Download Part A - Parkway C-2

VOLCANOES Team Name ________________________________
Part A
1.
The rough, jumbled blocky or jagged surface of a lava flow is called
a. pahoehoe
b. lahar
c. aa
d. phreatic
2.
The Cascade volcanoes like Mt. St. Helens and Mt. Rainier are examples of
a. cinder cones
b. plateau of fissure-type basaltic eruptions
c. composite cones
d. shield cones
3.
The volcanic eruptions along the mid-oceanic spreading ridges are examples of
a. cinder cones
b. plateau of fissure-type basaltic eruptions
c. composite cones
d. shield cones
4.
Which of the following terms represents a rock formed predominately from ash-sized pyroclastic
fragments?
a. breccia
b. tuff
c. cinders
d. aa lava
5.
Where would a caldera likely be found?
a. along a fissure zone
c. within a collapsed shield volcano
b. at the top of a cinder cone
d. along a mid-oceanic ridge
6.
The Pacific "Ring of Fire" is so named because it has
a. many deep-focus earthquakes
b. many explosive stratovolcanoes (composite cones)
c. many shield volcano "hot Spots"
d. many long transform faults like the San Andreas Fault
7.
Which characteristic best describe volcanoes which form over a hot spot in oceanic lithosphere?
a. broad shield cones with a composition of basalt
b. layer upon layer of plateau basalt's erupted from fissures
c. composite cones with an average composition of andesite
d. scattered cinder cones and fissure eruptions of highly viscous lava
8.
In terms of plate tectonics, where are the most hazardous volcanoes found?
a. at oceanic hot spots
b. along convergent plate boundaries
c. at continental fissure eruptions
d. along mid- oceanic spreading
9.
The most dangerous place to live in the vicinity of a cascade volcano ( ie Mt. St. Helens) would be
a. in one of the river valleys at the base of he volcano
b. 100 km. to the east, where ash could be deposited
c. on top of a nearby non-volcanic ridge
d. in any town within site of the volcano
10. Magma that reaches the earth's surface is called _______________________.
11. Most of the volcanic rock on the earth is produced at _____________________________.
12. When magma erupts out of long cracks in the lithosphere or crust, as it does along spreading
ridges, such eruptions are known as _____________________ eruptions.
13. The contractions of cooing lava may produce polygonal columns know as __________________
_______________________.
14. The volcanoes of the Pacific "Ring of Fire" actually represent _________________________ zone
volcanism.
15. Relatively fluid, basaltic lavas tend to form ______________ volcanoes when they erupt from
central vents.
16. The smooth, ropy-looking surface which forms when especially fluid lava cool is called
_____________________.
17. Silicic lava of andesitic or rhyolitic composition tends to form volcanic _________________ when
they ooze out at the surface.
18. A volcanic cone formed entirely of pyroclastic material is known as a _______________________.
19. Stratovolcanoes, or composite cones, are built of layers of alternating lava flows and
____________________________ material.
20. Andesitic and rhyolitic lava tend to be thick. or more __________________ than basaltic lava.
21. Composite cones tend to be more _______________ in composition, compared to shield cones.
22. Gases escape more easily from _______________ magmas than from the more viscous andesitic
or rhyolitic magmas.
23. The magma produced at seafloor spreading ridges derives from __________________
____________________ of the ultramafic asthenosphere.
24. The type of pyroclastic material that can be carried the farthest distance from an erupting volcano
would be ___________________.
25. A volcano is usually considered _________________ if it has erupted in recent history.
26. A volcano that has not erupted recently and that does not appear to have eroded or worn down is
considered ___________________.
27. A volcano that has had no recent eruptions and that appears very eroded or worn down is
considered ___________________.
Match the kind of volcano on the right with the description on the left.
28.
29.
30.
31.
32.
33.
34.
built primarily of lava flows only _____
likely to produce a nuee ardent _____
Columbia River plateau basalt _____
built of pyroclastic and lava flows _____
broad and very low-sloping _____
generally andesitic in composition _____
built entirely of pyroclastics _____
a. shield volcano
b. composite cone or stratovolcano
c. neither
Match the kind of volcano on the right with the description on the left.
35.
36.
37.
38.
39.
40.
41.
highly explosive, ash-rich eruptions _____
associated with oceanic hot-spots _____
low-viscosity lava _____
ash fall hazards _____
occurs mostly at convergent plate boundary _____
Mt. Vesuvius _____
Hawaiian Islands _____
a. shield volcano
b. composite cone or stratovolcano
c. neither
Chapter 10 WS
page 2
Part B
T
F
1.
The source for the magma that erupts along spreading ridges is partial melting of the
asthenosphere.
T
F
2.
Magma that cools along divergent boundaries is forming new crust and lithosphere.
T
F
3.
Volcanoes that form on continents over subduction zones are generally andesitic in
composition.
T
F
4.
The source for the magma that erupts over subduction zones is partial melting of the
asthenosphere.
T
F
5.
Magmas that erupt at an oceanic hot spot will be most similar to magmas erupting on a
continent over a subduction zone.
T
F
6.
One source for more silicic magma at subduction-related volcanoes may be melting or
partial melting of the continental crust itself.
T
F
7.
Moving a body of ultra mafic rock to a higher place in the mantle will lower the
temperature needed to melt the rock.
T
F
8.
Under pressure, wet basalt has a lower melting temperature than does dry granite.
T
F
9.
Under pressure, wet basalt has a higher melting temperature than does dry basalt.
Refer to Figure 2 on page 281 for the questions #10 to13.
10. If pressure is held constant and water is added, what will happen to the melting temperature of
igneous material of any composition?
a. nothing; the melting temperature will not change
b. the melting temperature will increase if water is added
c. the melting temperature will decrease if water is added
d. the direction of change in melting temperature varies, depending on the composition of the
igneous material
11. If the pressure on dry igneous material decreases, how will the melting temperature change?
a. the melting temperature will not change; pressure has no effect
b. the melting temperature will increase
c. the melting temperature will decrease
d. the direction of the effect depends on the composition of the igneous material
12. For wet igneous rocks (the dashed lines in both graphs), are melting temperatures higher or lower
at very low pressure compared to high pressure
a. melting temperatures are higher at low pressures
b. melting temperatures are lower at low pressures
c. the graphs don't indicate an answer to this question
d. the answer depends on the composition of the igneous rocks
13. Which type of rock requires the lowest temperatures to begin to melt?
a. ultramafic rock
b. granite rock
c. basaltic rock
d. mantle rock
14. The most silicic volcanoes are typically found
a. along the mid-oceanic rift zone
b. in continental fissure or rift zones
c. along continental-oceanic convergent plate margins
d. over hot spots in oceanic crust
Chapter 10 WS
page 3
15. Which term below represents a mudflow that contains volcanic material and is initiated by volcanic
eruption?
a. nueé ardentes
b. lahar
c. ash fall
d. aa flow
16. Which term below represents a dense cloud of gas and volcanic ash that races down the slopes of
a violently erupting volcano?
a. nueé ardentes
b. lahar
c. ash fall
d. aa flow
17. Why do more viscous lava generally erupt more violently and explosively than do less viscous
lavas?
a. because more viscous lavas erupts less frequently than less viscous lavas
b. because more viscous lavas tend to be cooler than less viscous lavas
c. because more viscous lavas trap gases so pressure build up in the magma chamber
d. because more viscous lavas contain very little gas and other volatiles
18. The smooth, ropy-looking surface which forms when especially fluid lavas cool is called
_________________________.
19. Silicic lavas of andesitic or rhyolitic composition tend to form volcanic ________________ when
they ooze out at the surface.
20. Magmas that erupt suddenly and violently, releasing built-up gas pressure, tend to produce
_________________________ materials rather than lava flows.
21. Gases escape more easily from ________________________ magmas than from the more
viscous andesitic or rhyolitic magmas.
22. The magma produced at seafloor spreading ridges derives from___________________________
of the ultramafic asthenosphere.
23. The release of water from a down going slab of subducted lithosphere is referred to as
__________________________ of the lithosphere.
24. The characteristic composition of island arc volcanism is basaltic to ________________________,
which represents magmas which contain more silica.
25. Hot-spot volcanism is attributed to mantle _______________________ ,which are thought to be
relatively stationary features in the mantle.
26. Like all liquids, lava flows __________________________.
27. The type of pyroclastic material that can be carried the farthest distance from an erupting volcano
would be _____________________.
28. Carbon monoxide, hydrochloric acid, and hydrofluoric acid are examples of __________________
gases that may be emitted during a volcanic eruption.
29. A _________________________ explosion occurs when water seeps into the rock surrounding a
hot magma chamber and turns to steam, blowing up the overlying volcano.
30. A very explosive volcanic eruptions can throw large amounts of volcanic dust high into the
atmosphere, blocking the sun and causing long term___________________________.
Chapter 10 WS
page 4
Chapter 4 WS
page 5
Chapter 4 WS
page 6
Chapter 4 WS
page 7