Download DC – DC CONVERTER (DC ‐ CHOPPER

Survey
yes no Was this document useful for you?
   Thank you for your participation!

* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project

Document related concepts

Coupon-eligible converter box wikipedia , lookup

Amplifier wikipedia , lookup

Spark-gap transmitter wikipedia , lookup

Immunity-aware programming wikipedia , lookup

Standing wave ratio wikipedia , lookup

Transistor–transistor logic wikipedia , lookup

Multimeter wikipedia , lookup

Analog-to-digital converter wikipedia , lookup

Valve RF amplifier wikipedia , lookup

TRIAC wikipedia , lookup

CMOS wikipedia , lookup

Ohm's law wikipedia , lookup

Operational amplifier wikipedia , lookup

Josephson voltage standard wikipedia , lookup

Integrating ADC wikipedia , lookup

Schmitt trigger wikipedia , lookup

Resistive opto-isolator wikipedia , lookup

Power MOSFET wikipedia , lookup

Current source wikipedia , lookup

Opto-isolator wikipedia , lookup

Surge protector wikipedia , lookup

Current mirror wikipedia , lookup

Power electronics wikipedia , lookup

Voltage regulator wikipedia , lookup

Switched-mode power supply wikipedia , lookup

Rectiverter wikipedia , lookup

Transcript
By
Mr. K .Anish
Block diagram of
DC-DC CONVERTER
DC – DC CONVERTER
(DC ‐ CHOPPER
• A chopper is a static device which is used to obtain a
variable dc voltage from a constant dc voltage source.
• chopper is also known as dc‐to‐dc converter.
• The thyristor converter offers greater efficiency, faster
response, lower maintenance, smaller size and smooth
control.
• Choppers are widely used in trolley cars,battery operated
vehicles, traction motor control,control of large number of
dc motors, etc…..
• They are also used in regenerative braking of dc motors to
return energy back to supply and also as dc voltage
regulators.
Choppers are of two types:
• Step‐down choppers
• Step‐up choppers
PRINCIPLE OF STEP‐DOWN
CHOPPER
• Figure 2.1 shows a step‐down chopper with
resistive load.
• The thyristor in the circuit acts as a switch.
When thyristor is ON,
• supply voltage appears across the load and
when thyristor is OFF,
• the voltage across the load will be zero. The
output voltage and
• current waveforms are as shown in figure 2.2.
Step-down choppers — output
voltage and current waveforms
Anish@PITS