Download Surge Protected Double Adaptor

Surge Protected Double Adaptor
Protects against power
surges and voltage
spikes on the power
line
Suitable for protecting
computer hardware,
electrical equipment
and domestic
appliances in the
home or commercial
situations
Light indicates
surge protection is
functioning
DA11
Surge Protected Double Adaptor
A power surge or spike can travel on active, neutral or earth and cause costly
irreparable damage to your electrical equipment. The Arlec surge protected double
adaptor is suitable for protecting valuable computer hardware, electrical
equipment and domestic appliances in the home or commercial situations.
Operating Instructions
4. If during use, the indicator lamp goes
1. Use only with correctly wired
out, the protection circuit has probably
regular household powerpoint
absorbed a large power surge and
(240 Volt Max Load 10 amps) with
been damaged. This means the unit is
good earth connection.
no longer protecting your equipment
2. Plug the unit into the power point.
and must be replaced.
When the power is switched ON the
Note: This unit is not a lightning arrestor
red indicator lamp will glow.
and may not protect your
3. Plug the electronic or electrical
equipment if lightning directly
appliance into the unit.
strikes the house’s electrical
services or antenna.
Specifications
Input : 240 volt 50 Hz
(Max 10 Amps)
Surge Capacity : To 4500 Amps
Max. Continual Voltage : 275 Volt
Reaction Time : Less than 25
Nanoseconds
Clamping Voltage : 775 volts
Energy Absorption
Factor : 100 Joules
Made in China
CPCD851/2
DA11
© This packaging is subject to copyright and
must not be reproduced, copied or otherwise
used in any way or for any purpose without
the consent in writing of the owner, Arlec
Australia Pty Ltd (ACN 009 322 105).