Survey
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project
G-celerator Cube Jumper Settings and Operation Guide IMPORTANT: PLEASE READ BEFORE USE This upgrade is sold as a dealer installed or distributor supported product. Giga Designs will service this product under the terms and conditions of the Limited Warranty included with the G-celerator. Please register your product by mail or fax using the included Product Registration card, or online at www.fastercpu.com. For warranty inquiries, please contact us via e-mail at [email protected] or call us at 510-919-1988. For installation support, please contact the dealer or distributor where the upgrade was purchased. The G-celerator has been tested at and is shipped with the jumpers set at a processor clock speed of 1.2GHz, and the voltage jumpers are preset to 1.5v. If you are using this upgrade in a stock Cube configuration, these are the maximum recommended settings for use without the addition of a cooling fan. For systems with an upgraded graphics card and/ or disc drive, a 1.4 volt maximum setting is suggested for use without a fan. At this voltage setting operation above 1GHz may not be possible. Although a cooling fan is not required for many hardware configurations, Giga Designs recommends the addition of a low speed dual ball bearing fan for optimal system performance, and the longest possible lifespan. Voltage Jumper Settings With the jumpers positioned along the top edge of the board, the voltage jumpers are the three small (2mm) jumpers closest to the right side of the board. From left to right the settings are as follows: 1.3v- open, open, closed 1.35v- open, closed, open 1.4v- open, closed, closed (Max. for Fanless Cube with Upgraded Graphics and/ or HDD) 1.45v- closed, open, open 1.5v- closed, open, closed (Maximum Voltage for use in a Stock Cube with no Fan) Processor Speed Jumpers Settings With the jumpers positioned along the top edge of the board, the processor speed jumpers are the five blue jumpers closest to the left side of the board. From left to right the settings are as follows. 1GHz- closed, open, closed, open, closed 1.1GHz- closed, open, open, closed, closed 1.2GHz- closed, open, closed, closed, closed www.fastercpu.com © Giga Designs, LLC. All rights reserved. Giga Designs, the Giga Designs logo, and G-celerator are trademarks of Giga Designs, LLC. Motorola, AltiVec, and the Motorola Digital DNA logo are trademarks of Motorola, Inc. Power Mac, Macintosh, Mac, the Built for Mac OS X badge, and the Mac logo are trademarks of Apple Computer, Inc. Revised 11/03