Cable Coupler Overview
... Ground-check circuits that connect after and disconnect before the phase conductors. Covers which protect against damage and contamination when not in use. ...
... Ground-check circuits that connect after and disconnect before the phase conductors. Covers which protect against damage and contamination when not in use. ...
Series 300 UPS
... input current shall be limited to 125% of the full input current rating. The rectifier/charger shall operate at a reduced current limit mode whenever the critical load is powered from the UPS static bypass circuit such that the maximum UPS input current will not exceed 125% of full load input curren ...
... input current shall be limited to 125% of the full input current rating. The rectifier/charger shall operate at a reduced current limit mode whenever the critical load is powered from the UPS static bypass circuit such that the maximum UPS input current will not exceed 125% of full load input curren ...
VLT 3500 Series
... automatically reduce its carrier frequency to reduce the heat sink temperature. As the VFD’s heat sink temperature returns to normal, the VFD shall automatically increase the carrier frequency to its set switching frequency. This assures the highest possible carrier frequency for a quiet motor with ...
... automatically reduce its carrier frequency to reduce the heat sink temperature. As the VFD’s heat sink temperature returns to normal, the VFD shall automatically increase the carrier frequency to its set switching frequency. This assures the highest possible carrier frequency for a quiet motor with ...
Altivar ® 31 Adjustable Speed AC Drives
... • 1 to 20 hp (0.75 to 15 kW), 525/575/600 V, three-phase input Industrial users and OEMs who specialize in material handling, pump, fan, packing, packaging, and general purpose motor control applications will find the features and functions of the ATV31 drive controller well suited for their use. ...
... • 1 to 20 hp (0.75 to 15 kW), 525/575/600 V, three-phase input Industrial users and OEMs who specialize in material handling, pump, fan, packing, packaging, and general purpose motor control applications will find the features and functions of the ATV31 drive controller well suited for their use. ...
H CMOS Switches Offer High Performance in Low Power, Wideband Applications
... of the switch can modulate the Vg, thereby causing distortion products as the on resistance of the switch varies. The use of high control voltages will reduce this effect, but only at the cost of generating voltages of approximately +2 V to –8 V to control the switches. GaAs processes don’t offer co ...
... of the switch can modulate the Vg, thereby causing distortion products as the on resistance of the switch varies. The use of high control voltages will reduce this effect, but only at the cost of generating voltages of approximately +2 V to –8 V to control the switches. GaAs processes don’t offer co ...
GM300 Mobile Radios Service Manual
... tiÞcation number for all chassis, kits, and components. If you do not know a part number, include with your order the number of the chassis or kit which contains the part, and a detailed description of the desired component. If a Motorola part number is identiÞed on a parts list, you should be able ...
... tiÞcation number for all chassis, kits, and components. If you do not know a part number, include with your order the number of the chassis or kit which contains the part, and a detailed description of the desired component. If a Motorola part number is identiÞed on a parts list, you should be able ...
Model 9005-A - HI
... 2.38 Do not use the meter if it has undergone long-term storage under unfavorable conditions. Failure to observe this precaution may result in damage to the meter or injury to the user. 2.39 Do not use the meter if it may have been damaged in transport. Failure to observe this precaution may result ...
... 2.38 Do not use the meter if it has undergone long-term storage under unfavorable conditions. Failure to observe this precaution may result in damage to the meter or injury to the user. 2.39 Do not use the meter if it may have been damaged in transport. Failure to observe this precaution may result ...
Findings and recommendations
... Note: According to Avaya Communication Server 1000E: Planning and Engineering (NN43041-220), Avaya recommends using an isolated ground topology as the preferred method of grounds for use as the CS 1000E single-point ground source. In the absence of such facilities, a portable or hardwired UPS system ...
... Note: According to Avaya Communication Server 1000E: Planning and Engineering (NN43041-220), Avaya recommends using an isolated ground topology as the preferred method of grounds for use as the CS 1000E single-point ground source. In the absence of such facilities, a portable or hardwired UPS system ...
Alarm Controller v1.0 Installation Guide
... Use the following list as a guide to find a suitable location to install this equipment: • Locate near a telephone socket and power outlet. • Select a location free from vibration and shock. • Place alarm controller on a flat, stable surface and follow the installation instructions. Do NOT locate th ...
... Use the following list as a guide to find a suitable location to install this equipment: • Locate near a telephone socket and power outlet. • Select a location free from vibration and shock. • Place alarm controller on a flat, stable surface and follow the installation instructions. Do NOT locate th ...
MAX14617 USB Host Charger Identification/Adapter Emulator General Description Benefits and Features
... device attached. If the voltage at DM is 2.05V (typ) or higher and the voltage at DP is 2.3V (typ) or lower, the voltage stays unchanged. If the voltage at DM is forced below the 2.05V (typ) threshold, the internal switch disconnects DM and DP from the resistor-divider and DP and DM are shorted toge ...
... device attached. If the voltage at DM is 2.05V (typ) or higher and the voltage at DP is 2.3V (typ) or lower, the voltage stays unchanged. If the voltage at DM is forced below the 2.05V (typ) threshold, the internal switch disconnects DM and DP from the resistor-divider and DP and DM are shorted toge ...
PowerLogic™ PM5100 Series Power and
... • Only qualified electrical workers should install this equipment. Such work should be performed only after reading this entire set of instructions. • If the equipment is not used in a manner specified by the manufacturer, the protection provided by the equipment may be impaired. • NEVER work alone. ...
... • Only qualified electrical workers should install this equipment. Such work should be performed only after reading this entire set of instructions. • If the equipment is not used in a manner specified by the manufacturer, the protection provided by the equipment may be impaired. • NEVER work alone. ...
MAX9374/MAX9374A Differential LVPECL-to-LVDS Translators General Description Features
... VCC to GND...........................................................................4.0V VD, VD to GND ..............................................-0.3V to VCC + 0.3V VD to VD ................................................................................3.0V VBB Sink/Source Current............. ...
... VCC to GND...........................................................................4.0V VD, VD to GND ..............................................-0.3V to VCC + 0.3V VD to VD ................................................................................3.0V VBB Sink/Source Current............. ...
SFH618A, SFH6186
... Statements regarding the suitability of products for certain types of applications are based on Vishay’s knowledge of typical requirements that are often placed on Vishay products in generic applications. Such statements are not binding statements about the suitability of products for a particular a ...
... Statements regarding the suitability of products for certain types of applications are based on Vishay’s knowledge of typical requirements that are often placed on Vishay products in generic applications. Such statements are not binding statements about the suitability of products for a particular a ...
Stakeholder Comparison Comment Rationale Matrix 2011-04-28 AESO AUTHORITATIVE DOCUMENT PROCESS
... Reason for Differences (Insert comments here) are used only for station entrance (001 thru 004)–WECC–1–CR and exit purposes, and if they do System Performance Criteria. not exceed five (5) towers at each station, this condition is an acceptable risk and therefore can Bulleted requirements were rebe ...
... Reason for Differences (Insert comments here) are used only for station entrance (001 thru 004)–WECC–1–CR and exit purposes, and if they do System Performance Criteria. not exceed five (5) towers at each station, this condition is an acceptable risk and therefore can Bulleted requirements were rebe ...
Crosstalk
... Forward crosstalk is proportional to the derivative of the driving signal and to the line length. The constant of proportion depends on the balance between inductive and capacitive coupling. Reverse crosstalk looks like a square pulse, with rise/fall times comparable to the input signal and height p ...
... Forward crosstalk is proportional to the derivative of the driving signal and to the line length. The constant of proportion depends on the balance between inductive and capacitive coupling. Reverse crosstalk looks like a square pulse, with rise/fall times comparable to the input signal and height p ...
Delay Sensitivity to Vth Variations
... performance its area must be 2.1 times the area of a standard NAND gate For a three input hybrid NAND, the area overhead required to match the nominal performance of a standard 3 input NAND gate is 1.5×. ...
... performance its area must be 2.1 times the area of a standard NAND gate For a three input hybrid NAND, the area overhead required to match the nominal performance of a standard 3 input NAND gate is 1.5×. ...
Vibration measurement
... The traditional velocity system consists of a coil and a magnet, either of which (but not both) may be mounted on springs. As they move relative to each other, the magnetic flux cuts the coil and generates a voltage. The output is a function of the rate of change of flux, or relative velocity of the ...
... The traditional velocity system consists of a coil and a magnet, either of which (but not both) may be mounted on springs. As they move relative to each other, the magnetic flux cuts the coil and generates a voltage. The output is a function of the rate of change of flux, or relative velocity of the ...
Nanowire Transistors and RF Circuits for Low
... which can be either grown with a bottom-up technique, or etched out with a topdown approach. The research interest concerning nanowires has gradually increasing for over two decades. Today, few have doubts that nanowires represent an attractive alternative, as scaling of planar structures has reache ...
... which can be either grown with a bottom-up technique, or etched out with a topdown approach. The research interest concerning nanowires has gradually increasing for over two decades. Today, few have doubts that nanowires represent an attractive alternative, as scaling of planar structures has reache ...
FSA6157 Low-RON SPDT (0.8Ω) Negative
... arising out of the application or use of any product or circuit, and specifically disclaims any and all liability, including without limitation special, consequential or incidental damages. Buyer is responsible for its products and applications using ON Semiconductor products, including compliance w ...
... arising out of the application or use of any product or circuit, and specifically disclaims any and all liability, including without limitation special, consequential or incidental damages. Buyer is responsible for its products and applications using ON Semiconductor products, including compliance w ...
Equipment Life Extension and Modernization of Generator
... As previously mentioned, in the generator circuit configuration utilizing a close connected step-up transformer (Figure 2) the two large and expensive components, each with highly inductive impedances are connected through the generator circuit breaker with short conductors of minimal resistance. Co ...
... As previously mentioned, in the generator circuit configuration utilizing a close connected step-up transformer (Figure 2) the two large and expensive components, each with highly inductive impedances are connected through the generator circuit breaker with short conductors of minimal resistance. Co ...
Mains electricity
Mains electricity is the general-purpose alternating-current (AC) electric power supply. In the US, electric power is referred to by several names including household power, household electricity, house current, powerline, domestic power, wall power, line power, AC power, city power, street power, and grid power.The two principal properties of the electric power supply, voltage and frequency, differ between regions. A voltage of (nominally) 230 V and a frequency of 50 Hz is used in Europe, most of Asia, most of South America and Australia. In North America, the most common combination is 120 V and a frequency of 60 Hz. Other voltages exist, and some countries may have, for example, 230 V but 60 Hz. This is a concern to travelers, since portable appliances designed for one voltage and frequency combination may not operate or may be destroyed by another.The use of different plugs and sockets in different regions provides some protection from accidental use of appliances with incompatible voltage and frequency requirements.