Download Slide 1

Survey
yes no Was this document useful for you?
   Thank you for your participation!

* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project

Document related concepts

Tinnitus wikipedia , lookup

Telecommunications relay service wikipedia , lookup

Sound localization wikipedia , lookup

Hearing loss wikipedia , lookup

Auditory system wikipedia , lookup

Olivocochlear system wikipedia , lookup

Evolution of mammalian auditory ossicles wikipedia , lookup

Soundscape ecology wikipedia , lookup

Ear wikipedia , lookup

Audiology and hearing health professionals in developed and developing countries wikipedia , lookup

Sensorineural hearing loss wikipedia , lookup

Noise in music wikipedia , lookup

Noise-induced hearing loss wikipedia , lookup

Earplug wikipedia , lookup

Transcript
NOISE AND ACOUSTICS
Hazardous noise exposures occur
on the job ..…
and off the job.
NOISE AND ACOUSTICS
Noise-Induced Hearing Loss

Causes no pain

Causes no visible trauma

Leaves no visible scars

Is unnoticeable in its earliest stages

Accumulates with each over-exposure

Takes years to diagnose
Is permanent and 100% preventable
NOISE AND ACOUSTICS
NOISE AND ACOUSTICS
How do I know if the noise levels are hazardous?
If you must shout to be understood over
the background noise when standing
about one arm-length away from
somebody,
that background noise is
hazardous.
NOISE AND ACOUSTICS
Time-Weighted Average
Permissible Exposure Limits
OSHA STANDARD
Time-Weighted Average
Permissible Exposure Limits
HOW WE HEAR

Sound waves cause
the eardrum to vibrate

Bones in middle ear
transmit vibrations to
cochlea

Receptors (hair cells)
in cochlea convert
vibrations to electrical
energy

Brain interprets these
electrical impulses as
sound
HOW WE HEAR

Nerve cells in the
cochlea are tuned to
specific frequencies

Base of the cochlea is
sensitive to high
frequency sounds

Tip of the cochlea is
sensitive to low
frequency sounds
HOW WE HEAR
17-year old girl
76-year old man
59-year old man
• Low noise exposure
• Low noise exposure
• High noise exposure
• Normal cochlea
• Fewer receptors but
still intact
• Damaged cochlea
• Receptors intact
• Receptors destroyed
HOW WE HEAR
High-frequency sounds of speech
F
T
HPD SELECTION
COMFORT
COMPATIBILITY
WITH OTHER
PPE
CLEANLINESS
NOISE
REDUCTION
The Best
Hearing
Protection
SPECIAL JOB
REQUIREMENTS
SIZE
COMMUNICATION
NEEDS
HPD SELECTION
Common Objections to Wearing HPDs
“I already lost some of my
hearing, so why should I
wear them?”
“Hearing protectors are
uncomfortable.”
“I don’t need them, I
am used to the
noise.”
“Can I hurt my
eardrums if I insert a
plug to deeply.”
“My machine
sounds different.”
“I can’t hear my
co-workers if I
wear them.”
“Won’t I get an
ear infection?”
“I can always
get a hearing aid.”
FITTING TIPS
Find the Right Size
Maximum protection is only
accomplished when an earplug
acoustically seals in the ear canal.
No earplug fits all ear canals, so
manufacturers have responded
with a variety of sizes.
It is important to find your right size
to obtain an acoustic seal
FITTING TIPS
ROLL-DOWN FOAM
1. Roll
entire earplug into a
crease-free cylinder
2. Pull Back
pinna by reaching over
head with free hand,
gently pull top of ear up
and out
3. Insert
earplug well
into ear
canal and
hold until it
fully expands
FITTING TIPS
Visual Check for Foam Earplugs
If properly fitted, the end of the earplugs should not
extend beyond the tragus (flap of the ear canal).
NO-ROLL FOAM EARPLUGS
1. Reach
over head with
free hand, pull ear
up and back and
insert earplug well
inside ear canal.
2. Earplugs
should be inserted
as shown in these
drawings. Stop
pushing earplug
when finger
touches the ear.
3. If properly
fitted, the end of
the earplugs
should not be
visible to someone
looking at you
from the front.
MULTIPLE-USE EARPLUGS
1. While holding the
stem, reach hand
overhead and gently
pull top of ear up
and back.
2. Insert earplug
so all flanges
are well inside 3. If properly
the ear canal.
fitted, only the
stem of the
earplugs
should be
visible to
someone
looking at you
from the front.
EARPLUGS (ALL)
1. Visual Check - The
earplug should sit well
inside the ear canal and
not stick out.
2. Acoustical Check Cup hands over ears
and release. Earplugs
should block enough
noise so that covering
your ears with hands
should not result in a
significant noise
difference.
EARMUFF INSTRUCTIONS
1. Place earcups
over each
outer ear
2. Adjust the
headband by
sliding the
headband up or
down at the
attachment
buttons
3. The ear
cushions should
seal firmly
against the head
EARMUFF INSTRUCTIONS – DON’TS
For best results, remove
all hair from underneath
earcup.
Ensure that the earcup
creates a seal and covers
the ear completely.
PRODUCTS
Types of Hearing Protectors
Earplugs
 Single-Use
 Multiple-Use
 Detectable
Banded Protectors
 Banded Earplugs
 Canal Caps
Earmuffs
 Standard (Headband)
 Cap-Mounted
 Electronic
 Special Application
PROS AND CONS OF HPDs – EARPLUGS
PRO
•Comfortable for extended use
•Disposable earplugs available
•Cooler in hot/humid
environments
CON
•Attenuation highly dependent
upon good fit
•Hygiene issues in dirty
environments
CARE & MAINTENANCE OF HPDs – EARPLUGS
•Dispose of single-use
earplugs daily
•Clean multiple-use
earplugs with mild soap
and water, dry thoroughly
•Inspect multiple-use
earplugs for dirt, cracks or
hardness, replace if
damaged
PROS AND CONS OF HPDs – BANDED EARPLUGS
•Clean and replace pods
regularly
CARE & MAINTENANCE OF HPDs – BANDED EARPLUGS
PRO
•Very convenient for intermittent
noise
•Readily available around neck
when not in use
CON
•Lower attenuation than most
earplugs
•Some noise transmission
through band
PROS AND CONS OF HPDs – EARMUFFS
PRO
•Easy to get proper fit
•Good for intermittent noise
•Radio & electronic options
CON
•Can feel hot/heavy with
extended wear
•Compatibility with other PPE?
CARE & MAINTENANCE OF HPDs – EARMUFFS
•Clean ear cushions and
headband regularly with
mild soap and water
•Replace ear cushionsand
foam inserts every 6
months with normal wear,
more often with heavy use
or under humid/extreme
conditions
Selecting Appropriate Hearing Protection
EHS will assist in selecting
appropriate hearing protection.
Some high noise areas may require
both ear plugs and ear muffs.
EHS has a noise dosimeter and is
able to provide noise monitoring for
individuals or areas of concern.
Hearing Loss Due To
Noise Exposure Is …
Painless
Permanent
Progressive
… and very PREVENTABLE!
University of Michigan – Flint
Roles & Responsibilities

Employer






Administer Hearing Protection Program
Provide appropriate hearing protection for employees
Provide annual hearing conservation training
Arrange for annual audiograms for employees
Keep records
Employee




Wear provided hearing protection in required areas or while
performing tasks that produce high noise levels
Follow fitting instructions
Properly store & care for re-usable hearing protection.
Inspect re-usable hearing protection prior to use.
What is a Standard Threshold Shift?

STS is defined by OSHA/MIOSHA as average of 10
dbA or greater increased hearing threshold in 2,000,
3,000 and 4,000 Hz in one or both ears.

STS’s are a recordable injury under OSHA. However,
in Michigan, a STS is not a recordable injury on the
OSHA/MIOSHA unless the hearing thresholds have
increased on an average of 25 dBA.
When an Employee has a Standard Threshold Shift
(STS)

If an employee’s annual audiogram indicates a
Standard Threshold Shift






The University’s medical provider notifies the employee and EHS.
The employee has 30 days to return to the clinic for a second
audiogram to verify or refute the first one.
If the second audiogram verifies a STS, then this audiogram
becomes the new baseline.
Work Connections is notified of verified STSs.
Per UM hearing conservation guidelines, the employee is notified
via e-mail and needs to meet with EHS for education on hearing
protection and conservation.
Employee signs letter stating they understand that they have a
STS and have received applicable education and training.
University of Michigan
Hearing Conservation GuidelinesTraining & Education






STS and audiometric zero
recognizing noisy environments
noise exposure on and off the job
methods used to control and reduce noise exposure
properly selecting and fitting hearing protection
monitoring of workplace noise levels