Download Lab-12 Stephan-Boltzmann Law

12- Stephan's Law for Black Body Radiation
Object:
Measure how the current through an electric light bulb varies as the applied
voltage is changed. This will allow you to establish Stephan's Law for Black Body
Radiation.
Introduction:
When an electric current flows through the filament in a light bulb the filament
heats up. The filament loses heat in two ways: electromagnetic radiation (mainly
visible light and invisible heat radiation) and conduction (through the base of the
bulb). The heat conducted away from the filament increases linearly with
filament temperature. The air in the bulb is pumped out during manufacture so
little heat is lost by convection.
Since it is difficult to measure the temperature of the filament directly, we use the
fact that the filament resistance is approximately proportional to the filament
temperature at T>>To. (Ro=resistance at room temperature T=To)
R(T)=Ro[ 1+α(T-To) ]
R(T ) =Ro + α R T- α Ro To ~ α R T
R ~ T ( T>>.To)
( T>>.To)
Part 1: Stefan's Law:
Stefan's Law states that the radiated power density (W/m2) of a black body is
proportional to its absolute temperature T raised to the fourth power.
E = e σ T4
The emissivity e is a correction for an approximate black body radiator, where e =
1 – R, is the fraction of the light reflected (R) by the black body. For a true
black body R = 0 and e = 1 or total absorbtion!
( σ = 5.66e-8 W/m2-K4 = Stephan-Boltzmann constant ).
Using the power~temperature relationship:
4
4
E=eσT =eσR
and
ln(E) = ln(e) + ln (σ) + 4 ln(R)
By plotting ln(P) vs ln(R) we should find a linear relationship y=a + bx where the
slope b=4.
Directions:
1) Connect a variable power supply in series to the terminals of a the small
utility light bulb as in Figure 1.
2) Attach a digital multimeter meter (DVM) in parallel across the light bulb + and
– terminals to measure the voltage drop V across the filament.
3) A second DVM is place in series with the power supply to measure the current
I passing through the filament.
V(volts)
0.5
1.0
1.5
2.0
2.5
3.0
3.5
4.0
4) Record the voltage V and current I
for a number of voltages while keeping
the current I below 200mA.
5) Determine the resistance R by Ohm;s
Law.
6) Graph ln(P) vs ln(R)
7) Measure the slope fhe graph and
confirm Stephan;s Law.
slope = 4 ± err
8) Determine the error in the slope either
! or graphical means.
by analytical
5.0
6.0
7.0
8.0
9.0
10.0
11.0
12.0
I(amps)
R=V / I
Part II. Measurement of Power with a Tungsten Lamp and Radiometer.
We can directly measure the power output of a tungsten filament at each voltage
using the Daedalon Stephan Boltzmann Source and Radiiometer.
Use the procedure supplies in the Daedalon Experiment Manual.
experiment a tungsten lamp is used of known α = 0.0045 Ohms/degK
T = ( R/Ro-1)/α + To
V
I
R=V / I
P(W/m2)
radiiometer
0.5
1.0
1.5
2.0
2.5
3.0
3.5
4.0
5.0
6.0
7.0
8.0
< 1.5
A
T
In this