![Transmission at 200 Mbps in VME Card Cage](http://s1.studyres.com/store/data/005374523_1-9c27de73c94b622d51ecb9dc4a7ec0ce-300x300.png)
Transmission at 200 Mbps in VME Card Cage
... floating line on either side of the signal pair. For comparison, data were also collected (not presented here) on a channel at the edge of the backplane. It was found that at the edge of the backplane, the crosstalk was reduced, as evidenced by improved BERT results and a more open eye pattern. To p ...
... floating line on either side of the signal pair. For comparison, data were also collected (not presented here) on a channel at the edge of the backplane. It was found that at the edge of the backplane, the crosstalk was reduced, as evidenced by improved BERT results and a more open eye pattern. To p ...
... With the engine off and the Master switch on. Pins I, A, and S should measure Battery voltage, pin F should be 0.5 to 2V less the bus voltage. • If the measured voltage is different, see The voltages on pins I, A, S should equal bus’ on page 3 for probable causes for the problem. • If the pin F volt ...
幻灯片 1
... protection circuit from ATX) 2. Check PSON # whether there is action, if the action properly, check the graphics card protection circuit is working properly. 3. PSON # if no action is issued by the South Bridge SLP_S3 # Check whether there is normally issued, if OK, replace the ASUS chip. 4. If SLP_ ...
... protection circuit from ATX) 2. Check PSON # whether there is action, if the action properly, check the graphics card protection circuit is working properly. 3. PSON # if no action is issued by the South Bridge SLP_S3 # Check whether there is normally issued, if OK, replace the ASUS chip. 4. If SLP_ ...
Asus mainboard Advanced Maintenance
... protection circuit from ATX) 2. Check PSON # whether there is action, if the action properly, check the graphics card protection circuit is working properly. 3. PSON # if no action is issued by the South Bridge SLP_S3 # Check whether there is normally issued, if OK, replace the ASUS chip. 4. If SLP_ ...
... protection circuit from ATX) 2. Check PSON # whether there is action, if the action properly, check the graphics card protection circuit is working properly. 3. PSON # if no action is issued by the South Bridge SLP_S3 # Check whether there is normally issued, if OK, replace the ASUS chip. 4. If SLP_ ...
Open Multi-Core Router
... BFD: Bidirectional Forwarding Detection (IETF standard) is a technology of fast detecting node and link faults. The handshake time is 10ms by default and can be configured. BFD provides light-load, short-time detection. It can be used to provide real-time detection of any media and any protocol laye ...
... BFD: Bidirectional Forwarding Detection (IETF standard) is a technology of fast detecting node and link faults. The handshake time is 10ms by default and can be configured. BFD provides light-load, short-time detection. It can be used to provide real-time detection of any media and any protocol laye ...
AFDX for Airplanes
... Also based on the DS4504 is dSPACE’s 100-Mbit/s Ethernet Solution. The new 100-Mbit/s Ethernet Solution enables you to transmit data between dSPACE processor boards (DS1005, DS1006, or multiprocessor system) and a remote computer system. The UDP/IP and TCP/IP protocols are supported. Data transmissi ...
... Also based on the DS4504 is dSPACE’s 100-Mbit/s Ethernet Solution. The new 100-Mbit/s Ethernet Solution enables you to transmit data between dSPACE processor boards (DS1005, DS1006, or multiprocessor system) and a remote computer system. The UDP/IP and TCP/IP protocols are supported. Data transmissi ...
EEE449 Computer Networks
... start of the frame and enables the receiver to locate the first bit of the rest of the frame. Destination Address (DA): Specifies the station(s) for which the frame is intended. It may be a unique physical address, a group address, or a global address. Source Address (SA): Specifies the station that ...
... start of the frame and enables the receiver to locate the first bit of the rest of the frame. Destination Address (DA): Specifies the station(s) for which the frame is intended. It may be a unique physical address, a group address, or a global address. Source Address (SA): Specifies the station that ...
SNx5HVD308xE Low-Power RS-485
... The wide common-mode range and high ESDprotection levels of these devices makes them suitable for demanding applications such as energy meter networks, electrical inverters, status and command signals across telecom racks, cabled chassis interconnects, and industrial automation networks where noise ...
... The wide common-mode range and high ESDprotection levels of these devices makes them suitable for demanding applications such as energy meter networks, electrical inverters, status and command signals across telecom racks, cabled chassis interconnects, and industrial automation networks where noise ...
UCC5628 数据资料 dataSheet 下载
... The diff sense signal is a three level signal, which is driven at each end of the bus by one active terminator. A LVD or multimode terminator drives the diff sense line to 1.3 V. If diff sense is at 1.3 V, then bus is in LVD mode. If a single ended SCSI device is plugged into the bus, the diff sense ...
... The diff sense signal is a three level signal, which is driven at each end of the bus by one active terminator. A LVD or multimode terminator drives the diff sense line to 1.3 V. If diff sense is at 1.3 V, then bus is in LVD mode. If a single ended SCSI device is plugged into the bus, the diff sense ...
computer capsule for sbi po/clerk mains -2016
... storage capacity compared to main memory. The hard disk is usually contained inside the case of a computer. Read-only memory (ROM) is a storage medium used in computers and other electronic devices. Data stored in ROM can only be modified slowly or with difficulty, or not at all. ROM is non-volatile ...
... storage capacity compared to main memory. The hard disk is usually contained inside the case of a computer. Read-only memory (ROM) is a storage medium used in computers and other electronic devices. Data stored in ROM can only be modified slowly or with difficulty, or not at all. ROM is non-volatile ...
PCA9508 Hot swappable level translating I2C
... The size of these pull-up resistors depends on the system, but each side of the repeater must have a pull-up resistor. This part designed to work with Standard-mode and Fast-mode I2C-bus devices in addition to SMBus devices. Standard-mode I2C-bus devices only specify 3 mA output drive; this limits t ...
... The size of these pull-up resistors depends on the system, but each side of the repeater must have a pull-up resistor. This part designed to work with Standard-mode and Fast-mode I2C-bus devices in addition to SMBus devices. Standard-mode I2C-bus devices only specify 3 mA output drive; this limits t ...
ITE_PC_v40_Chapter1
... Parallel ports can transmit 8 bits of data at one time and use the IEEE 1284 standard. To connect a parallel device, such as a printer, a parallel cable must be used. A parallel cable has a maximum length of 15 feet (4.5 m). ...
... Parallel ports can transmit 8 bits of data at one time and use the IEEE 1284 standard. To connect a parallel device, such as a printer, a parallel cable must be used. A parallel cable has a maximum length of 15 feet (4.5 m). ...
CALCULATION OF TMS320LC54x POWER DISSIPATION
... is the switching frequency of the device clock Since knowing the number and capacitance of all of the internal switching nodes is an unmanageable task, the current under different conditions can be determined empirically by measuring the current level for a particular algorithm under known frequency ...
... is the switching frequency of the device clock Since knowing the number and capacitance of all of the internal switching nodes is an unmanageable task, the current under different conditions can be determined empirically by measuring the current level for a particular algorithm under known frequency ...
MAX9129 Quad Bus LVDS Driver with Flow-Through Pinout General Description
... ZDIFF-loaded = 54Ω In this example, capacitive loading reduces the characteristic impedance from 120Ω to 54Ω. The load seen by a driver located on a card in the middle of the bus is 27Ω because the driver sees two 54Ω loads in parallel. A typical LVDS driver (rated for a 100Ω load) would not develop ...
... ZDIFF-loaded = 54Ω In this example, capacitive loading reduces the characteristic impedance from 120Ω to 54Ω. The load seen by a driver located on a card in the middle of the bus is 27Ω because the driver sees two 54Ω loads in parallel. A typical LVDS driver (rated for a 100Ω load) would not develop ...
CS61C - Lecture 13
... °Disk Latency = Seek Time + Rotation Time + Transfer Time + Controller Overhead ° Seek Time? depends no. tracks move arm, seek speed of disk ° Rotation Time? depends on speed disk rotates, how far sector is from head ...
... °Disk Latency = Seek Time + Rotation Time + Transfer Time + Controller Overhead ° Seek Time? depends no. tracks move arm, seek speed of disk ° Rotation Time? depends on speed disk rotates, how far sector is from head ...
Chapter_01 - La Sierra University
... of a computer to increase overall performance by an amount proportional to the size of the improvement. The idea of making the common case fast reminds us that the opportunity for improvement is affected by how much time the event consumes. ...
... of a computer to increase overall performance by an amount proportional to the size of the improvement. The idea of making the common case fast reminds us that the opportunity for improvement is affected by how much time the event consumes. ...
IOSR Journal of Electronics and Communication Engineering (IOSR-JECE)
... standardized by ISO. In automotive industry has adventure to various electronic control systems that have been developed in pursuit of safety, comfort, pollution prevention and low cost.CAN was first developed by Robert Bosch GmbH, Germany in 1986 when they were requested to develop a Communication ...
... standardized by ISO. In automotive industry has adventure to various electronic control systems that have been developed in pursuit of safety, comfort, pollution prevention and low cost.CAN was first developed by Robert Bosch GmbH, Germany in 1986 when they were requested to develop a Communication ...
Multiprocessor and Distributed Systems
... Shared-Memory Multiprocessor • All processors can access all memory • Some memory may be faster than other memory ...
... Shared-Memory Multiprocessor • All processors can access all memory • Some memory may be faster than other memory ...
DC 16-Circuit Sink and Source I/O Blocks
... An isolation or blocking diode is incorporated into the Terminal Assembly for every point on these blocks. These internal diodes make it unnecessary to add external diodes in series with outputs, to perform the same blocking/isolation function. ...
... An isolation or blocking diode is incorporated into the Terminal Assembly for every point on these blocks. These internal diodes make it unnecessary to add external diodes in series with outputs, to perform the same blocking/isolation function. ...
DC 32-Circuit Source/Sink I/O Blocks
... If the output is commanded to go on and current exceeds 5 Amps for 1 ms, the circuit is automatically turned off and the FAILED SWITCH message issued. The circuit must be reset by cycling power to the block, or by sending a CLEAR FAULTS command from the Hand-held Monitor or the Bus Controller. Surge ...
... If the output is commanded to go on and current exceeds 5 Amps for 1 ms, the circuit is automatically turned off and the FAILED SWITCH message issued. The circuit must be reset by cycling power to the block, or by sending a CLEAR FAULTS command from the Hand-held Monitor or the Bus Controller. Surge ...
Dr. Amr Talaat ELECT1002 SoC Design
... • Dedicated path, or circuit, is established over which data packets will travel • Naturally lends itself to time-sensitive guaranteed service due to ...
... • Dedicated path, or circuit, is established over which data packets will travel • Naturally lends itself to time-sensitive guaranteed service due to ...
TLE7259-3 - Infineon Technologies
... The TLE7259-3 is a transceiver for the Local Interconnect Network (LIN) with integrated wake-up and protection features. It is designed for in-vehicle networks using data transmission rates from 2.4 kbps to 20 kbps. The TLE7259-3 operate as a bus driver between the protocol controller and the physic ...
... The TLE7259-3 is a transceiver for the Local Interconnect Network (LIN) with integrated wake-up and protection features. It is designed for in-vehicle networks using data transmission rates from 2.4 kbps to 20 kbps. The TLE7259-3 operate as a bus driver between the protocol controller and the physic ...
DS1821 Programmable Digital Thermostat and Thermometer FEATURES PIN ASSIGNMENT
... is configured as a 1-Wire port for communication with a microprocessor using the protocols described in the 1-Wire BUS SYSTEM section of this datasheet. These communications can include reading and writing the high and low thermostat trip-point registers (TH and TL) and the configuration register, a ...
... is configured as a 1-Wire port for communication with a microprocessor using the protocols described in the 1-Wire BUS SYSTEM section of this datasheet. These communications can include reading and writing the high and low thermostat trip-point registers (TH and TL) and the configuration register, a ...
TLE7259-2GE
... The TLE7259-2GE is a transceiver for the Local Interconnect Network (LIN) with integrated Wake-Up and protection features. It is designed for in-vehicle networks using data transmission rates from 2.4 kBaud to 20 kBaud. The TLE7259-2GE functions as a bus driver between the protocol controller and th ...
... The TLE7259-2GE is a transceiver for the Local Interconnect Network (LIN) with integrated Wake-Up and protection features. It is designed for in-vehicle networks using data transmission rates from 2.4 kBaud to 20 kBaud. The TLE7259-2GE functions as a bus driver between the protocol controller and th ...
c164cmsm_ds.pdf
... approval of Infineon Technologies, if a failure of such components can reasonably be expected to cause the failure of that life-support device or system, or to affect the safety or effectiveness of that device or system. Life support devices or systems are intended to be implanted in the human body, ...
... approval of Infineon Technologies, if a failure of such components can reasonably be expected to cause the failure of that life-support device or system, or to affect the safety or effectiveness of that device or system. Life support devices or systems are intended to be implanted in the human body, ...
Bus (computing)
![](https://commons.wikimedia.org/wiki/Special:FilePath/PCIExpress.jpg?width=300)
In computer architecture, a bus (related to the Latin ""omnibus"", meaning ""for all"") is a communication system that transfers data between components inside a computer, or between computers. This expression covers all related hardware components (wire, optical fiber, etc.) and software, including communication protocols.Early computer buses were parallel electrical wires with multiple connections, but the term is now used for any physical arrangement that provides the same logical functionality as a parallel electrical bus. Modern computer buses can use both parallel and bit serial connections, and can be wired in either a multidrop (electrical parallel) or daisy chain topology, or connected by switched hubs, as in the case of USB.