FPF2024/5/6/7 Full Functional Load Switch With 100mA Current Limit F P
... The FPF2024/5/6/7 respond to an output overload condition by going into constant current mode where the output current is regulated by the load switch. If the overcurrent condition persists beyond the 10ms Blanking Time, FPF2024 and FPF2025 pull the fault signal pin (FLAGB) low and shut-off the swit ...
... The FPF2024/5/6/7 respond to an output overload condition by going into constant current mode where the output current is regulated by the load switch. If the overcurrent condition persists beyond the 10ms Blanking Time, FPF2024 and FPF2025 pull the fault signal pin (FLAGB) low and shut-off the swit ...
AN2009-06 MIPAQ™ sense
... estimate of the analog input signal. At the same time, a lower sampling rate suitable for a microcontroller or DSP is generated. Each output sample is generated from a long sequence of input samples. In many cases, single-bit quantization is sufficient in an oversampled feedback modulator. In recent ...
... estimate of the analog input signal. At the same time, a lower sampling rate suitable for a microcontroller or DSP is generated. Each output sample is generated from a long sequence of input samples. In many cases, single-bit quantization is sufficient in an oversampled feedback modulator. In recent ...
MAX5222 Dual, 8-Bit, Voltage-Output Serial DAC in 8-Pin SOT23 General Description
... power-supply range is from +5.5V down to +2.7V. Reference Input and DAC Output Range The voltage at REF sets the full-scale output of the DACs. The input impedance of the REF input is code dependent. The lowest value, approximately 8kΩ, occurs when the input code is 01010101 (55hex). The maximum val ...
... power-supply range is from +5.5V down to +2.7V. Reference Input and DAC Output Range The voltage at REF sets the full-scale output of the DACs. The input impedance of the REF input is code dependent. The lowest value, approximately 8kΩ, occurs when the input code is 01010101 (55hex). The maximum val ...
Crate PSU Stress Analysis
... Power Dissipation Analysis – All IC’s are operating within the fanout derating criteria at a switching rate much less than the derated maximum frequency limit, therefore the power dissipated will be within the derating criteria. Hard copies of this document are for REFERENCE ONLY and should not be c ...
... Power Dissipation Analysis – All IC’s are operating within the fanout derating criteria at a switching rate much less than the derated maximum frequency limit, therefore the power dissipated will be within the derating criteria. Hard copies of this document are for REFERENCE ONLY and should not be c ...
PAM8403 Description Pin Assignments
... failure of the life support device or to affect its safety or effectiveness. Customers represent that they have all necessary expertise in the safety and regulatory ramifications of their life support devices or systems, and acknowledge and agree that they are solely responsible for all legal, regul ...
... failure of the life support device or to affect its safety or effectiveness. Customers represent that they have all necessary expertise in the safety and regulatory ramifications of their life support devices or systems, and acknowledge and agree that they are solely responsible for all legal, regul ...
Chapter 10 Sinusoidal steady
... 1. With same frequency sources. 2. With different frequency sources EXAMPLE 8-14 ...
... 1. With same frequency sources. 2. With different frequency sources EXAMPLE 8-14 ...
Servo Reverser - Hobbielektronika.hu
... solution and indeed it will be when the manufacturers of our radios figure out the need for this type of dual servo control. However, if you try it now, you will find that the transmitter trim lever, in all of the radio systems that I am aware of, will affect only the master servo, leaving the slave ...
... solution and indeed it will be when the manufacturers of our radios figure out the need for this type of dual servo control. However, if you try it now, you will find that the transmitter trim lever, in all of the radio systems that I am aware of, will affect only the master servo, leaving the slave ...
NX5P3001 1. General description Bidirectional high-side power switch for charger and
... translation (EN) and low capacitance Transient Voltage Suppression (TVS) type ESD-clamps for USB data and ID pins. When EN is set HIGH the device enters a low-power mode, disabling all protection circuits. When used in combined charger and USB-OTG applications the 30 V tolerant VBUSI switch terminal ...
... translation (EN) and low capacitance Transient Voltage Suppression (TVS) type ESD-clamps for USB data and ID pins. When EN is set HIGH the device enters a low-power mode, disabling all protection circuits. When used in combined charger and USB-OTG applications the 30 V tolerant VBUSI switch terminal ...
MAX4249–MAX4257 UCSP, Single-Supply, Low-Noise, Low-Distortion, Rail-to-Rail Op Amps General Description
... quiescent supply current per amplifier while featuring ultra-low distortion (0.0002% THD), as well as low input voltage-noise density (7.9nV/√Hz) and low input current-noise density (0.5fA/√Hz). These features make the devices an ideal choice for portable/battery-powered applications that require lo ...
... quiescent supply current per amplifier while featuring ultra-low distortion (0.0002% THD), as well as low input voltage-noise density (7.9nV/√Hz) and low input current-noise density (0.5fA/√Hz). These features make the devices an ideal choice for portable/battery-powered applications that require lo ...
DEWA Standards for Distributed Renewable Resources Generators
... Unit is disconnected for any event that could impair the integrity or degrade the safety of the Distribution Network. ...
... Unit is disconnected for any event that could impair the integrity or degrade the safety of the Distribution Network. ...
— Extra-Small, High-Performance, FDMF6824A High-Frequency DrMOS Module FDMF6
... No connect. The pin is not electrically connected internally, but can be connected to VIN for convenience. ...
... No connect. The pin is not electrically connected internally, but can be connected to VIN for convenience. ...
FAN6921ML Integrated Critical Mode PFC/Quasi-Resonant Current Mode PWM Controller
... Adjustable Over-Temperature Latched (RT Pin) VDD Pin & Output Voltage OVP (Latched) Internal Temperature Shutdown (140°C) ...
... Adjustable Over-Temperature Latched (RT Pin) VDD Pin & Output Voltage OVP (Latched) Internal Temperature Shutdown (140°C) ...
MAX1874 Dual-Input, USB/AC Adapter, 1-Cell Li+ Charger with OVP and Thermal Regulation
... external MOSFET or diodes, and accepts input voltages up to 6.5V; however, DC input overvoltage protection up to 18V can be added with a single SOT PFET. On-chip thermal limiting simplifies printed circuit board (PCB) layout and allows optimum charging rate without the thermal limits imposed by wors ...
... external MOSFET or diodes, and accepts input voltages up to 6.5V; however, DC input overvoltage protection up to 18V can be added with a single SOT PFET. On-chip thermal limiting simplifies printed circuit board (PCB) layout and allows optimum charging rate without the thermal limits imposed by wors ...
LOW-POWER DISSIPATION ADSL LINE DRIVER THS6182 FEATURES DESCRIPTION
... driver ideal for full rate ADSL systems. Its extremely low-power dissipation is ideal for ADSL systems that must achieve high densities in ADSL central office rack applications. The unique architecture of the THS6182 allows the quiescent current to be much lower than existing line drivers while stil ...
... driver ideal for full rate ADSL systems. Its extremely low-power dissipation is ideal for ADSL systems that must achieve high densities in ADSL central office rack applications. The unique architecture of the THS6182 allows the quiescent current to be much lower than existing line drivers while stil ...
HMMC-3104 DC-16 GHz Packaged Divide-by-4 Prescaler
... 1. For sine-wave input signal. Prescaler will operate down to D.C. for square-wave input signal. Minimum divide frequency limited by input slew-rate. 2. Prescaler may exhibit this output signal under bias in the absence of an RF input signal. This condition may be eliminated by use of the Input dc ...
... 1. For sine-wave input signal. Prescaler will operate down to D.C. for square-wave input signal. Minimum divide frequency limited by input slew-rate. 2. Prescaler may exhibit this output signal under bias in the absence of an RF input signal. This condition may be eliminated by use of the Input dc ...
SMPS AC/DC Reference Design User`s Guide
... BLOCK DIAGRAM A conventional SMPS must implement PFC if it draws more than 75 watts from the AC Mains. The PFC circuitry draws input current in phase with the input voltage, and the Total Harmonic Distortion (THD) of the input current should be less than 5% at full load. The PFC provides a fixed DC ...
... BLOCK DIAGRAM A conventional SMPS must implement PFC if it draws more than 75 watts from the AC Mains. The PFC circuitry draws input current in phase with the input voltage, and the Total Harmonic Distortion (THD) of the input current should be less than 5% at full load. The PFC provides a fixed DC ...
lecture 080 – latchup and esd
... 2.) A bias condition must exist such that both bipolars are turned on long enough for current through the “SCR” to exceed its switching current. 3.) The bias supply and associated circuits must be capable of supplying the current at least equal to the switching current and at least equal to the hold ...
... 2.) A bias condition must exist such that both bipolars are turned on long enough for current through the “SCR” to exceed its switching current. 3.) The bias supply and associated circuits must be capable of supplying the current at least equal to the switching current and at least equal to the hold ...
Reverse Conduction IGBT for Inductive Cooking
... The underlying models of both the IGBT and the diode are physics based and have been published elsewhere. These physics based sub models account for the relevant device phenomena, as there is the charge injection via anode and cathode pn-junctions, the dynamic conductivity modulation of the base reg ...
... The underlying models of both the IGBT and the diode are physics based and have been published elsewhere. These physics based sub models account for the relevant device phenomena, as there is the charge injection via anode and cathode pn-junctions, the dynamic conductivity modulation of the base reg ...
Power inverter
A power inverter, or inverter, is an electronic device or circuitry that changes direct current (DC) to alternating current (AC).The input voltage, output voltage and frequency, and overall power handling depend on the design of the specific device or circuitry. The inverter does not produce any power; the power is provided by the DC source.A power inverter can be entirely electronic or may be a combination of mechanical effects (such as a rotary apparatus) and electronic circuitry.Static inverters do not use moving parts in the conversion process.