Download UL DESKTOP MODEL MANUAL(jenny)11.24 - Rack-A

DTB-1-BK INSTALLATION INSTRUCTIONS:
ATTENTION
The design of this product is fully considered to be safe. However , it also may cause electric shock and fire with improper
usage. Please closely follow rules on installation, usage , and maintenance.
··
·
·
·
For indoor use only at normal temperatures. Not to be used in extreme damp or dusty conditions.
Please use a qualified electrician for the installation of this product.
Box must be properly grounded before usage.
All connections must be properly affixed before usage.
All switchs and power must be turned off before installation.
USAGE
Specifically designed for office and conference tables
INSTALLATION
1. Make cut into table top according to these measurements:13 9/16" L x 6 1/16" W. This measurement is to allow for
the screw heads to pass through the hole after the cut. Please physically measure box dimensions before cutting in
the event of box defect. Overall measurement of the flange is 14" x 6 1/4" , so do not overcut the hole as there is
little room for the flange to sit atop the table.
2.
Remove the (8) screws which are affixed to the bottom box and separate box from socket structure. (SEE PIC 1)
sockets structure
screw
bottom box
Pic 1
3.
Pass the power cable through the gasket of the bottom box. Pass low voltage wires through bottom grommet. Snap
in low voltage jacks (not provided)into 6-port device. Affix ground wire to terminal on bottom box. Check connections
before reassembly.(SEE PIC 2)
6-port device
GFCI
overload switch
shroud
bottom box
gasket
power cable
grounding wire
SNAP Grommet
Pic 2
4.
Affix box screws to make unit complete. (SEE PIC 3)
gasket
wire clip
Pic 3
(BACKSIDE CONTINUE)
5. Set (2) fixed blocks into width openings on table. Drop box into opening and onto fixed blocks. Use provided screws to
affix blocks to box. (SEE PIC 4)
table-board
fixed block
screw
Pic 4
6. Gently press down on the middle of the cover closest to brush until the clicking sound is heard. Door will automatically
open slowly. To close cover, depress gently until clicking sound is heard. (SEE PIC 5)
PUSH
middle cover
Pic 5
7. Slight press the middle cover close to hairbrush, loose it after hearing slight”click”, the middle cover can be open softly
and automatically, it can be used after the cover done, same steps for closing. (SEE PIC 6 )
Pic 6
We always appreciate hearing what’s on your mind. Your feedback, suggestions and ideas are what
keeps us going.
Please feel free to call us at (630) 665-2075
Lew Electric Fittings Company
371 Randy Rd.
Carol Stream, IL 60188
Phone: 630.665.2075
Fax: 630.665.2077
Website: www.lewelectric.com