configuring
• Forwarding tends to be quite fast, since packets
only need to be processed through layer 2
Routers
• Router-level topologies are not restricted to a
spanning tree
– Can even have multipath routing
23
Scaling Ethernet
• Main limitation: Broadcast
– Spanning tree protocol messages
– ARP queries
• High-level proposal: Distributed directory service
–
–
–
–
Each switch implements a directory service
Hosts register at each bridge
Directory is replicated
Queries answered locally
• …are there other ways to do this?
24