Survey
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project
HIB-XR-1002 Head Interface Board for Xaar 1002 / 1003 Printhead GIS Inkjet Operating System The HIB-XR-1002 is a GIS Head Interface Board. It is Features designed to provide communications between the Xaar General 1002 GS6/GS12/GS40 printhead, the Xaar 1003 GS6/ Supported Printheads : Xaar 1002 and Xaar 1003 GS12/GS40 printhead, and the GIS Print Manager Dimensions: H 98mm, W 74mm, D 15mm Board. Weight : 100g Specifically designed for use with GIS software products High Speed (200MB/s) data channel Printhead Control The HIB-XR-1002 provides access to all the standard Power Requirements Xaar printhead settings including voltage trim, binary 24V DC and greyscale mode (8 grey levels), waveform settings. Automatic download of Xaar configuration files. Xaar Printhead Control Printhead Voltage Base and Offset Control Left and Right Nozzle Bank Voltage Trim (1/16V steps) Power Control Grey level / Binary Mode Control The GIS HIB-XR-1002 provides the Xaar printheads all their power requirements via a single 24V power connector. Grey level Drop Count Control Printhead Waveform Control Cable Length From PMB : 15m The HIB-XR-1002 has the same form factor as the Xaar Head Personality Card (HPC), which it replaces. www.globalinkjetsystems.com — © Global Inkjet Systems Ltd. 2015 HIB-XR-1002 0415 From HIB to head : 300mm Form Factor HIB-XR-1002 GIS Operating System User Interface & Customisable Print Manager Head Interface RIP software Drivers Board Board Connectivity The HIB-XR-1002 is a standard interface component HIB-XR-1002 of the GIS Inkjet Operating System. It is designed to drive the Xaar 1002 and Xaar 1003 printhead using a GIS Print Manager Board and GIS Software. Connectors The HIB-XR-1002 requires just two connectors to drive the printhead: Data Connector: A standard RJ45 for connection to a GIS Print Manager Board using CAT 6a STP shielded cabling (up to 15m). Power Connector: A standard 24V DC connector to supply the HIB-XR- 1002 board and 1 x Xaar 1002 or 1 x Xaar 1003 separate printhead power. All trademarks acknowledged. www.globalinkjetsystems.com — © Global Inkjet Systems Ltd. 2015 HIB-XR-1002 0415 printhead with power. There is no requirement for