Download INSTALLATION INSTRUCTIONS

NOTICE:
INSTALLATION INSTRUCTIONS
ANY ISSUES WITH INSTALLATION REQUIRES IMMEDIATE CALLS TO
SHAPER
GLASS LENS 4
INNER GLASS 4
For proper installation, have a qualified
electrician install this product.
Before installation of any luminaire onto an
electrical junction box, be sure to disconnect power.
This luminaire must be wired and grounded in
accordance with the National Electrical Code, local
codes, and ordinances.
Wire supply connections must be made with U.L.
approved connectors.
Check that luminaire voltage and building voltage
are the same.
OR
340-LED
CAUTION:
REFLECTOR 1
GLASS TRIM 2
REFLECTOR ASSEMBLY 5
FLANGED CLIP 3
EXERCISE SPECIAL CARE AND SAFETY WHILE INSTALLING AND
SERVICING LUMINAIRE.
USE OF SOFT GLOVES AND PADDED MATERIALS ARE RECOMMENDED
DURING HANDLING TO AVOID MARRING THE FINISH.
INSTRUCTIONS:
0. Make sure power to fixture is turned off.
1. Follow installation instructions shipped with housings to install housing and
REFLECTOR.
2. Insert GLASS TRIM from bottom of REFLECTOR.
3. Secure GLASS TRIM to REFLECTOR using FLANGED CLIP.
4. Insert either GLASS LENS or INNER GLASS to cover GLASS TRIM.
5. Insert REFLECTOR ASSEMBLY into HOUSING ASSEMBLY.
6. Turn power on to test installation.
HOUSING ASSEMBLY 1
REFLECTOR ASSEMBLY 5
1141 Marina Way South, Richmond, CA 94804 Phone: (510)234-2370 Fax:(510) 234-2371
CLS-11527296
P2
8/8/2011