UPS SYSTEM Communication Manual Network Interface Card
... Cable for connection with the ETHERNET Network ......................................................................................... 2-1 Cable length from floor to connection point in the equipment ....................................................................... 2-1 Installing the NIC car ...
... Cable for connection with the ETHERNET Network ......................................................................................... 2-1 Cable length from floor to connection point in the equipment ....................................................................... 2-1 Installing the NIC car ...
LM2599 SIMPLE SWITCHER Power Converter 150 kHz 3A Step
... located close to the IC using short capacitor leads and short copper traces. Do not use capacitors larger than 820 µF. For additional information, see section on output capacitors in application information section. B. To simplify the capacitor selection procedure, refer to the quick design componen ...
... located close to the IC using short capacitor leads and short copper traces. Do not use capacitors larger than 820 µF. For additional information, see section on output capacitors in application information section. B. To simplify the capacitor selection procedure, refer to the quick design componen ...
MAX16054 On/Off Controller with Debounce and ±15kV ESD Protection General Description
... On/Off Controller with Debounce and ±15kV ESD Protection The MAX16054 is a pushbutton on/off controller with a single switch debouncer and built-in latch. It accepts a noisy input from a mechanical switch and produces a clean latched digital output after a factory-fixed qualification delay. The MAX1 ...
... On/Off Controller with Debounce and ±15kV ESD Protection The MAX16054 is a pushbutton on/off controller with a single switch debouncer and built-in latch. It accepts a noisy input from a mechanical switch and produces a clean latched digital output after a factory-fixed qualification delay. The MAX1 ...
74LVT241 1. General description 3.3 V octal buffer/line driver; 3-state
... This is the bus hold overdrive current required to force the input to the opposite logic state. ...
... This is the bus hold overdrive current required to force the input to the opposite logic state. ...
APN1015: A Dual-Band Switchable IF VCO for GSM/PCS Handsets
... reactance portion of the overall tank circuit. This has significant impact on VCO performance, especially if more than 10% of the switching gap (the difference between designated frequency bands) is required. ...
... reactance portion of the overall tank circuit. This has significant impact on VCO performance, especially if more than 10% of the switching gap (the difference between designated frequency bands) is required. ...
OPERATIONAL AMPLIFIERS: BASIC CONCEPTS and COOKBOOK
... For example often the textbook starts with a difficult and discouraging introduction on transistors. The transistor is indeed the basic element in any IC, but learning its working principle is not necessary for learning IC. In the modern analog electronic circuits, on the other hand, the basic build ...
... For example often the textbook starts with a difficult and discouraging introduction on transistors. The transistor is indeed the basic element in any IC, but learning its working principle is not necessary for learning IC. In the modern analog electronic circuits, on the other hand, the basic build ...
tl7705 - supply voltage supervisors
... NC – No internal connection delay after which outputs RESET and RESET go inactive (high and low respectively). When an undervoltage condition occurs during normal operation, outputs RESET and RESET go active. To ensure that a complete reset occurs, the reset outputs remain active for a time delay af ...
... NC – No internal connection delay after which outputs RESET and RESET go inactive (high and low respectively). When an undervoltage condition occurs during normal operation, outputs RESET and RESET go active. To ensure that a complete reset occurs, the reset outputs remain active for a time delay af ...
MAX9742 Single-/Dual-Supply, Stereo 16W, Class D Amplifier with Differential Inputs General Description
... OUTL to VDD.......................................................-45V to +0.3V REGLS to VSS .........................................................-0.3V to +12V MID to REGP, REGM...............(VREGM - 0.3V) to (VREGP + 0.3V) REGP to REGM.......................................................-0.3 ...
... OUTL to VDD.......................................................-45V to +0.3V REGLS to VSS .........................................................-0.3V to +12V MID to REGP, REGM...............(VREGM - 0.3V) to (VREGP + 0.3V) REGP to REGM.......................................................-0.3 ...
Institutionen för systemteknik technology Department of Electrical Engineering
... Addition is one of the critical and fundamental binary logic operations carried in digital circuits. Most electronic devices such as mobile phones, personal computers and tablet PCs, which are equipped with microprocessors contain Arithmetic and Logic Units (ALU). Being part of ALU, addition circuit ...
... Addition is one of the critical and fundamental binary logic operations carried in digital circuits. Most electronic devices such as mobile phones, personal computers and tablet PCs, which are equipped with microprocessors contain Arithmetic and Logic Units (ALU). Being part of ALU, addition circuit ...
PowerPoint
... One nice property of the cascode stage can be discovered looking at the resistance seen in the drain of T2. Rout ...
... One nice property of the cascode stage can be discovered looking at the resistance seen in the drain of T2. Rout ...
... 3.5 Electrical test requirements. The electrical test requirements shall be the subgroups specified in table II. The electrical tests for each subgroup are defined in table I. 3.6 Marking. The part shall be marked with the PIN listed in 1.2 herein. In addition, the manufacturer’s PIN may also be mar ...
- SlideBoom
... simulation and verify the simulated results are the same as the calculated values. Were the values the same? Yes/No. If no, why? 3.Construct the circuit above on the breadboard. Connect the circuit’s input to the power supply and set it to +10 V. Use the handheld DMM to adjust the supply to +10 V. U ...
... simulation and verify the simulated results are the same as the calculated values. Were the values the same? Yes/No. If no, why? 3.Construct the circuit above on the breadboard. Connect the circuit’s input to the power supply and set it to +10 V. Use the handheld DMM to adjust the supply to +10 V. U ...
P82478
... The AMT Multitone Strobe Appliance are UL Listed under Standard 1971 for Emergency Appliances for the Hearing Impaired and UL Standard 464 for Audible Appliances. They are listed for indoor use only with the backboxes specified in these instructions (See Mounting Options). Models with LS and IS stro ...
... The AMT Multitone Strobe Appliance are UL Listed under Standard 1971 for Emergency Appliances for the Hearing Impaired and UL Standard 464 for Audible Appliances. They are listed for indoor use only with the backboxes specified in these instructions (See Mounting Options). Models with LS and IS stro ...
The American University in Cairo School of Science and Engineering
... amplifier topologies are introduced. Then, some operational amplifiers topologies are introduced with some techniques to self bias these amplifiers. The folded cascode fully differential Op-Amp with self bias is presented. This is one of the newest amplifier topologies which provide stable self-bias ...
... amplifier topologies are introduced. Then, some operational amplifiers topologies are introduced with some techniques to self bias these amplifiers. The folded cascode fully differential Op-Amp with self bias is presented. This is one of the newest amplifier topologies which provide stable self-bias ...
MAX17019 High-Input-Voltage Quad-Output Controller General Description Features
... low-cost controller capable of providing four independent regulators—a main stage, a 3AP-P internal stepdown, a 5AP-P internal step-down, and a 2A source/sink linear regulator. The input voltage is up to 38V. This makes it an excellent choice for automotive applications. The internal switching regul ...
... low-cost controller capable of providing four independent regulators—a main stage, a 3AP-P internal stepdown, a 5AP-P internal step-down, and a 2A source/sink linear regulator. The input voltage is up to 38V. This makes it an excellent choice for automotive applications. The internal switching regul ...
