Download HotShot Power Supply Kit

Survey
yes no Was this document useful for you?
   Thank you for your participation!

* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project

Document related concepts

Spark-gap transmitter wikipedia , lookup

Integrating ADC wikipedia , lookup

Decibel wikipedia , lookup

Josephson voltage standard wikipedia , lookup

Ohm's law wikipedia , lookup

List of vacuum tubes wikipedia , lookup

Immunity-aware programming wikipedia , lookup

Operational amplifier wikipedia , lookup

Radio transmitter design wikipedia , lookup

Audio power wikipedia , lookup

Valve RF amplifier wikipedia , lookup

Resistive opto-isolator wikipedia , lookup

CMOS wikipedia , lookup

Current mirror wikipedia , lookup

Schmitt trigger wikipedia , lookup

Valve audio amplifier technical specification wikipedia , lookup

Power MOSFET wikipedia , lookup

Opto-isolator wikipedia , lookup

Voltage regulator wikipedia , lookup

Power electronics wikipedia , lookup

Surge protector wikipedia , lookup

Rectiverter wikipedia , lookup

Switched-mode power supply wikipedia , lookup

Transcript
HSPS18KIT
HotShot Power Supply Kit
Power Supply and Wiring Kit For HotShot 18” Heaters
¯ Rugged heavy duty wirewound primary and
secondary transformer
¯ Protected by an externally
accessible glass tube fuse
¯ 24vAC secondary winding
¯ Line voltage power-on
indication by pilot light
¯ Low-voltage output to the
heater blanket assures a
SAFE circuit
¯ Wire wound transformer
is not subject to line
voltage spikes
ds\specifications\hsps18kit
Product Description
The power supply in this kit should only be used on the 18” HotShot blankets.
This is a wire wound transformer that is really tough. Electronic ‘switching’ transformers are subject
to damaging line voltage surges that a wire wound transformer simply ignores.
Installers should note that this is a SAFE, low-voltage output device. Competitive products to the
HotShot dish heater often use HIGH VOLTAGE to power their heaters. Perfect 10 has never
recommended the use of high voltage 120vAC dish heaters. Injury can easily result if high voltage
devices used outside are not installed with GFI connections at the antenna as well as other major
safety efforts. You are liable for your installations! Be safe, use low voltage HotShot heaters and
power supplies.
One hundred feet (100’) of stranded 18AWG two conductor is included in the kit box.
TOLL FREE 1-866-470-0887 • INTERNATIONAL +1-501-955-0033 • WWW.PERFECTVISIONMFG.COM
Jan 24, 2012
Product Specifications
HSPS18KIT
Power Supply
5.00”
3.00”
2.50”
Mechanical
Ÿ High impact ABS body
Ÿ Single pole on/off manual switch
Ÿ Horizontal surface mounting only
Electrical
Ÿ Input voltage is 120vAC.
Ÿ Power supply output voltage 24vAC @ 3 amps maximum
Ÿ Power supply replacement fuse is a 3.5amp standard glass fuse (BUSS GMA-3.5A125V)
Ÿ Line voltage power-on indicator lamp
Ÿ Power wire included is 100 feet of 18AWG stranded two conductor.
Limitations
Ÿ The power supply is for 18” heaters only and must be installed indoors, it is not water resistant.
TOLL FREE 1-866-470-0887 • INTERNATIONAL +1-501-955-0033 • WWW.PERFECTVISIONMFG.COM
Jan 24, 2012