Download LCD_WM2 - VideoMountStore.com

LCD-WM2
Lay out all your parts and match them to the parts list.
For the purposes of this parts list all LCD-WM2 part numbers will be numbered
normally (1, 2, 3, … etc) while all LCD-1 part number will have an A following their part
number (1A, 2A, 3A, …etc). Also for the purpose of these instructions it is assumed you
have already assembled the LCD-1, but have not attached the arm (2A or 8A) to the wall
plate (1A)
First mark wall or desired mounting surface in preparation of installation of the
wall plate (1) to desired surface. Pre drill if necessary and mount wall plate (1) to desired
surface.
Note: For the previous step it is important to attach the brackets to a solid surface (i.e.
wall plate, double wall studs, concrete or other support system) that will support the
weight of your TV and mount.
Next take the connector support (2) and secure it to the wall plate using the two
M6 screws (3). Now take the arms of the LCD-1s (2A or 8A) and use the 3/8” screw
(17A) to bolt the arm into the “U” connectors on the connector support (2).
Next is to determine what VESA pattern your TV follows. If it is VESA 75mm
(about 3 inches) use mounting plate B (5BA) and if it is VESA 100mm use mounting
plate A (5AA). Bolt the correct mounting plate to the swivel bracket (4A) using the M6
screw (12A) and nylon nut (13A). Next use the correct size screws (M4 or M5 (19A or
20A) depending on the size of the mounting holes on the back of your TV) to screw your
TV to the correct mounting plate (5AA or 5BA).
Please verify all nuts and screws and securely and completely fastened
Enjoy your mount