• Study Resource
  • Explore
    • Arts & Humanities
    • Business
    • Engineering & Technology
    • Foreign Language
    • History
    • Math
    • Science
    • Social Science

    Top subcategories

    • Advanced Math
    • Algebra
    • Basic Math
    • Calculus
    • Geometry
    • Linear Algebra
    • Pre-Algebra
    • Pre-Calculus
    • Statistics And Probability
    • Trigonometry
    • other →

    Top subcategories

    • Astronomy
    • Astrophysics
    • Biology
    • Chemistry
    • Earth Science
    • Environmental Science
    • Health Science
    • Physics
    • other →

    Top subcategories

    • Anthropology
    • Law
    • Political Science
    • Psychology
    • Sociology
    • other →

    Top subcategories

    • Accounting
    • Economics
    • Finance
    • Management
    • other →

    Top subcategories

    • Aerospace Engineering
    • Bioengineering
    • Chemical Engineering
    • Civil Engineering
    • Computer Science
    • Electrical Engineering
    • Industrial Engineering
    • Mechanical Engineering
    • Web Design
    • other →

    Top subcategories

    • Architecture
    • Communications
    • English
    • Gender Studies
    • Music
    • Performing Arts
    • Philosophy
    • Religious Studies
    • Writing
    • other →

    Top subcategories

    • Ancient History
    • European History
    • US History
    • World History
    • other →

    Top subcategories

    • Croatian
    • Czech
    • Finnish
    • Greek
    • Hindi
    • Japanese
    • Korean
    • Persian
    • Swedish
    • Turkish
    • other →
 
Profile Documents Logout
Upload
layered approach for runtime fault recovery in noc-based
layered approach for runtime fault recovery in noc-based

VERTICAL HORIZON VH-2402-L3 FAST ETHERNET SWITCH
VERTICAL HORIZON VH-2402-L3 FAST ETHERNET SWITCH

... used over the network using the TCP/IP TELNET protocol. The console program can be used to configure the switch to use an SNMP-based network management software over the network. This chapter describes how to use the console interface to access the switch, change its settings, and monitor its operat ...
IOSR Journal of Electronics and Communication Engineering (IOSR-JECE)
IOSR Journal of Electronics and Communication Engineering (IOSR-JECE)

... hosts on the LAN. This set is known as an HSRP group or a standby group. A single router elected from the group is responsible for forwarding the packets that hosts send to the virtual router. This router is known as the active router. Another router is elected as the standby router. In the event th ...
IPv6 Survival Kit
IPv6 Survival Kit

NE5000E Product Description
NE5000E Product Description

... The purchased products, services and features are stipulated by the contract made between Huawei and the customer. All or part of the products, services and features described in this document may not be within the purchase scope or the usage scope. Unless otherwise specified in the contract, all st ...
downloading
downloading

... - 1 km of optic fiber - Via satellite with a distance of 30 km between the base and the satellite ...
PPT
PPT

... Spring 2005 E2E Protocols (point-to-point) E2E Protocols (multipoint) CMPE 257 Spring 2005 ...
Network Working Group G. Gross Request for
Network Working Group G. Gross Request for

... [4] are to be used to map PPP onto a FUNI-based ATM network. Section 1 within [4] defines the two mechanisms for identifying the Protocol Data Unit (PDU) payload field’s protocol type: virtual circuit based multiplexing, and Logical Link Control (LLC) encapsulation. In the former technique, the payl ...
Chapter14 (Unicast Routing Protocols)
Chapter14 (Unicast Routing Protocols)

...  Link State Routing OSPF uses Link State Routing to update the routing tables in an area Each router shares its knowledge about its neighborhood with every router in the area. Kyung Hee University ...
OS fingerprinting with IPv6
OS fingerprinting with IPv6

... destination rather than intermediate routers to speed up packet delivery times (Network Working Group, 1998). In IPv4 fingerprinting, tools avoid fragmentation because it is ...
Routing in IPv6 over Low-Power Wireless Personal Area Networks
Routing in IPv6 over Low-Power Wireless Personal Area Networks

... the IEEE 802.15.4. However, ZigBee uses the IEEE 802.15.4 standard as its communication protocol for Medium Access Control (MAC) layer and Physical (PHY) layer. IEEE 802.15.4 devices are characterized by low computational power, scarce memory capacity, lower bit rate, short range, and low cost [1]. ...
On TCP Performance Enhancing Proxies in a Wireless Environment
On TCP Performance Enhancing Proxies in a Wireless Environment

Chapter 1
Chapter 1

... • Used to connect routers to external networks, usually over a larger geographical distance. • The Layer 2 encapsulation can be different types (PPP, Frame Relay, HDLC (High-Level Data Link Control) ). • Similar to LAN interfaces, each WAN interface has its own IP address and subnet mask, making it ...
3rd Edition, Chapter 5
3rd Edition, Chapter 5

3rd Edition, Chapter 5
3rd Edition, Chapter 5

...  If you use these slides (e.g., in a class) in substantially unaltered form, that you mention their source (after all, we’d like people to use our book!)  If you post any slides in substantially unaltered form on a www site, that you note that they are adapted from (or perhaps identical to) our sl ...
Dynamic Routing Protocols - E Learning UPN Veteran Yogyakarta
Dynamic Routing Protocols - E Learning UPN Veteran Yogyakarta

... The TTL field is found in an IP header and is used to prevent packets from endlessly traveling on a network • How the TTL field works TTL field contains a numeric value. The numeric value is decreased by one by every router on the route to the destination. If numeric value reaches 0 then Packet is ...
TCP, IGP, EGP etc. - La Salle University
TCP, IGP, EGP etc. - La Salle University

computer networks
computer networks

... indicate the working node. ...
EPL-Router sorgt für Transparenz und Durchgängigkeit
EPL-Router sorgt für Transparenz und Durchgängigkeit

... The Ethernet Powerlink-Router is equipped with two Ethernet-ports and connects two networks on IP-level. For this purpose it requires two IEEE802.3-compliant network accesses. The real-time port is connected with an Ethernet-Powerlink-segment. The second port is the interface to an IPnetwork, the so ...
Virtual Private Networks (VPN`s)
Virtual Private Networks (VPN`s)

Coding and Error Control
Coding and Error Control

... • EEE 802.15.4k – Low Energy Critical Infrastructure Networks (LECIM) – To facilitate point to multi-thousands of points communications for critical infrastructure monitoring devices with multi-year battery life. ...
How Ethernet becomes industrial
How Ethernet becomes industrial

Redes Inalámbricas
Redes Inalámbricas

... The PSNR is most commonly used as a measure of quality of reconstruction in image compression ...
Scalable Routing Strategies for Ad hoc Wireless Networks
Scalable Routing Strategies for Ad hoc Wireless Networks

... In this paper we consider a large population of mobile stations which are interconnected by a multihop wireless network. A key feature which sets multihop wireless networks apart from the more traditional cellular radio systems is the ability to operate without a xed, wired communications infrastru ...
ALIAS: Scalable, Decentralized Label Assignment for Data Centers
ALIAS: Scalable, Decentralized Label Assignment for Data Centers

... and therefore these L2 switches can all share the same prefix. This process continues up the hierarchy, grouping Li switches into Li HNs based on bipartite connections to Li−1 HNs. Finally, ALIAS assigns unique coordinates to switches, where a coordinate is a number shared by all switches in an HN a ...
< 1 2 3 4 5 6 7 8 ... 103 >

RapidIO

The RapidIO architecture is a high-performance packet-switched, interconnect technology. RapidIO supports messaging, read/write and cache coherency semantics. RapidIO fabrics guarantee in-order packet delivery, enabling power- and area- efficient protocolimplementation in hardware. Based on industry-standard electrical specifications such as those for Ethernet, RapidIO can be used as a chip-to-chip, board-to-board, and chassis-to-chassis interconnect. The protocol is marketed as: RapidIO - the unified fabric for Performance Critical Computing, and is used in many applications such as Data Center & HPC, Communications Infrastructure, Industrial Automation and Military & Aerospace that are constrained by at least one of size, weight, and power (SWaP).
  • studyres.com © 2025
  • DMCA
  • Privacy
  • Terms
  • Report