Download Portable Digital Blood Pressure Monitor

Survey
yes no Was this document useful for you?
   Thank you for your participation!

* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project

Document related concepts
no text concepts found
Transcript
Portable Digital Blood Pressure
Monitor
Introduction:
Our final project is to design and build a portable blood pressure monitor device that can
measure a user's blood pressures and heart rate through an inflatable hand cuff. The
device is consisted of three main parts: external hardwares (such as cuff, motor, valve,
and lcd), analog circuit, and microcontroller. The anolog circuit converts the pressure
value inside the cuff into readable and usable analog waveforms. The MCU samples the
waveforms and performs A/D convertion so that further calculations can be made. In
addition, the MCU also controls the operation of the devices such as the button and lcd
display. Since we have the word 'portable' in our title, for sure all of the components are
put together in one package which allows a user to take it anywhere and perform a
measurement whenever and wherever he/she wants.
It is undeniable that nowadays people are more aware of the health conditions. One of
the most widely used methods to test the health conditions of an individual is to
measure his/her blood pressures and heart rate. We, as ones of those who are
concerned about their health, decided to work on this subject matter because we would
like to build something that is useful and useable in real life.
How blood pressures are
measured
Usually when the doctor measures the patient's blood pressure,
he will pump the air into the cuff and use the stethoscope to listen
to the sounds of the blood in the artery of the patient's arm. At
the start, the air is pumped to be above the systolic value. At this
point, the doctor will hear nothing through the stethoscope. After
the pressure is released gradually, at some point, the doctor will
begin to hear the sound of the heart beats. At this point, the
pressure in the cuff corresponds to the systolic pressure. After the
pressure decreases further, the doctor will continue hearing the
sound (with different characteristics). And at some point, the
sounds will begin to disappear. At this point, the pressure in the
cuff corresponds to the diastolic pressure.
The air will be pumped into the cuff to be around 20 mmHg above average
systolic pressure (about 120 mmHg for an average). After that the air will be
slowly released from the cuff causing the pressure in the cuff to decrease. As
the cuff is slowly deflated, we will be measuring the tiny oscillation in the air
pressure of the arm cuff. The systolic pressure will be the pressure at which
the pulsation starts to occur. We will use the MCU to detect the point at
which this oscillation happens and then record the pressure in the cuff. Then
the pressure in the cuff will decrease further. The diastolic pressure will be
taken at the point in which the oscillation starts to disappear.
Hardware Diagram
Hardware Diagram
NOTES
• The output voltage of the pressure sensor will
be proportional to the difference between the
pressure in the cuff and the air pressure in the
room.
• The output voltage from the pressure sensor
is very small (in mV),so we used a DC
Amplifier (AD620) that amplifies according
this equation RG=49.4KOhm/(G-1).
NOTES
• We used a Band-Pass filter to red of the DC
voltage and amplify the AC voltage.
• We used an AC coupling stage to provide the
DC bias level. Given this bias level, it is easier
for us to process the AC signal using the onchip ADC in the microcontroller.
Software Flowchart