PPT
... Such a device is called an emf , or electromotive force. A common emf device is the battery, used to power a wide variety of machines from wristwatches to submarines. The emf device that most influences our daily lives is the electric generator, which, by means of electrical connections (wires) from ...
... Such a device is called an emf , or electromotive force. A common emf device is the battery, used to power a wide variety of machines from wristwatches to submarines. The emf device that most influences our daily lives is the electric generator, which, by means of electrical connections (wires) from ...
PAM3116 Description Pin Assignments
... A 4.7μF or larger ceramic input bypass capacitor, connected between VIN and GND and located close to the PAM3116, is required for stability. A 4.7µF minimum value capacitor from VO to GND is also required. To improve transient response, noise rejection, and ripple rejection, an additional 1 0μF or l ...
... A 4.7μF or larger ceramic input bypass capacitor, connected between VIN and GND and located close to the PAM3116, is required for stability. A 4.7µF minimum value capacitor from VO to GND is also required. To improve transient response, noise rejection, and ripple rejection, an additional 1 0μF or l ...
OPA699 Wideband, High Gain VOLTAGE LIMITING AMPLIFIER FEATURES
... (2) Junction temperature = ambient at low temperature limit; junction temperature = ambient +1°C at high temperature limit for over-temperature tested specifications. (3) Test Levels: (A) 100% tested at +25°C. Over temperature limits by characterization and simulation. (B) Limits set by characteriza ...
... (2) Junction temperature = ambient at low temperature limit; junction temperature = ambient +1°C at high temperature limit for over-temperature tested specifications. (3) Test Levels: (A) 100% tested at +25°C. Over temperature limits by characterization and simulation. (B) Limits set by characteriza ...
OPA3695
... 900MHz BANDWIDTH, GAIN = +2V/V 450MHz BANDWIDTH, GAIN = +8V/V WIDE OUTPUT VOLTAGE SWING: ±4V ULTRA-HIGH SLEW RATE: 4300V/µs 3RD-ORDER INTERCEPT: > 35dBm (f < 40MHz) LOW 1.8nV/√Hz VOLTAGE NOISE ...
... 900MHz BANDWIDTH, GAIN = +2V/V 450MHz BANDWIDTH, GAIN = +8V/V WIDE OUTPUT VOLTAGE SWING: ±4V ULTRA-HIGH SLEW RATE: 4300V/µs 3RD-ORDER INTERCEPT: > 35dBm (f < 40MHz) LOW 1.8nV/√Hz VOLTAGE NOISE ...
Lecture 7: RF front-end design LNA mixer
... Mixer noise figure can be approximately analyzed using a lowly swept dc voltage at the LO input or with an actual LO signal. With a slowly swept dc voltage, the mixer becomes equivalent to a cascode amplifier and the LO input served as a gain-controlling signal. For mixer, any noise (or signal) is m ...
... Mixer noise figure can be approximately analyzed using a lowly swept dc voltage at the LO input or with an actual LO signal. With a slowly swept dc voltage, the mixer becomes equivalent to a cascode amplifier and the LO input served as a gain-controlling signal. For mixer, any noise (or signal) is m ...
Exp_9
... therefore illegal, except briefly during transitions. If a TTL circuit is given a voltage in this undefined range, it might, unpredictably, interpret it as either a “1” or a “0.” ...
... therefore illegal, except briefly during transitions. If a TTL circuit is given a voltage in this undefined range, it might, unpredictably, interpret it as either a “1” or a “0.” ...
REG710-25 数据资料 dataSheet 下载
... The regulator has thermal shutdown circuitry that protects it from damage caused by overload conditions. The thermal protection circuitry disables the output when the junction temperature reaches approximately +160°C, allowing the device to cool. When the junction temperature cools to approximately ...
... The regulator has thermal shutdown circuitry that protects it from damage caused by overload conditions. The thermal protection circuitry disables the output when the junction temperature reaches approximately +160°C, allowing the device to cool. When the junction temperature cools to approximately ...
UCC27200 数据资料 dataSheet 下载
... Stresses beyond those listed under “absolute maximum ratings” may cause permanent damage to the device. These are stress ratings only, and functional operation of the device at these or any other conditions beyond those indicated under “recommended operating conditions” is not implied. Exposure to a ...
... Stresses beyond those listed under “absolute maximum ratings” may cause permanent damage to the device. These are stress ratings only, and functional operation of the device at these or any other conditions beyond those indicated under “recommended operating conditions” is not implied. Exposure to a ...
MAX1705/MAX1706 1- to 3-Cell, High-Current, Low-Noise, Step-Up DC-DC Converters with Linear Regulator
... ONA, ONB, FBLDO, OUT, POUT to GND...................-0.3V to 6V PGND to GND.....................................................................±0.3V POUT to OUT ......................................................................±0.3V LX to PGND ............................................-0.3V t ...
... ONA, ONB, FBLDO, OUT, POUT to GND...................-0.3V to 6V PGND to GND.....................................................................±0.3V POUT to OUT ......................................................................±0.3V LX to PGND ............................................-0.3V t ...
PSPICE计算机仿真
... The short circuit current, which is the current through the voltage source V3, is 2 A. ...
... The short circuit current, which is the current through the voltage source V3, is 2 A. ...
TPS2375 数据资料 dataSheet 下载
... where ILIM is the desired inrush current value, in amperes, and R(ILIM) is the value of the programming resistor from ILIM to VSS, in ohms. The practical limits on R(ILIM) are 62.5 kΩ to 500 kΩ. A value of 178 kΩ is recommended for compatibility with legacy PSEs. Inrush current limiting prevents cur ...
... where ILIM is the desired inrush current value, in amperes, and R(ILIM) is the value of the programming resistor from ILIM to VSS, in ohms. The practical limits on R(ILIM) are 62.5 kΩ to 500 kΩ. A value of 178 kΩ is recommended for compatibility with legacy PSEs. Inrush current limiting prevents cur ...
Series MT and MT Strobe Multitone Electronic
... The notification appliance shall be a Wheelock Series MT audible/visual appliance or equivalent. Notification appliance shall be electronic and use solid state components. Electromechanical alternatives are not approved. Each electronic appliance shall provide eight (8) field selectable alarm tones. ...
... The notification appliance shall be a Wheelock Series MT audible/visual appliance or equivalent. Notification appliance shall be electronic and use solid state components. Electromechanical alternatives are not approved. Each electronic appliance shall provide eight (8) field selectable alarm tones. ...
23 - Cardinal Newman High School
... • Characteristics of series circuit (continued): 4. The total voltage impressed across a series circuit divides among the individual electrical devices in the circuit so that the sum of the “voltage drops” across the resistance of each individual device is equal to the total voltage supplied by the ...
... • Characteristics of series circuit (continued): 4. The total voltage impressed across a series circuit divides among the individual electrical devices in the circuit so that the sum of the “voltage drops” across the resistance of each individual device is equal to the total voltage supplied by the ...
DC/AC Fundamentals: A Systems Approach
... If R2 is open, there is no current. Notice that VB = 0 V because it is ground and VA = 0 V because it has the same potential as VB. VC = -12 V because the source voltage is across the open. DC/AC Fundamentals: A Systems Approach Thomas L. Floyd ...
... If R2 is open, there is no current. Notice that VB = 0 V because it is ground and VA = 0 V because it has the same potential as VB. VC = -12 V because the source voltage is across the open. DC/AC Fundamentals: A Systems Approach Thomas L. Floyd ...
power point for Chapter 23
... • Characteristics of series circuit (continued): 4. The total voltage impressed across a series circuit divides among the individual electrical devices in the circuit so that the sum of the “voltage drops” across the resistance of each individual device is equal to the total voltage supplied by the ...
... • Characteristics of series circuit (continued): 4. The total voltage impressed across a series circuit divides among the individual electrical devices in the circuit so that the sum of the “voltage drops” across the resistance of each individual device is equal to the total voltage supplied by the ...
Atmel LED Driver-MSL1060
... Voltage (With Respect to GND Exposed Pad on Package Underside) VIN................................................................................................................................................................................................... -0.3V to +40V VCC, EN................. ...
... Voltage (With Respect to GND Exposed Pad on Package Underside) VIN................................................................................................................................................................................................... -0.3V to +40V VCC, EN................. ...
MAX1762/MAX1791 High-Efficiency, 10-Pin µMAX, Step-Down Controllers for Notebooks General Description
... allows small external components to be utilized in PC board area-critical applications such as subnotebook computers and smart phones. PWM operation occurs at heavy loads, and automatic switchover to pulse-skipping operation occurs at lighter loads. The external high-side p-channel and low-side n-ch ...
... allows small external components to be utilized in PC board area-critical applications such as subnotebook computers and smart phones. PWM operation occurs at heavy loads, and automatic switchover to pulse-skipping operation occurs at lighter loads. The external high-side p-channel and low-side n-ch ...
