Download ENDO CUT® I and Q

System
ENDO CUT I
®
With its highly flexible programming architecture and intuitive controls, ENDO CUT® I is an
innovative approach to endoscopic tissue separation. Only ERBE VIO offers the next generation in
ENDO CUT® technology. With the introduction of ENDO CUT® I, the physician is able to tailor cutting
speed, interval and duration, and has the ability to select from four different levels of hemostasis.
Adjustable Parameters
Effect setting
adjusts
hemostasis level
9
Choose from
needle or
wire electrode
EndoCut Knife/Wire
Monopolar
receptacle
Guide/
progs.
Mode
Mode
ENDO CUT I
Effect
FORCED COAG
Upmax:550Vp Upmax:1100Vp
2
Length
of cut
2
Cut
Cut
duration interval
2
Effect
3
Time
between cut
max. watts
25
Physician testimonial
“Use of the microprocessorcontrolled ERBE electrosurgical
generator for endoscopic
sphincterotomy was associated
with a significantly lower
frequency of endoscopically
observed bleeding.”
Rafael F. Perini, MD; Rafal Sadurski, MD
Peter B. Cotton, MD; Rig S. Patel, MD
Robert H. Hawes, MD; John T. Cunningham, MD
Gastrointest. Endosc. 2005; 61: 53-7
The coagulation phase allows for additional coagulation between the cutting
phases. Coagulation intensity can be adjusted using the EFFECT setting with four
modes, altering coagulation voltage levels. Raising the EFFECT setting increases
coagulation intensity.
“Post-sphincterotomy Bleeding After the
Introduction of Microprocessor-controlled
Electrosurgery: Does the New Technology
Make the Difference?”
I =
I is the mode used for needle electrodes and sphincterotomes.
2225 Northwest Parkway, Marietta, GA 30067 USA
www.erbe-usa.com
EMAIL [email protected]
CUSTOMER SERVICE 800.778.3723
System
ENDO CUT Q
®
With its highly flexible programming architecture and intuitive controls, ENDO CUT® Q is an
innovative approach to endoscopic tissue separation. Only ERBE VIO offers the next generation in
ENDO CUT® technology. With the introduction of ENDO CUT® Q, the physician is able to tailor cutting
speed, interval and duration, and has the ability to select from four different levels of hemostasis.
Adjustable Parameters
Effect setting
adjusts
hemostasis level
10
Choose from
snare wire or
loop electrode
EndoCut Snare
Monopolar
receptacle
Guide/
progs.
Mode
Mode
ENDO CUT Q
Effect
FORCED COAG
Upmax:770Vp
Upmax:1100Vp
3
Length
of cut
2
Cut
Cut
duration interval
1
Effect
6
Time
between cut
max. watts
25
Physician testimonial
“I try to schedule all my
patients at the Endo Center
at Voorhees because of the
ERBE electrosurgical units
with ENDO CUT ®. I have
more confidence in the safe,
controlled cutting of the unit
for polypectomy.”
- Dr. Jane Friehling
The Endo Center at Voorhees
Voorhees, New Jersey
The coagulation phase allows for additional coagulation between the cutting
phases. Coagulation intensity can be adjusted using the EFFECT setting with four
modes, altering coagulation voltage levels. Raising the EFFECT setting increases
coagulation intensity.
Q=
Q is the mode used for snare wire or loop electrodes.
MKT/5027/01 9/06