Download SIMULATING WITH SPECTRE

SIMULATING WITH SPECTRE
4. Setting up the simulation:
4.1 Provide stimulus:
From analogLib, get your signal source. You can find anything you need for this project
(and much more), in there: vdc, idc, vpwl, vsin, vpulse, etc. For this example, let's get
vdc, and connect it to the gate of the transistor.
Edit the properties of vdc so that it supplies a DC voltage of 770 mV, and an AC
magnitude of 1 V.
4.2 Place a battery in the circuit:
Get another vdc from analogLib, and connect it to vdd! and gnd!. You can place more
vdd! and gnd! symbols since they are global (that's what the exclamation mark '!' means).
Edit the properties of vdc so that it supplies a DC voltage of 3.3 V.
Your schematic should now look something like this:
Figure 5.1: Schematic ready for simulation.
5. Simulate:
In Schematic Window:
Design->Check and Save
There should be no errors. Warnings such as "Solder dot on cross over" are okay.
Tools->Analog Environment
In Cadence Analog Design Environment:
The following two steps only need to be done for this first session.
Setup->Simulator/Directory/Host
Set the simulator to Spectre.
Setup->Model Libraries Use the model files in the directory (for VLSI lab):
/home/class/ee5333t1/models/spc/models.scs Section “c0”. Click Add and
OK.
Set Analysis:
Analyses->Choose
Select dc analysis
Click "dc operating point"
Select ac analysis
Choose sweep range, from 1 kHz to 1 GHz.
Choose sweep type "logarithmic, 10 points per decade.
Click OK.
Choose nodes to be saved:
Outputs->Save all, click 'OK'.
Start simulation:
Simulation->Run
The simulator status can be seen in the log (CIW) window. Ignore the warnings about the
model files, and wait until it finishes.
6. View Results
To see the operating point, do the following in the Analog Artist Simulation Window:
Results->Annotate->DC Node Voltages.
The node voltages will be annotated in the schematic window. You can also annotate the
transistors operating points by choosing:
Results->Annotate->DC Operating Points.
Figure 2: DC operating point results.
To see the results of the ac analysis, do the following:
In the Analog Artist Simulation Window:
Tools->Calculator
Then, in the Calculator:
Click the "vf" button, click on output net in schematic.
Click "plot".
The Waveform Window opens. You can find, for example, the unity gain frequency
easily by choosing:
Markers->Horizontal Marker
Type 1 Volt in "Marker locations", and click "Apply". If you want to see the exact
value, click "Display Intercept Data".
You can also see the output voltage in dB. Just click the 'dB20' button in the calculator,
and then 'Plot'. To delete other plots, click directly on the curve and press Delete.
Figure 3: AC analysis results