Survey
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project
Requirements of the SwissFEL Timing Babak Kalantari Timing Workshop @ PSI 06.10.2011 Frame rate requirements Increase the event clock to about 150 MHz (currently 125 MHz not sufficient). Precisely 142.8 MHz required. [Rocket IO speed of greater than 2.5 GHz] Preliminary discussions with MRF has started Technological challenges on low jitter transmission according to Jukka Babak Kalantari Timing Workshop @ PSI 06.10.2011 EVG: a better Sequencer SwissFEL will be operated at 100 Hz rep (seq. trigger rate) From our experience in injector test facility we know that: we have to maintain several event sets at different rates, consequence: : every sequence pattern is different Do less frequent sequencer programming of the EVG by IOC (CPU), delegate more to EVG Babak Kalantari Timing Workshop @ PSI 06.10.2011 EVG: proposal for a new sequencing sequencers sequences seq1 1 seq2 2 seq3 Chain A (M sequences) seq4 seq5 seq6 seq7 Play and Load mechanism within a sequence chain: seq8 seq9 seq10 sequencer 1: sequencer 2: seq11 Trigger: seq1 seq2 t0 seq3 seq2 t1 seq5 seq4 seq3 seq4 t2 t3 seq12 seq13 Chain B (N sequences) seq14 seq15 seq16 seq17 seq18 seq19 seq20 Babak Kalantari Timing Workshop @ PSI 06.10.2011 EVG: other requirements … It must be possible to delay the internal, external or AC synced sequencer trigger with much higher resolution at least at microsecond level. This will replace the currently existing phase shifter which delays the sequence trigger generated by the AC input trigger with resolution of 0.1 ms. Babak Kalantari Timing Workshop @ PSI 06.10.2011 Other requirements … We most probably will use backward links: some applications already are in sight some simple low level protocol is required if the to identify data sender (EVR). Notion of protocols already exists in mrfDataBuffer driver has to be looked at more carefully. Diagnostics on distribution network: Some features like readout of power levels of the in/out ports especially at fanouts temperature, etc or any kind of information which releases us from going to the distribution locations for manual/visual checking. Such information could be read via network interface or bus interface e.g. VME, etc. Babak Kalantari Timing Workshop @ PSI 06.10.2011 Other requirements … EVR: Not much new major features needed but a minor.. trigger the same pulser from 2 (or more) events with independent local delays Babak Kalantari Timing Workshop @ PSI 06.10.2011