Download Henning_Stofen_FRAC_G187

Survey
yes no Was this document useful for you?
   Thank you for your participation!

* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project

Document related concepts

Index of electronics articles wikipedia , lookup

Transistor–transistor logic wikipedia , lookup

Distributed element filter wikipedia , lookup

Crystal radio wikipedia , lookup

Test probe wikipedia , lookup

Audio crossover wikipedia , lookup

Power MOSFET wikipedia , lookup

Power dividers and directional couplers wikipedia , lookup

Operational amplifier wikipedia , lookup

Automatic test equipment wikipedia , lookup

Resistive opto-isolator wikipedia , lookup

Wilson current mirror wikipedia , lookup

Negative-feedback amplifier wikipedia , lookup

Ohm's law wikipedia , lookup

Amplifier wikipedia , lookup

Scattering parameters wikipedia , lookup

Power electronics wikipedia , lookup

Two-port network wikipedia , lookup

Opto-isolator wikipedia , lookup

Tube sound wikipedia , lookup

Audio power wikipedia , lookup

Switched-mode power supply wikipedia , lookup

Rectiverter wikipedia , lookup

Radio transmitter design wikipedia , lookup

PS Audio wikipedia , lookup

Antenna tuner wikipedia , lookup

Standing wave ratio wikipedia , lookup

Valve RF amplifier wikipedia , lookup

Zobel network wikipedia , lookup

Impedance matching wikipedia , lookup

Transcript
RTCA SC-135 and EUROCAE WG-14
Change Proposal Form
(One major comment per form.)
(Shaded blocks for committee use only.)
SC-135/WG-14 Paper Number: Date: 15-09-2010
DO-160F/ED-14F Section:
Rev G Frac#187
Author’s Name, Affiliation, and E-mail:
Paragraph:
Page:
Henning Stöfen, Airbus, [email protected]
18.4.a and figure 18-1
18-4, 18-5
Summary of Change (25 words or less):
Change the specified transformer output impedance to a realistic value with today’s equipment.
Reason for Change (Justification):
If we change the secondary limit from power to current, the output impedance of the transformer does not
have a direct impact on test severity anymore. We can allow for a wider range of impedances and
especially for lower impedances. Therefore, we do not need to reduce the performance of the test
equipment by introducing additional impedances as proposed in the user’s guide to section 18.
Revise From:
a. If the impedance of the test power leads is such that excessive power will be required
to generate the specified audio signal voltage level, the test conditions will be
adequately satisfied by the use of an audio amplifier with a maximum output of
100 W. The impedance of the output of the transformer shall be 0.6 Ohm ±50%.
Revise To:
a. If the impedance of the test power leads is such that excessive power will be required
to generate the specified audio signal voltage level, the test conditions will be
adequately satisfied by the use of an audio amplifier with a maximum output of
100 W. The generator impedance measured at the the outputs of the transformer shall be less than 0.9
Ohm.
Proposal Page Number:
1 of 2
SC-135/ED-14 Change Proposal Form Rev G
As Modified Text:
- Delete UG 18.A.3a, 18.A.3c.
- 18.A.4a, & 18.A.4b change source impedance to rated impedance
- Remove figure references of 0.6 ohm source impedances 18-1 & 18-2
X
Accepted As Written
Withdrawn
Accepted As Modified
Rejected
Deferred
Other
Rejection Reason / Comments:
Proposal Deferred To:
X
RTCA SC-135 Concurrence
Proposal Disposition By: WG14
SC 135
EUROCAE WG-14 Concurrence
Date: 15-09-2010
10/6/2010
Proposal Page Number:
2 of 2
SC-135/ED-14 Change Proposal Form Rev G