Download Fanhdi® 25 IU/ml, 50 IU/ml and 100 IU/ml (Factor VIII)

Survey
yes no Was this document useful for you?
   Thank you for your participation!

* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project

Document related concepts

Gene therapy of the human retina wikipedia , lookup

Transcript
1
Fanhdi® 25 I.U./ml, 50 I.U./ml
and 100 I.U./ml (Factor VIII)
2
QUALITATIVE AND QUANTITATIVE COMPOSITION
- Vial
· Active ingredient:
Factor VIII
250 I.U.
500 I.U.
(Total proteins
≤ 90 mg
≤ 90 mg
· Excipients:
Arginine
175 mg
175 mg
Human albumin
50 mg
50 mg
Histidine
40 mg
40 mg
- Pre-filled syringe with solvent:
Water for injections
10 ml
10 ml
30°C 86°F
3
4
5
8
Hemorrhagic event
9
10
- Minor hemorrhages:
- H. into joints
- Major hemorrhages:
- H. into muscles
- Teeth extraction
- Mild trauma capitis
- Minor operations
- H. into the oral cavity
- Life-threatening hemorrhages:
- Major operations
- Gastro-intestinal bleeding
- Intracranial, intra-abdominal or
intrathoracic hemorrhages
- Fractures
175 mg
50 mg
40 mg
263 mg
75 mg
60 mg
10 ml
15 ml
Therapeutically necessary
plasma level of FVIII activity
30%
40 - 50%
60 - 100%
Period during which it is necessary to
maintain the therapeutic plasma level
of factor VIII activity
At least 1 day, depending on the
severity of the hemorrhage
3 - 4 days or until adequate
wound healing
During 7 days, then therapy for at least
another 7 days
Patients with inhibitors:
If plasma factor VIII does not reach the expected levels or if the bleeding cannot be controlled
after the administration of the adequate dose, the presence of inhibitors should be suspected.
Hemophilic patients having antibodies against factor VIII (inhibitors) need a specific therapy.
Immunotolerance may occur after treatment with human plasma coagulation factor VIII
concentrate.
Prophylaxis:
For long-term prophylaxis against bleeding in patients with severe hemophilia A, Fanhdi® should
be administered at doses of 10 to 50 I.U./kg given at intervals of 2 to 3 days. In some cases,
especially in younger patients, shorter dosage intervals or higher doses may be necessary.
Method of administration
Use the product in room temperature not above 30 °C.
Fanhdi® is intended for intravenous administration only. Fanhdi® may be administered at a rate
of no more than 10 ml/minute. (For full details of reconstitution and use refer to instructions for
use/handling).
Contra-indications
Caution is advised in patients with known allergic reactions to constituents of the preparation.
Special warnings and special precautions for use
If allergic or anaphylactic reactions occur, administration should be stopped immediately (the
current specific guidelines of shock therapy should be followed).
After repeated treatment with human plasma coagulation factor VIII concentrate, the level of
inhibitor in plasma should be determined.
When medicinal products prepared from human blood or plasma are administered, transmission
of infective agents cannot be totally excluded. This also applies to pathogens of hitherto unknown
nature.
To reduce the risk of transmission of infective agents, selection of donors and donations using
suitable methods is performed. Besides, removal and inactivation procedures are included in the
production process.
11
Instituto Grifols, S.A. Can Guasch, 2 - Parets del Vallès 08150 Barcelona - SPAIN
1500 I.U.
≤ 135 mg)
The product in final vial has a specific activity at least of 2.5 to 10 I.U./mg of protein depending
on its strength (250, 500, 1000 or 1500 I.U.).
The specific activity excluding the natural stabiliser vWf and albumin is greater than
1000 I.U./mg of protein.
PHARMACEUTICAL FORM AND THERAPEUTIC CLASS
Lyophilised preparation for intravenous injection. B02B D therapeutic class.
CLINICAL PARTICULARS
Therapeutic indications
Fanhdi® is indicated for the prevention and control of bleeding in patients with moderate or
severe factor VIII deficiency due to classical hemophilia A.
Fanhdi® is not effective in controlling the bleeding of patients with von Willebrand's disease.
Posology and method of administration
Posology
The dose and duration of Fanhdi® treatment must be adjusted according to each patient's
needs.
The required dosage may be estimated using the following formula:
Number of factor VIII = Body weight x Desired factor VIII x 0.5
units required (I.U.)
(kg)
rise (%)
This calculation is based on the empirical finding that 1 I.U. of factor VIII per kg body weight
raises the plasma factor VIII activity approximately 2% (i.e. 0.5 I.U./kg are required for 1%
increase in plasma factor VIII level).
The patient's plasma factor VIII levels should be determined and monitored during treatment with
Fanhdi®. This is particularly important in the case of surgical procedures.
6
7
1000 I.U.
≤ 90 mg
P-6
Vaccination guidelines for patients treated with blood or human plasma derivatives must be
taken into consideration in all the patients receiving Fanhdi®.
Interaction with other medicaments and other forms of interaction
None known.
Pregnancy and lactation
The safety of this medicinal product for use in human pregnancy has not been established in
controlled clinical trials.
Studies carried out in animal models are not sufficient to assess the safety with respect to
reproduction, development of the embryo or foetus, the course of gestation and peri- and
postnatal development.
Therefore, human plasma factor VIII concentrate may be used if clearly needed during pregnancy
and lactation.
Effects on ability to drive and use machines
There are no indications that human plasma coagulation factor VIII concentrate may impair the
ability to drive or to operate machines.
Undesirable effects
- Allergic or anaphylactic reactions are observed in rare cases.
- Increase in body temperature is observed in rare cases.
- Development of antibodies to FVIII.
- Although the isoagglutinin content is very low, there is a risk of intravascular hemolysis.
- The transmission of infectious agents cannot be totally excluded (see item special warnings
and special precautions for use).
Overdose
Consequences of overdosage are not known since overdosage cases have not been reported.
PHARMACOLOGICAL PROPERTIES
Pharmacodynamic properties
FVIII:C is responsible for the coagulation activity. As a factor IX cofactor, it accelerates the
conversion of factor X into activated factor X.
Activated factor X converts prothrombin into thrombin. Thrombin then converts fibrinogen into
fibrin in such a way that a clot can be formed.
The FVIII:C activity is greatly reduced in patients with hemophilia A and, therefore, substitution
therapy is necessary.
Pharmacokinetic properties
Plasma factor VIII activity decreases by a two-phase exponential decay.
The half-life of Fanhdi® obtained in the clinical trial carried out with this product is 14.18 ± 2.55
hours and the "in vivo" recovery is 105.5 ± 18.5%, which is equivalent to approximately 0.021 ±
0.004 I.U./ml per I.U./ kg administered (determinations performed following chromogenic method).
Preclinical safety data
Viral safety
The product is obtained from plasma from healthy donors subjected to medical examinations,
laboratory tests and study of their clinical case history. Furthermore, each donation is tested and
should be non reactive for hepatitis B surface antigen (HBsAg), HIV-1 and HIV-2 antibodies and
HCV antibodies. ALT levels are also determined, rejecting those plasma units with an ALT level of
greater than twice the upper limit of normal.
The process to manufacture Fanhdi® has been validated for viral inactivation/removal, using
HIV and model viruses for enveloped and non-enveloped viruses. Two specific steps designed
to inactivate any contaminating viruses, consisting of a treatment with tri-n-butyl phosphate
(TNBP) and Tween 80 and a heat treatment for 72-74 h at 81 ± 1 ºC, as well as two steps of
the process related to viral inactivation/removal (polyethylene glycol precipitation and affinity
chromatography) were studied, resulting altogether in a good viral inactivation/removal level.
Toxicological properties
Human plasma coagulation factor VIII (from the concentrate) is a normal constituent of the
human plasma and acts like the endogenous factor VIII.
Single dose toxicity testing is of no relevance since higher doses result in overloading.
Repeated dose toxicity testing in animals is impracticable due to interference with developing
antibodies to heterologous protein.
Even doses of several times the recommended human dosage per kilogram body weight show no
toxic effects on laboratory animals.
Since clinical experience provides no hint for tumorigenic and mutagenic effects of human
plasma coagulation factor VIII, experimental studies, particularly in heterologous species, are
not considered imperative.
PHARMACEUTICAL PARTICULARS
List of excipients
- Histidine
- Albumin (human)
- Arginine
- Water for injections (solvent)
Incompatibilities
Fanhdi® should not be mixed with any other drugs.
Shelf-life
Fanhdi® has a shelf-life of 3 years when stored not above 30 ºC.
Special precautions for storage
Do not store above 30 ºC.
Do not freeze.
Do not use after expiry date.
Nature and contents of container
Fanhdi® is supplied in type II glass vials containing 250, 500, 1000 or 1500 I.U. of FVIII
(lyophilised) and type I glass pre-filled syringes containing 10 ml for the presentations of 250,
500 and 1000 I.U. or 15 ml for the presentation of 1500 I.U. of water for injections (solvent).
Instructions for use/handling
Do not use after expiry date shown on the label.
Chemical and physical in-use stability has been demonstrated for 12 hours at 25 °C. From a
microbiological point of view, the product should be used immediately. If not used immediately,
in-use storage times and conditions prior to use are responsibility of the user and would normally
not be longer than 24 hours at 2 to 8 °C, unless reconstitution has taken place in controlled and
validated aseptic conditions. Left-over product must never be kept for later use, nor stored in
a refrigerator.
To prepare the solution:
1. Warm the vial and syringe but not above 30 ºC.
2. Attach plunger to syringe containing diluent.
3. Remove filter from packaging. Remove cap from syringe tip and attach syringe to filter.
4. Remove vial adaptor from packaging and attach to syringe and filter.
5. Remove cap from vial and wipe stopper with antiseptic wipe provided.
6. Pierce vial stopper with adaptor needle.
7. Transfer all diluent from syringe to vial.
8. Gently shake vial until all product is dissolved. As with other parenteral solutions, do not use
if product is not properly dissolved or particles are visible.
9. Briefly separate the syringe/filter from vial/adaptor, to release the vacuum.
10. Invert vial and aspirate solution into syringe.
11. Prepare injection site, separate syringe and inject product using the set with butterfly needle
provided or a sterile needle. Injection rate should be 3 ml/min into a vein and never more than
10 ml/min to avoid vasomotor reactions.
Do not re-use administration sets.
Manufacturer:
Instituto Grifols, S.A.
Can Guasch, 2 - Parets del Vallès
08150 Barcelona - Spain
License Holder:
Medici Medical Ltd.
2 Hapnina st.
Ra'anana 43000 - ISRAEL
The format of this leaflet was determined by the Ministry of Health and its content was checked
and approved.
Date of last approval: March 2007