Download design and construction of an automatic voltage

Survey
yes no Was this document useful for you?
   Thank you for your participation!

* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project

Document related concepts

Immunity-aware programming wikipedia , lookup

Power engineering wikipedia , lookup

Transformer wikipedia , lookup

Pulse-width modulation wikipedia , lookup

Islanding wikipedia , lookup

Electrical ballast wikipedia , lookup

Ohm's law wikipedia , lookup

Power inverter wikipedia , lookup

Variable-frequency drive wikipedia , lookup

Resistive opto-isolator wikipedia , lookup

Electrical substation wikipedia , lookup

Transformer types wikipedia , lookup

Three-phase electric power wikipedia , lookup

Current source wikipedia , lookup

P–n diode wikipedia , lookup

Triode wikipedia , lookup

Power MOSFET wikipedia , lookup

History of electric power transmission wikipedia , lookup

Schmitt trigger wikipedia , lookup

Rectifier wikipedia , lookup

Power electronics wikipedia , lookup

Opto-isolator wikipedia , lookup

Stray voltage wikipedia , lookup

Surge protector wikipedia , lookup

Buck converter wikipedia , lookup

Alternating current wikipedia , lookup

Voltage regulator wikipedia , lookup

Switched-mode power supply wikipedia , lookup

Voltage optimisation wikipedia , lookup

Mains electricity wikipedia , lookup

Transcript
Design And Construction Of An Automatic Voltage
Stabilizer
TABLE OF CONTENTS
Cover Page
Title Page
Approval Page
Dedication
Acknowledgment
Abstract
Table of Contents
CHAPTER ONE
1.0
Introduction
CHAPTER TWO
2.0
Literature Review
2.1
The aims/purpose
2.2
Stages in the development of voltage stabilizer
2.3
Stabilizer grading
2.4
Application
CHAPTER THREE
3.0
Basic Theory of Components Us ed
3.1
Transistors
3.2
Diode
3.3
Resistor
3.4
Relay
3.5
Zener diode
3.6
Capacitor
3.7
Transformer
3.8
Fuse
3.9
Other materials us ed
CHAPTER FOUR
4.0
Design, Construction and Operation of the Stabilizer
4.1
Design/Construction
4.2
The Transformer Stage
4.3
Control Stage
4.4
The Relay Stage
4.5
Operation
4.6
Transformer Stage
4.7
Control Stage
4.8
Relay Stage
CHAPTER FIVE
5.0
Discussion, Conclusion and Recommendation
5.1
Discussion
5.2
Conclusion
5.3
Recommendation
CHAPTER SIX
6.0
Cost Analysis, References
6.1
Cost Analysis
6.2
References
CHAPTER ONE
INTRODUCTION
In Nigeria and some other parts of the world today, the electricity power
supply to consumers (at homes and industries) are not maintained at a
stipulated voltage say 240 volts. But the electronics gadgets and some other
power operated machines, that we use in our homes, offices and industries
requires power with constant or nearly constant voltage for their efficiency, and
to avoid damage by the voltage.
Voltage stabilizer is an electronic control circuit or device that is capable
of providing a constant or nearly constant output voltage even when there is
variation in load or input voltage as low as 90 volt can be boast up to 240 volt
by stabilizer at output stage without any voltage fluctuation.
*** INSTRUCTIONS ***
Please Read The Below Instructions Carefully.
******************************
HOW TO ORDER THIS COMPLETE MATERIAL
If you want to order the complete materials (Chapter One
to Five, Including Abstract, References, Questionnaires, Proposal (where
applicable)) of the above mentioned topic, please visit
www.freeplace.org and click on “Order” (i.e.
www.freeplace.org/order)
******************************
HOW TO BECOME OUR PARTNER
To become our partner, visit www.freeplace.org and click on
partnership.
******************************
TERMS OF USE
This Material is for Academic Research Purposes only. On no
account should you copy this material word for word. Copying
this material “Word for Word” is against our “Terms of Use”.
That you ordered this material shows you have agreed Our
‘Terms of Use’.
******************************
Better is not good enough, the best is yet to come!
Endeavour to be the best!!