OAI Emulation Platform
... emulation and real-time RF platforms. At the access layer, it implements the MAC (medium access control), RLC (radio link control), PDCP (packet data convergence protocol), RRC (radio resource control) layers as well as full or abstracted PHY layer. It also provides an IPv4/IPv6 network device inter ...
... emulation and real-time RF platforms. At the access layer, it implements the MAC (medium access control), RLC (radio link control), PDCP (packet data convergence protocol), RRC (radio resource control) layers as well as full or abstracted PHY layer. It also provides an IPv4/IPv6 network device inter ...
SPAIN: COTS Data-Center Ethernet for Multipathing over Arbitrary Topologies
... new problems, especially the difficulty of supporting dynamic mobility of virtual machines: the lack of a single flat address space makes it much harder to move a VM between subnets. Also, the use of IP routers instead of Ethernet switches can increase hardware costs and complicate network managemen ...
... new problems, especially the difficulty of supporting dynamic mobility of virtual machines: the lack of a single flat address space makes it much harder to move a VM between subnets. Also, the use of IP routers instead of Ethernet switches can increase hardware costs and complicate network managemen ...
Digital Communications I - Cambridge Computer Laboratory
... channels with any signal have nonzero information capacity fidelity of the channel usually measured as a bit error rate — the probability that a bit sent as a 1 was interpreted as a 0 by the receiver or vice versa. ...
... channels with any signal have nonzero information capacity fidelity of the channel usually measured as a bit error rate — the probability that a bit sent as a 1 was interpreted as a 0 by the receiver or vice versa. ...
23.22
... Context activation and registration .................................................................................................................. 34 Location management............................................................................................................................... ...
... Context activation and registration .................................................................................................................. 34 Location management............................................................................................................................... ...
Achieving WAN Operational Efficiency with the Cisco ASR 1000 Series
... concurrent services in mind, and they provide a higher degree of service integration and consistency than multiple independent devices ...
... concurrent services in mind, and they provide a higher degree of service integration and consistency than multiple independent devices ...
Slides
... mechanism, with one end opened for reading and the other end for writing. pipe() system call is used to create a readwrite pipe that may later be used to communicate with a forked off process. An array of 2 integers as the argument that will be used to save the two file descriptors used to acces ...
... mechanism, with one end opened for reading and the other end for writing. pipe() system call is used to create a readwrite pipe that may later be used to communicate with a forked off process. An array of 2 integers as the argument that will be used to save the two file descriptors used to acces ...
Multimedia Streaming File
... RTP packets are encapsulated in UDP segments Interoperability: If two Internet phone applications run RTP, then they may be able to work together ...
... RTP packets are encapsulated in UDP segments Interoperability: If two Internet phone applications run RTP, then they may be able to work together ...
Novell IPX
... • It is used exclusively in a client/server environment. • It uses the network.node IPX addressing structure. • Its logical address contains an interface MAC address. • IPX interface configuration supports multiple datalink encapsulations (to support outdated IOS applications). • Novell RIP uses the ...
... • It is used exclusively in a client/server environment. • It uses the network.node IPX addressing structure. • Its logical address contains an interface MAC address. • IPX interface configuration supports multiple datalink encapsulations (to support outdated IOS applications). • Novell RIP uses the ...
Document
... – Supporting route aggregation (summarization), also known as supernetting, where thousands of routes could be represented by a single route in the routing table. • Route aggregation also helps prevent route flapping on Internet routers using BGP. Flapping routes can be a serious concern with Intern ...
... – Supporting route aggregation (summarization), also known as supernetting, where thousands of routes could be represented by a single route in the routing table. • Route aggregation also helps prevent route flapping on Internet routers using BGP. Flapping routes can be a serious concern with Intern ...
Chapter 5 - Professor Dan Web
... point-to-point PPP for dial-up access point-to-point link between Ethernet switch and host broadcast (shared wire or medium) Old-fashioned Ethernet upstream HFC 802.11 wireless LAN ...
... point-to-point PPP for dial-up access point-to-point link between Ethernet switch and host broadcast (shared wire or medium) Old-fashioned Ethernet upstream HFC 802.11 wireless LAN ...
Wireless Sensor Networks: Technology Roadmap
... the network of air defense radars to defend its territory, which now is also used for drug interdiction. Research on sensor networks started around 1980 with the Distributed Sensor Networks (DSN) program at DARPA (Defense Advanced Research Projects Agency) where Arpanet (predecessor of the Internet) ...
... the network of air defense radars to defend its territory, which now is also used for drug interdiction. Research on sensor networks started around 1980 with the Distributed Sensor Networks (DSN) program at DARPA (Defense Advanced Research Projects Agency) where Arpanet (predecessor of the Internet) ...
3rd Edition, Chapter 5
... point-to-point PPP for dial-up access point-to-point link between Ethernet switch and host broadcast (shared wire or medium) Old-fashioned Ethernet upstream HFC 802.11 wireless LAN ...
... point-to-point PPP for dial-up access point-to-point link between Ethernet switch and host broadcast (shared wire or medium) Old-fashioned Ethernet upstream HFC 802.11 wireless LAN ...
AS/CA S003.1:2010 - Communications Alliance
... Standards. This Standard is the result of a consensus among representatives on the Communications Alliance Working Committee to produce it as an Australian Standard. The designation of this Standard has been changed from AS/ACIF to AS/CA to reflect that the Standard has been published by Communicati ...
... Standards. This Standard is the result of a consensus among representatives on the Communications Alliance Working Committee to produce it as an Australian Standard. The designation of this Standard has been changed from AS/ACIF to AS/CA to reflect that the Standard has been published by Communicati ...
Shortest Path Bridging
... utilization, it was necessary to set the maximum available bandwidth for this new traffic class quite high (75%) • Therefore the Credit Based Shaper (CBS) was introduced • The CBS spaces out the frames as much as possible in order to reduce bursting and bunching ...
... utilization, it was necessary to set the maximum available bandwidth for this new traffic class quite high (75%) • Therefore the Credit Based Shaper (CBS) was introduced • The CBS spaces out the frames as much as possible in order to reduce bursting and bunching ...
Personal Area Networks: Bluetooth or IEEE 802.11? | SpringerLink
... • Four-way handshake: The sending node sends a request-to-send (RTS) packet to the receiving terminal. If the receiver accepts the request, it replies with a clear-to-send (CTS) packet. If no collisions have occurred, the sender then begins transmitting its data. • The sender immediately begins send ...
... • Four-way handshake: The sending node sends a request-to-send (RTS) packet to the receiving terminal. If the receiver accepts the request, it replies with a clear-to-send (CTS) packet. If no collisions have occurred, the sender then begins transmitting its data. • The sender immediately begins send ...
MPLS QoS - Lyle School of Engineering
... • 6 bits used for Differentiated Service Code Point (DSCP) and determine PHB that the packet will receive • 2 bits are currently unused ...
... • 6 bits used for Differentiated Service Code Point (DSCP) and determine PHB that the packet will receive • 2 bits are currently unused ...
A Survey of BGP Security Issues and Solutions
... hijacked destinations; the malicious AS can then analyze the traffic these hosts receive, possibly receiving sensitive information such as passwords and credit-card numbers. In some cases, prefix hijacking can be used to perform an interception attack, where the AS inspects the packets (compromising ...
... hijacked destinations; the malicious AS can then analyze the traffic these hosts receive, possibly receiving sensitive information such as passwords and credit-card numbers. In some cases, prefix hijacking can be used to perform an interception attack, where the AS inspects the packets (compromising ...
PDF
... maintenance level for VLAN IDs that are not associated with specific maintenance associations (MAs). You can also use this command to enable level filtering. – id—Configures a maintenance domain identifier (MDID). – level—Configures a maintenance level to receive Alarm Indication Signal (AIS) frames ...
... maintenance level for VLAN IDs that are not associated with specific maintenance associations (MAs). You can also use this command to enable level filtering. – id—Configures a maintenance domain identifier (MDID). – level—Configures a maintenance level to receive Alarm Indication Signal (AIS) frames ...
21-04-0164-01-0000-Freescale
... nominal beacon intervals, etc. Some of these may be normalized w/ application or service Not every element may be available or appropriate for reporting across all network types – some basic set will be mandatory, others may be service engine specific and optional ...
... nominal beacon intervals, etc. Some of these may be normalized w/ application or service Not every element may be available or appropriate for reporting across all network types – some basic set will be mandatory, others may be service engine specific and optional ...
Description
... The purchased products, services and features are stipulated by the contract made between Huawei and the customer. All or part of the products, services and features described in this document may not be within the purchase scope or the usage scope. Unless otherwise specified in the contract, all st ...
... The purchased products, services and features are stipulated by the contract made between Huawei and the customer. All or part of the products, services and features described in this document may not be within the purchase scope or the usage scope. Unless otherwise specified in the contract, all st ...