Download Electric and Micro Grids Power Point

Survey
yes no Was this document useful for you?
   Thank you for your participation!

* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project

Document related concepts

Telecommunications engineering wikipedia , lookup

Solar micro-inverter wikipedia , lookup

Grid energy storage wikipedia , lookup

General Electric wikipedia , lookup

Electrification wikipedia , lookup

Mains electricity wikipedia , lookup

Transmission line loudspeaker wikipedia , lookup

Life-cycle greenhouse-gas emissions of energy sources wikipedia , lookup

Amtrak's 25 Hz traction power system wikipedia , lookup

Rectiverter wikipedia , lookup

Triode wikipedia , lookup

Intermittent energy source wikipedia , lookup

Electrical substation wikipedia , lookup

Power engineering wikipedia , lookup

Alternating current wikipedia , lookup

Electric power transmission wikipedia , lookup

Islanding wikipedia , lookup

Transmission tower wikipedia , lookup

History of electric power transmission wikipedia , lookup

Transcript
Final Project: The Electric and
Micro Grid
Lakshmi GopiReddy
Adventures
in STEM
2
Microgrid
Microgrid- Small scale independent
electric grids, generating low power.
3
Advantages of micro grid
The idea is to use energy where it is generated.
Less transmission challenges
▫ No need to step up voltage for transmission
Less distribution challenges
▫ The loads are local and so the distribution is for a limited
area.
Disadvantage
With uncertainty in renewable energy, we might not have
enough power all the time
Solution:
1) Connect to the Electric grid and use power only when
required.
2) Energy storage. (Batteries, fuel cells, etc.)
4
Tasks for the Project
1) Build wind turbine system. (Yesterday’s
project)
2) Build a solar farm system.
3) Build your loads.
4) Build transmission and distribution towers
5) Connect all of your electric grid or micro
grid with wire.
5
Solar Farm(10 min.)


Connect 4 solar panels to generate >
4.0 V with a light source.
Each solar panel generates about 2.2
V.
Use all four panels!!! .(Hint: series and parallel).

Make a connection and test it with the
loads.
6
Loads (15 min.)
Four LEDs.
Should you connect your loads in series or
parallel?
Even before connecting wires, connect them in
parallel and test them if they light up when
connected to the solar farm.
Connect wires to LED. Sand both ends of the wire.
Make sure that the two leads/terminals of the LED
are not touching!
Pull your wires though the straw.
7
Transmission and Distribution Towers (10 min.)
Two transmission towers and one distribution tower.
Transmission tower: 2 Balsa wood sticks
1) Build two towers
2) Less than 10 inches.
3) Should stand on the table by itself.
4) Design should include a bar to hold two wires.
5) Not fall apart even if it falls on the ground.
Distribution Towers: 1 Balsa wood stick
1) Build one tower.
2) Less than 7 inches.
3) Should stand on table by itself.
4) Hold 8 wires.
5) Not fall apart
8
Connecting the grid (15 min.)
The total distance of the grid
You need two long wires.
Before you get your connections, get it
verified by a mentor/helper.