Download AC Output Socket

FBC series 300V 60A Automatic Battery Charger
ITEMS
FBC-30060
Input Power
AC220V 50HZ 1Phase
or AC220V 3Phase or AC380V 3Phase
Charging Voltage
DC 300V (max.375V)
Charging Current
max.60A
Charging method
Limit Current / Limit Voltage / Absorption / Equalization
Recommended
Size（Ah）
Battery
Battery Types
Accommodated
300AH ~ 480AH
Lead-Acid of Deep cycle, Flooded, VRLA batteries
Short circuit protection.
Reverse polarity protection.
Anti-Arc protection
Over temperature protection.
Protection
Operating Temperature
Dimensions
( Lx WxH )
600mm X 670mm X 1050mm
Kgs
Weight
Ideal uses:
-20℃ ~ 50℃
Industry Heavy Duty Useing
Features：
◎
◎
◎
◎
Fully controlled by microprocessor.
Programmable voltage capability
No Power in the output leads until connected to the batteries.
Two start modes：
＊ Auto start with thirty minute delay（programmable 30、60、90 or 120 minutes）
＊ Push to start
◎ Automatic Equalization
◎ Anti-Arc protection：Means no sparks are generated when connecting the charger to the battery or
outlet.
◎ Low battery voltage start：The charging function will be started when battery is at low voltage. When
battery over discharging to low voltage as 1V (for single cell), the microcomputer of this charging
apparatus will be able to start to charge.
◎ Protection over the reverse connection of the battery: When the pole of the battery is wrongly
connected, the charging machine will be unable to use.
1. Auto detect function：Auto check whether the battery wiring and charging circuit are normal and
completely correct，then the microcomputer may start to do the charging.
2. Microcomputer check ( check stopped when battery abnormal )：When battery is breakdown or cell
plate is damaged and unable to achieve 80％ effective capacity or battery voltage unable to achieve
effective saturation voltage within 12 hours，the charging apparatus will auto stop to protect the
charging apparatus and battery, besides the indicator will display the battery abnormal.
3. Regulate the charging voltage and current to guarantee steady absorption of the battery：The steady
current protects the battery in absorption stage, no temperature raise & no over charging. (The
battery temperature will go up after it has just been used due to great amount of discharge)
4. Auto delay turning on the machine to protect battery function: when the charging apparatus is turned
on and connected to the battery, the charging apparatus will auto get into delay turning on the
apparatus for charging, and auto start the charging after delay time is up to protect the battery. The
delay turning on function may protect the battery for natural cool down, and wait until temperature
goes down for auto charging so that the battery temperature will not go too high and affect the
battery service life. The delay turning on time may be set up on your own from 30–60、90–120
minutes.【The battery temperature will go up after it has just been used due to great amount of
discharge, it is not suitable to do charging right away
5. CPU auto pressure increasing system may do the auto increasing at the end of the charging, when
the charging achieved about 80% and the current is one-fifth (1/5) less than that of the output total
current, then CUP auto pressure increasing system may auto increase the charging current at the
end of the charging to help the charging achieve 100%.
6. Even time balance function allow every single pole of the battery achieve evenly saturated voltage
and increase the efficiency, the even balance time may set up at 60-120-180-240 minutes
respectively.
7. The electricity quantity of the battery displayed with percentage can fully control the charging
saturation change.
8. The digital voltage meter displays the voltage allows you to see if the battery voltage is normal.
9. CPU programmable charging function allows one to regulate the charging method according to the
requirement of the customers.
CHARGING CURVE：