Survey
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project
Address: 79 Trenton Ave. Frenchtown, NJ 08825. Phone: (908)996-7710 Fax.: (908)996-7042 GINEVRA Dust tight and protected against waterjets ip65. Suitable for installation on normally flammable surfaces. Input 110VAC. TC-TSE 33w max fluorescent lamp QT32 100w max halogen lamp HIT-CE 35w max metal halide lamp Fixture will require some assembly. This fixture consists of three main parts... vibrated and sandblasted concrete base, an extruded aluminum stem with electronics, and a white sandblasted polyethylene diffuser. Remove the cap head bolt and lock washer from the bottom end of the aluminum pole, position the flat side of the concrete base against the pole, insert the bolt/washer thru the hole in the concrete base and using a hex key wrench, tighten the bolt. USER MANUAL Installation and safety instructions RISK OF ELECTRICAL SHOCK. THIS EQUIPMENT IS TO BE INSTALLED BY A QUALIFIED ELECTICIAN ONLY. MAKE CERTAIN ELECTRICAL SUPPLY CIRCUIT IS DE-ENEREGIZED BEFORE BEGINNING INSTALLATION. CHECK FIXTURE LABEL FOR CORRECT VOLTAGE. READ ALL INSTRUCTIONS CAREFULLY. Parts of the luminaire get very hot during operation. (Risk of burn!) During workings on the luminaire or in the event of damage to the luminaire the power supply must be switched off. Never touch the bulb or parts close to the bulb such as glasses or reflectors. Let all parts cool off before any maintenance or cleaning is done! Never use the luminaire with an inappropriate bulb or with a bulb which has a higher wattage than indicated on the type label of the luminaire. Remove the four screws from the base of the polyethylene diffuser. Install the lamp into the lamp socket. Place the diffuser over the lamp/socket and fasten together using the four screws. Ensure that the screws are securly tightened. Plug the fixture into 120V receptical, fixture is ready to be energized.