Download AirMate (PAPR)

Survey
yes no Was this document useful for you?
   Thank you for your participation!

* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project

Document related concepts
no text concepts found
Transcript
1
• The 3M manufactures 2 types of Powered Air
Purifying Respirator (PAPR) to be worn to provide
respiratory protection for those staff members who
have not been successfully fit-tested using an N-95
respirator or to protect staff members from harmful
chemicals.
• The Air Mate is provided with a high efficiency
particulate air (HEPA) filter that protects when
providing care to patients with airborne precautions
within isolation rooms.
2
• Regardless of the respirator you wear, you must be medically
certified through Occupational Health Services prior to
wearing any respirator.
• Medical certification must occur for all respirator use, even
though fit testing is not a requirement of the Air Mate
3
• You must have all of the pieces for the PAPR to work properly.
Filter
Motor
Battery
Hose Cone
Mask
Blower
Belt
Fan
4
• The breathing tube connects the head cover to the blower unit
delivering clean filtered air through the top of the head cover
and into the breathing zone of the wearer.
• Air is exhausted around the edges of the head-cover and
through the holes in the chin area of the head cover.
• The PAPR is a positive pressure respirator, meaning that the
head cover is always inflated, preventing harmful agents on the
outside of the head cover from entering into the breathing zone.
5
• The battery should be charged after each use
• Do not remove battery from blower assembly during
recharge, simply plug charger into plug on blower
assembly case
• Fully charged batteries last 6-8 hours
• An LED light will appear in “normal charge” mode
6
• All components, except head covers, can be reused (Head
covers should be replaced after limited / single use)
• The Hose is NOT disposable - Assure hose is firmly locked in
place and is not kinked
• Check head-cover assembly and hose before each use - look
for holes, tears or abrasions
• Remove protective paper from visor window before use
• Safety goggles and surgery masks can be worn under the visor
window for additional protection
• Check air flow rate before attaching head cover to hose by
suspending black cone in air-stream of hose (Cone should be
suspended to the second line)
7
• Put on head cover assembly by pulling it over your head, visor
facing forward (ears should not be covered)
• Sizes are medium or large
• Latex free
• Issued individually to each wearer (Do not share head covers
with co-workers.)
• Obtain separate head cover for each patient (Do not take
head covers from one patient isolation room to another.)
• Can be paper bagged, and used by the same employee with
the same patient for a number of times
8
When cleaning or decontaminating the PAPR:
• Use antiseptic cleaning solution on outside case and hose
(spray cloth then wipe to prevent damage to unit)
• The HEPA filter can be used many times prior to replacing
annually (Open date and expiration date is marked on filter.)
• Replaced filter and rubber gasket when doing a filter
change-out. (Make sure gasket is firmly seated before
installing new filter)
• Used filters are disposed of as biohazardous waste
• Always store equipment in a clean, dry, area (Do not place
unit in direct sunlight or near source of excessive heat.)
9
• Units are NOT flame resistant
• Units will NOT provide protection from toxic gases
• Units are NOT for use in situations where oxygen level is below
19.5% or greater than 23.5% by volume (On average, Indiana
is 20.8% oxygen by volume)
• Units are NOT for use in an atmosphere that is immediately
dangerous to life and health (IDLH) (Poses an immediate threat
to life, would cause irreversible adverse health effects, or would
impair an individual’s ability to escape from a dangerous
situation.)
10
11