Download S21 – LED Power Distribution

S21 – LED Power Distribution
General
The design shall be based on the S21 dimmer strip metal construction with the same
optional hangers, and physical dimensions. The current processor if it has the capacity
can form the base processor for the system. The strip shall have a modular construction
so that users can install a range of modules to suit the specific needs of a project. There
shall be an alternate construction format for a wall mount module designed to attached
to a wall, pipe rail or be freestanding on a floor.
Power Input
The strip shall support 3 phase 4 wire, or single phase 3 wire power inputs. A set of
standard power input cables shall be available.
Operating range
The system shall accept any input voltage from 90-264 volts
Power Modules
There shall be three standard power modules for the system:
Dimmer module
The system shall support the standard S21 dual IGBT dimmer module for dimming
conventional or line voltage LED loads. The module shall have two dimmers supporting a
total load of 2.4kW at any input voltage.
Philips Selecon TR series or Color Kinetics Blast series Power module
This module shall have electronics to manage and power up to 4 Led luminaires. The
unit shall have a 360 watt 24V (to be confirmed) power supply. Luminaire addressing
electronics and 4 – 4 pin XLR connectors for luminaire connectivity. Luminaires shall
operate up to 60 feet from the Power distribution strip. The LED module when
connected to the processor shall be configurable to support two color, three color and 5
color LED luminaires with individual addressing and set up for each output connector.
The central processor shall permit users to set up 8 or 16 bit operating modes and add
an optional intensity channel to simplify system operation.
Relay module with data distribution
This module shall supply a total of 2400 watts of switched power to two output
connectors (PowerCon, GP, Edison, GTL). Each module shall also have two DMX out
connectors with termination switches. These modules will specifically support Philips
Selecon PL1, PL3 and PL5 luminaires as well as other mains power LED luminaires or
other switched loads. The module shall be configured by the processor to provide
remote control from any processor input.
Processor
The processor shall be available with a choice of control input options (some of which
may not be available at launch but released over time). It shall be designed to simply
configure and address any combination of available power modules. The processor shall
have the following inputs:
DMX512 In/Out
Wireless DMX (optional)
Setup
The processor shall be simple to set up with a menu system that allows the operator to
easily configure each of the three module types in any configuration. Dimmer modules
shall support two channels each of which can be configured for Forward phase, reverse
phase, LED and auto load select operation. Relay modules shall be single channel
devices and LED power supply modules shall provide up to 12 channels of control for
each connected luminaire up. Dimmer and relay modules shall have local controls with
indicators to facility set up and testing.
The processor shall report test and diagnostic data appropriate for each module type.
There shall be password protection for the processor to lock the processor against
accidental changes to configuration.
Approvals
Each strip and all optional features shall be CE marked and ETL, cETL listed.