Download Analyzing Circuits

Survey
yes no Was this document useful for you?
   Thank you for your participation!

* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project

Document related concepts

Nanofluidic circuitry wikipedia , lookup

Printed circuit board wikipedia , lookup

Multimeter wikipedia , lookup

Surge protector wikipedia , lookup

Operational amplifier wikipedia , lookup

Index of electronics articles wikipedia , lookup

Valve RF amplifier wikipedia , lookup

Power MOSFET wikipedia , lookup

Ohm's law wikipedia , lookup

Flexible electronics wikipedia , lookup

TRIAC wikipedia , lookup

Regenerative circuit wikipedia , lookup

Resistive opto-isolator wikipedia , lookup

Rectiverter wikipedia , lookup

Two-port network wikipedia , lookup

Opto-isolator wikipedia , lookup

Integrated circuit wikipedia , lookup

Current mirror wikipedia , lookup

Current source wikipedia , lookup

Surface-mount technology wikipedia , lookup

RLC circuit wikipedia , lookup

Network analysis (electrical circuits) wikipedia , lookup

Transcript
Analyzing Circuits
{
Ass. Statements 5.2.1 – 5.2.8 due Wed., Dec. 11
Quiz on Topic 5 (electric circuit analysis) on Wed., Dec. 11

On your whiteboards, sketch each of the following:



A. A circuit with 3 resistors in series with a 12 V cell.
B. A circuit with 3 resistors in parallel with a 6.0 V cell.
C. A circuit with a single resistor in series with 2 resistors
that are in parallel with a 9.0 V cell.
Review

The total potential supplied by the source must
be “used up” by the components of the circuit.

The sum of the potential drops across each
component in a series circuit will be equal to
the total potential supplied by the source

The electrons going through parallel branches
will each experience the same drop in potential
by the time they meet up again in the main
circuit
Kirchoff’s Voltage Rule


The total current passing through a circuit
depends on the total resistance. Current
leaving the potential source is the same as the
current entering the potential source (it’s not
“used up”)
Current must pass equally through all
components in series with each other

When current reaches a junction, it will split.

The sum of the currents entering a junction will
be equal to the sum of the currents exiting a
junction
Kirchoff’s Current Rule