Survey
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project
Mid-latitude Cyclones Chapter 12 Polar Front Theory • Polar front is a semi-continuous boundary separating cold, polar air from more moderate mid-latitude air • Mid-latitude cyclone (wave cyclone) forms and moves along polar front in wavelike manner • Frontal wave, warm sector, mature cyclone, triple point, secondary low, family of cyclones Figure 12.1 The idealized life cycle of a mid-latitude cyclone (a through f) in the Northern Hemisphere based on the polar front theory. As the life cycle progresses, the system moves eastward in a dynamic fashion. The small arrow next to each L shows the direction of storm movement. Midlatitude Cyclones Figure 12.2 A series of wave cyclones (a ―family‖ of cyclones) forming along the polar front. Where do mid-latitude cyclones tend to form? • • • • • • Cyclogenesis – cyclone development Lee side low’s Nor’easters Hatteras low Alberta Clipper Explosive cyclogenesis, bomb Figure 12.4 As westerly winds blow over a mountain range, the airflow is deflected in such a way that a trough forms on the downwind (leeward) side of the mountain. Troughs and developing cyclonic storms that form in this manner are called lee-side lows. Figure 12.5 (a) Typical paths of winter mid-latitude cyclones. The lows are named after the region where they form. (b) Typical paths of winter anticyclones. • Topic: Northeasters – Mid-latitude cyclones that develop or intensify off the eastern seaboard of North America then move NE along coast Vertical Structure of Deep Dynamic Lows • Dynamic low = intensify with height • When upper-level divergence is stronger than surface convergence (more air is taken out of the top than the bottom) surface pressure drops and low formation Figure 12.6 If lows and highs aloft were always directly above lows and highs at the surface, the surface systems would quickly dissipate. Convergence and divergence Figure 2 The formation of convergence (CON) and divergence (DIV) of air with a constant wind speed (indicated by flags) in the upper troposphere. Circles represent air parcels that are moving parallel to the contour lines on a constant pressure chart. Below the area of convergence the air is sinking, and we find the surface high (H). Below the area of divergence the air is rising, and we find the surface low (L). Figure 3 As the faster-flowing air in the ridge moves toward the slower-flowing air in the trough, the air piles up and converges. As the slower-moving air in the trough moves toward the faster-flowing air in the ridge, the air spreads apart and diverges. Upper Level Waves and Mid-latitude Cyclones • Longwaves – planetary or Rossby waves • Shortwave disturbances Figure 12.8 A 500-mb map of the Northern Hemisphere from a polar perspective shows five longwaves encircling the globe. Note that the wavelength of wave number 1 is as great as the width of the United States. Solid lines are contours. Dashed lines show the position of longwave troughs. (a) Upper-air chart showing a longwave with three shortwaves (heavy dashed lines) embedded in the flow. (b) Twenty-four hours later the shortwaves have moved rapidly around the longwave. Notice that the shortwaves labeled 1 and 3 tend to deepen the longwave trough, while shortwave 2 has weakened as it moves into a ridge. Notice also that as the longwave deepens in diagram (b), its length actually shortens. Dashed lines are isotherms in °C. Solid lines are contours. Blue arrows indicate cold advection and red arrows, warm advection. Barotropic vs. baroclinic Barotropic – contours parallel to isotherms winds blow parallel to isotherms Baroclinic - isotherms cross contours So, Temperature advection occurs Causing - Cold and warm air advection The Necessary Ingredients for Development of Mid-latitude Storm • Baroclinic instability • Upper-Air Support: the overall effect of differential temperature advection is to amplify the upper level wave • Upper air low may break away from main flow and become a cut-off low Figure 12.10 - formation of a mid-latitude cyclone during baroclinic instability. (a) A longwave trough at 500 mb lies parallel to and directly above the surface stationary front. (b) A shortwave (not shown) disturbs the flow aloft, initiating temperature advection (blue arrow, cold advection; red arrow, warm advection). The upper trough intensifies and provides the necessary vertical motions (as shown by vertical arrows) for the development of the surface cyclone. c) The surface storm occludes, and without upper level divergence to compensate for surface converging air, the storm system dissipates. • Topic: Jet Streaks and Storms – Entrance and exit regions associated with divergence and convergence, right exit allows divergence. Figure 5 Changing air motions within a straight jet streak (shaded area) cause strong convergence of air at point 1 (left entrance region) and strong divergence at point 3 (left exit region). Figure 12.11 (a) As the polar jet stream and its area of maximum winds (the jet streak, or core) swings over a developing mid-latitude cyclone, an area of divergence (D) draws warm surface air upward, and an area of convergence (C) allows cold air to sink. The jet stream removes air above the surface storm, which causes surface pressures to drop and the storm to intensify. (b) When the surface storm moves northeastward and occludes, it no longer has the upper-level support of diverging air, and the surface storm gradually dies out. Figure 12.12 Summary of clouds, weather, vertical motions, and upper-air support associated with a developing midlatitude cyclone. Conveyor Belt Model: air constantly glides through storm warm, cold, and dry conveyor belts Figure 12.14 Visible satellite image of a mature mid-latitude cyclone with the three conveyor belts superimposed on the storm. As in Fig. 12.13, the warm conveyor belt is in orange, the cold conveyor belt is in blue, and the dry conveyor belt (forming the dry slot) is in yellow. Figure 12.16 A Developing Mid-Latitude Cyclone – Storm of March 1993 Surface weather map for 4 a.m (EST) on March 13, 1993. Lines on the map are isobars. A reading of 96 is 996 mb and a reading of 00 is 1000 mb. (To obtain the proper pressure in millibars, place a 9 before those readings between 80 and 96, and place a 10 before those readings of 00 or higher.) Green shaded areas are receiving precipitation. Heavy arrows represent surface winds. The orange arrow represents warm, humid air; the light blue arrow, cold, moist air; and the dark blue arrow, cold, arctic air. Figure 12.15 A color-enhanced infrared satellite image that shows a developing mid-latitude cyclone at 2 a.m. (EST) on March 13, 1993. The darkest shades represent clouds with the coldest and highest tops. The dark cloud band moving through Florida represents a line of severe thunderstorms. Notice that the cloud pattern is in the shape of a comma. Figure 12.17 The 500-mb chart for 7 a.m. (EST) March 13, 1993. Solid lines are contours where 564 equals 5640 meters. Dashed lines are isotherms in °C. Wind entries in red show warm advection. Those in blue show cold advection. Those in black indicate no appreciable temperature advection is occurring. Figure 12.18 The development of the ferocious mid-latitude cyclonic storm of March, 1993. A small wave in the western Gulf of Mexico intensifies into a deep open-wave cyclone over Florida. It moves northeastward and becomes occluded over Virginia where its central pressure drops to 960 mb (28.35 in.). As the occluded storm continues its northeastward movement, it gradually fills and dissipates. The number next to the storm is its central pressure in millibars. Arrows show direction of movement. Time is Eastern Standard Time. Vorticity, Divergence and Development of Cyclones • Vorticity is a measure of the spin of small air parcels – Positive: cyclonic – negative: anticyclonic • Divergence aloft causes an increase in the cyclonic vorticity of surface cyclones = cyclogenesis and upward air movement Figure 12.19 When upper-level divergence moves over an area of weak cyclonic circulation, the cyclonic circulation increases (that is, it becomes more positive), and air is forced upward. • Earth’s vorticity always positive • Relative vorticity due to curvature of wind flow + shear ( change of wind speed over horizontal distance) – trough: cyclonic – ridge: anticyclonic • Absolute vorticity = Earth v + relative v • An increase in absolute vorticity is related to upper level convergence • A decrease in absolute vorticity is related to upper level divergence • Vorticity maxima/minima Figure 12.20 Earth’s Vorticity Due to the rotation of the earth, the rate of spin of observers about their vertical axes increases from zero at the equator to a maximum at the poles. Figure 12.21 Relative Vorticity In a region where the contour lines curve, air moving through a ridge spins clockwise and gains anticyclonic relative vorticity. In the trough, the air spins counterclockwise and gains cyclonic relative vorticity. Figure 12.22 Areas of cyclonic (positive) relative vorticity and anticyclonic (negative) relative vorticity can form in a region of strong wind-speed shear. Notice that the pinwheel changes its direction of spin when placed above and below the region of maximum winds. Figure 12.23 The vorticity of an air parcel changes as we follow it through a wave. From position 1 to position 3, the parcel’s absolute vorticity increases with time. In this region (shaded blue), we normally experience an area of upper-level converging air. As the air parcel moves from position 3 to position 5, its absolute vorticity decreases with time. In this region (shaded green), we normally experience an area of upper-level diverging air. Figure 12.24 A region of high absolute vorticity—a vorticity maximum—on its downwind (eastern) side has diverging air aloft, converging surface air, and ascending air motions. On its upwind (western) side, there is converging air aloft, diverging surface air, and descending air motions. Figure 12.25 This infrared water vapor image shows regions of maximum vorticity as cyclonic swirls of moisture off the coast of Oregon and Washington and out over the Pacific. The stretched-out band of clouds toward the bottom of the picture is the intertropical convergence zone. • Vorticity and Longwaves – Longwaves develop in upper-levels due to the conservation of absolute vorticity. – Absolute V = Earth’s V + relative V = CONSTANT • Putting It All Together • Forecasters review 200mb, 500mb, and surface maps to examine pressure, convergence, vorticity, and advection Figure 12.26 The atmospheric conditions for February 11, 1983, at 7 a.m., EST. The bottom chart is the surface weather map. The middle chart is the 500-mb chart that shows contour lines (solid lines) in meters above sea level, isotherms (dashed lines) in °C, and the position of a shortwave (heavy dashed line). The upper chart is the 200-mb chart that illustrates contours, winds, and the position of the polar jet stream (dark blue arrow). The letters DIV represent an area of strong divergence. The region shaded orange represents the jet stream core—the jet streak. Figure 12.27 The 500-mb chart for February 11, 1983, at 7 a.m., EST. Solid lines are height contours in meters above sea level. Dashed lines are lines of constant absolute vorticity × 10−5/sec. Polar Lows • Storms that develop over water behind (poleward of) main polar front. – Comma cloud, eye – Warm central core, strong winds, heavy showery precipitation. – Arctic front = baroclinic instability Figure 12.28 An enhanced infrared satellite image of an intense polar low situated over the Norwegian Sea, north of the Arctic Circle. Notice that convective clouds swirl counterclockwise about a clear area, or eye. Surprising similarities exist between polar lows and tropical hurricanes described in Chapter 15.