Download MP11 High Sensitive Metal Detector for Detecting Metal Objects

Survey
yes no Was this document useful for you?
   Thank you for your participation!

* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project

Document related concepts

Variable-frequency drive wikipedia , lookup

Spectrum analyzer wikipedia , lookup

Spark-gap transmitter wikipedia , lookup

Power inverter wikipedia , lookup

Cavity magnetron wikipedia , lookup

Mains electricity wikipedia , lookup

Islanding wikipedia , lookup

Opto-isolator wikipedia , lookup

Rectifier wikipedia , lookup

Pulse-width modulation wikipedia , lookup

Utility frequency wikipedia , lookup

Buck converter wikipedia , lookup

Atomic clock wikipedia , lookup

Klystron wikipedia , lookup

Resistive opto-isolator wikipedia , lookup

Crystal oscillator wikipedia , lookup

Switched-mode power supply wikipedia , lookup

Time-to-digital converter wikipedia , lookup

Rectiverter wikipedia , lookup

Superheterodyne receiver wikipedia , lookup

Regenerative circuit wikipedia , lookup

Phase-locked loop wikipedia , lookup

Heterodyne wikipedia , lookup

Wien bridge oscillator wikipedia , lookup

Transcript
MP11
HIGH SENSITIVE METAL DETECTOR FOR DETECTING METAL
OBJECTS
(Better Security System for to Detect Terrorists / Human Bombs)
One of the simplest methods of metal detecting is by beat frequency oscillator. Basically, the
circuit consists of two balanced oscillator. One oscillator provides the reference signal, and other
oscillator is acting as the detector element. The reference oscillator’s frequency is fixed, while
the detector oscillator is variable depending on the presence of a metal. The reference oscillator
can be constructed using various circuit topologies: inductor-capacitor (LC) Colpitts oscillator.
While the reference oscillator can be implemented using various circuit topology, the detector
oscillator always use inductor-capacitor topology, because the mechanism will be using the
magnetic induction property of the detected object, and the inductor component of the detector
oscillator will be the detecting probe.
With the absence of a metal near the detector probe (the inductor component of the detector
oscillator), the detector oscillator is tuned to have same frequency as the reference oscillator.
The output of the detector oscillator and the reference oscillator output is mixed using heterodyne mixer circuit, producing a beat frequency output of zero Hz, or a very low frequency if both
oscillators is slightly unbalanced. In the presence of a metal near the detector probe, the detector
oscillator will shift it’s frequency, and the mixer output will produce a tone with frequency equal
to the difference of the reference and the detector frequency.
This project uses regulated 12V, 750mA power supply. 7812 three terminal voltage
regulator is used for voltage regulation. Bridge type full wave rectifier is used to rectify the ac
output of secondary of 230/18V step down transformer.
www.wineyard.in
MP11
Reference Oscillator
Switching Circuit
Detector Oscillator
Driver Circuit
Detector
Coil
Buzzer
Step
down
T/F
Bridge
Rectifier
Filter
Circuit
Regulator
www.wineyard.in
Power supply to all sections