Download DTC P0350: IGNITION COIL PRIMARY/SECONDARY CIRCUIT P0350

POWERTRAIN DTC CHARTS & DESCRIPTIONS -- GASOLINE MODELS -2006 For... Page 1 of 1
DTC P0350: IGNITION COIL PRIMARY/SECONDARY CIRCUIT
P0350 - IGNITION COIL PRIMARY/SECONDARY CIRCUIT
Each ignition primary circuit is continuously monitored. The test fails when the
Description: powertrain control module (PCM) does not receive a valid ignition diagnostic
monitor (IDM) pulse signal from the ignition module (integrated in the PCM).
Open or short in the Ignition START/RUN circuit
Open coil driver circuit
Coil driver circuit shorted to ground
Damaged coil
Coil driver circuit shorted to VPWR
Use the 12-volt non-powered test lamp to verify START/RUN voltage at the
ignition coil harness connector.
Check the coil driver circuit for open, short to VPWR, or short to ground.
Key On Engine Off
Key On Engine Running
Continuous Memory
GO to Pinpoint Test JE .
Possible
Causes:
Diagnostic
Aids:
Application
All
© 2008 Mitchell Repair Information Co., LLC.
http://www.ondemand5.com/mric/common/asp/printart.aspx
7/15/2011