• Study Resource
  • Explore
    • Arts & Humanities
    • Business
    • Engineering & Technology
    • Foreign Language
    • History
    • Math
    • Science
    • Social Science

    Top subcategories

    • Advanced Math
    • Algebra
    • Basic Math
    • Calculus
    • Geometry
    • Linear Algebra
    • Pre-Algebra
    • Pre-Calculus
    • Statistics And Probability
    • Trigonometry
    • other →

    Top subcategories

    • Astronomy
    • Astrophysics
    • Biology
    • Chemistry
    • Earth Science
    • Environmental Science
    • Health Science
    • Physics
    • other →

    Top subcategories

    • Anthropology
    • Law
    • Political Science
    • Psychology
    • Sociology
    • other →

    Top subcategories

    • Accounting
    • Economics
    • Finance
    • Management
    • other →

    Top subcategories

    • Aerospace Engineering
    • Bioengineering
    • Chemical Engineering
    • Civil Engineering
    • Computer Science
    • Electrical Engineering
    • Industrial Engineering
    • Mechanical Engineering
    • Web Design
    • other →

    Top subcategories

    • Architecture
    • Communications
    • English
    • Gender Studies
    • Music
    • Performing Arts
    • Philosophy
    • Religious Studies
    • Writing
    • other →

    Top subcategories

    • Ancient History
    • European History
    • US History
    • World History
    • other →

    Top subcategories

    • Croatian
    • Czech
    • Finnish
    • Greek
    • Hindi
    • Japanese
    • Korean
    • Persian
    • Swedish
    • Turkish
    • other →
 
Profile Documents Logout
Upload
T D A 7 1 1 6 F
T D A 7 1 1 6 F

... AC/DC Characteristics . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . AC/DC Characteristic at 3V, 25°C . . . . . . . . . . . . . . . . . . . . . . . . . . . . . AC/DC Characteristic at 2.1V ...4.0 V, -40°C ...+85°C . . . . . . . . . . . . . ...
router`s
router`s

... Because routers are protocol-dependent devices, they require software for each protocol that they run. ...
Low-Cost, Integrated, Analog Front-End for Weigh
Low-Cost, Integrated, Analog Front-End for Weigh

... The AFE4300 is a low-cost, integrated front-end designed for weight scales incorporating body-composition measurements. The AFE4300 integrates all the components typically used in a weight scale. It has two signal chains: one for weight scale measurements and the other for body composition measureme ...
asynchronous design in vlsi
asynchronous design in vlsi

... receiver then he send us a acknowledgement ,then we send second request to receiver for which he send us another acknowledgement , therefore it is known as four phase protocol. The request and acknowledgment are implemented by voltage transition on different wires. In this protocol at the end of eve ...
From NDNS - Internet Research Lab
From NDNS - Internet Research Lab

... • All NDN names are applications names – some names are directly routable world-wide (DFZ) – other names are routable just only inside ISP networks ...
M48T129V
M48T129V

... Should the supply voltage decay, the RAM will automatically deselect, write protecting itself when VCC falls between VPFD (max), VPFD (min) window. All outputs become high impedance and all inputs are treated as “Don’t care”. Note: A power failure during a WRITE cycle may corrupt data at the current ...
Chapter 2
Chapter 2

... Multiple TCP connections are multiplexed over same network interface, reducing available R and efficiency For multi-hop connections, D is the sum of delays across each network plus delays at each router If source data rate R exceeds data rate on one of the hops, that hop will be a bottleneck Lost se ...
Fundamentals of Embedded Software Development Technology
Fundamentals of Embedded Software Development Technology

...  Usually vendors of ZigBee devices use system-on-chip (SoC) solutions with integrated radio and 60-250KB of flash memory. ...
3. issues on ip multicast-based push - EECG Toronto
3. issues on ip multicast-based push - EECG Toronto

... calculates the minimum total traffic in Tree (v) given that up to i filters can be placed in Tree (v). When a filter is placed at v it will ensure that only the flows strictly required in the left child tree and the right child tree. If there is no need to put a filter at v, the incoming information ...
Keysight Technologies J
Keysight Technologies J

.pdf
.pdf

... can be very inefficient in a grid environment, where the differences in bandwidth between the sites can be significant and also dynamically changing. In previous work, we have used monitoring information about network bandwidth to construct multicast trees between grid sites [11]. This approach, how ...
Unsupervised Speech Activity Detection Using Voicing Measures
Unsupervised Speech Activity Detection Using Voicing Measures

... for evaluations. However, our system has the potential to be adapted for automatic speech applications such as speaker and language identification, with no or minimal modifications. Fig. 3 illustrates the SNR differences between the two data corpora used in our evaluations. It can be seen that RATS ...
LoRa® ® FAQs
LoRa® ® FAQs

Slide 1 - CLASSE Cornell
Slide 1 - CLASSE Cornell

... amplitude. • We have also shown that there is a tune shift that is dependent on the driving amplitude. • We have also shown that these effects can be detected in the signal from the particle accelerator. ...
DS1859 Dual, Temperature-Controlled Resistors with Internally Calibrated Monitors General Description
DS1859 Dual, Temperature-Controlled Resistors with Internally Calibrated Monitors General Description

... Each signal (VCC, MON1, MON2, MON3, and temperature) is available as a 16-bit value with 12-bit accuracy (left-justified) over the serial bus. See Table 1 for signal scales and Table 2 for signal format. The four LSBs should be masked when calculating the value. ...
Treatment of horizontal and vertical tidal signals in GPS data
Treatment of horizontal and vertical tidal signals in GPS data

... signal and large horizontal motions in the data. Over a one hour period, vertical and horizontal movements can be as much as 0.3 metres and 0.1 metres respectively. For such GPS data to be processed using conventional static methods would require the observation period to be split into small (∼1 hou ...
$doc.title

... The values for the equation are found in the maximum ratings table on the data sheet. Substituting these values into the equation for an ambient temperature TA of 25°C, one can calculate the power dissipation of the device which in this case is 225 milliwatts. PD = ...
daaac 4.0 - Voss Scientific
daaac 4.0 - Voss Scientific

... • Once a system is set up, its configuration can be saved with a user supplied name • Convenient for saving standard test setups • Records system setup independently of data • May be restored at will in standalone mode • May be edited and deleted ...
CS244a: An Introduction to Computer Networks
CS244a: An Introduction to Computer Networks

... – Partition a physical LAN into several “logically separate” LANs • reduce broadcast traffic on physical LAN! • provide administrative isolation ...
Speed control of permanent magnet synchronous motor using FPGA
Speed control of permanent magnet synchronous motor using FPGA

... A high-performance motor control system requires a high response system and recovery to steady state condition immediately when a motor is loaded and influenced by any disturbances. To achieve it, the high frequency PWM is needed so the speed control system using FPGA with SiC inverter is proposed. ...
RED72 - Coulton Instrumentation Ltd
RED72 - Coulton Instrumentation Ltd

DS1339B Low-Current, I C, Serial Real-Time Clock For High-ESR Crystals
DS1339B Low-Current, I C, Serial Real-Time Clock For High-ESR Crystals

... Note 13: CB—total capacitance of one bus line in pF. Note 14: Guaranteed by design; not production tested. Note 15: The parameter tOSF is the period of time the oscillator must be stopped for the OSF flag to be set. Note 16: The device can detect any single SCL clock held low longer than tTIMEOUTMIN ...
8-Channel, 24-Bit Analog-To-Digital Converter (Rev. C)
8-Channel, 24-Bit Analog-To-Digital Converter (Rev. C)

... can be selected to provide a very high input impedance for direct connection to transducers or low-level voltage signals. Burnout current sources are provided that allow for the detection of an open or shorted sensor. An 8-bit Digital-toAnalog Converter (DAC) provides an offset correction with a ran ...
NorthStar Controller—Multilayer SDN Coordination and Optimization
NorthStar Controller—Multilayer SDN Coordination and Optimization

... The first question to consider is whether to use centralized versus distributed multilayer coordination. In the past, multilayer coordination focused mostly on Generalized MPLS (GMPLS) [1] control planes in the transport and IP/MPLS network layers. GMPLS also provides a distributed control plane for ...
Flow Configuration Document and Submission Guide
Flow Configuration Document and Submission Guide

... (BEACH Act). The Act amended the Federal Water Pollution Control Act with the purpose of improving the quality of coastal recreation waters. Each year following the passage of the Act, EPA has awarded grants to coastal states for the purpose of increasing monitoring and notification activities at co ...
< 1 ... 40 41 42 43 44 45 46 47 48 ... 258 >

UniPro protocol stack

In mobile-telephone technology, the UniPro protocol stack follows the architecture of the classical OSI Reference Model. In UniPro, the OSI Physical Layer is split into two sublayers: Layer 1 (the actual physical layer) and Layer 1.5 (the PHY Adapter layer) which abstracts from differences between alternative Layer 1 technologies. The actual physical layer is a separate specification as the various PHY options are reused in other MIPI Alliance specifications.The UniPro specification itself covers Layers 1.5, 2, 3, 4 and the DME (Device Management Entity). The Application Layer (LA) is out of scope because different uses of UniPro will require different LA protocols. The Physical Layer (L1) is covered in separate MIPI specifications in order to allow the PHY to be reused by other (less generic) protocols if needed.OSI Layers 5 (Session) and 6 (Presentation) are, where applicable, counted as part of the Application Layer.
  • studyres.com © 2025
  • DMCA
  • Privacy
  • Terms
  • Report