Download Dry Slide Instruction - Party Palace Rentals

INSTRUCTIONS FOR INFLATABLE DRY SLIDE
Site Location:
 Pick a location free from overhead electric power or telephone lines. Location should be free from trees and
could damage or strain the inflatable. An unobstructed area should be maintained for 5 feet around the
perimeter of the inflatable.
 Contact all utility companies and have all underground lines properly located so no accidental contact occurs
when driving stakes into ground.
 Keep the front of the inflatable clear and accessible at all times.
Installation
 Remove unit from the carrying bag if one came with the unit.
 Remove the straps from the unit.
 Unroll and position the slide on a level area.
 Once unrolled, the unit is folded. Completely open the inflatable to expose the entire unit.
 The slide has several tethered straps that are use to secure the unit to the ground with stakes.
 Tie off each tethered line with a stake, and hammer the stake into the ground. Please allow for plenty slack.
 Attach the blower to the inflation/deflation tube.
 Make sure all the zippers and Velcro flaps are sealed prior to inflating unit.
 The placement of the blower must be free to receive intake of air.
 Connect the 12 gauge/50’ extension cord that is provide to the blower. Note: It is required that each blower
may require a 20 amp / 110 volt circuit.
 Turn the blower on. The slide will take a good 5-10 minutes to inflate because of the massive size. Please
check the surrounds prior to use.
 See Attach diagram.
Operating Instruction
 Check the stakes regularly to ensure they are tight.
 Check the blower and inflation tube regularly to ensure there isn’t any excessive air leakage.
 If a GFI is required, please check prior to use of inflatable and during the use.
 Prohibited excessive roughhousing by riders. Prohibited use of shoes.
 Observe all maximum occupancy rules.
 Keep inflatable clean and dry at all times.
 If the inflatable gets wet, remove riders and dry unit as soon as possible by blowing air through the unit.
 DO NOT ALLOW CHILDREN OR ADULTS NEAR THE REAR OF THE UNIT NEAR THE ELECTRIC BLOWER AT ANY
TIME.
Safety Rules
 Do not inflate in high winds or rain.
 Unload all occupants/riders and deflate the inflatable if winds become excessive.
 Use the adequate extension cord provided by Party Palace. DO NOT USE ANY OTHER TYPE OR EXTENDED
CORDS. This could cause the blower not to receive the proper voltage and may be damaged. Never cut or
remove the round grounding pin from the cord.









Always connect the GFI to the extension cord before plugging into the power source. This reduces the
possibility of arcing the GFI contacts.
Check the GFI at least once during operations.
Obtain marking and location information from the utility company if there is a possibility of underground
utilities.
Ensure there are no underground irrigation pipes, electric wires, gas lines, telephone lines, cable, or FIOS
lines that the utility company or property owner may not have installed.
Limit the riders to the numbered specified in the operating instructions.
Always ensure that there is adequate clearance around and above the ride.
NEVER ROLL-UP OR PACKAGE THE INFLATABLE WET.
Never use chlorine based cleaner or bleaches to clean, as this may damage the thread or vinyl.
If power should stop at any time during use, riders need to evacuate immediately. Since the inflatable will
deflate rapidly, ask the riders to sit down, and have a responsible adult evacuate each person individually.
Deflating & Packaging Inflatable
 Make sure no one is in the inflatable.
 Turn off blower and unplug from power source.
 Loosen inflation/deflation tube straps. Open all zipper and Velcro flaps. The air inside the inflatable will start
discharging more rapidly.
 Once the inflatable is completely discharged of air, remove the j-stakes from the ground.
 With the inflatable completely deflated and unsecured to the ground, fold the unit in half as shown in the
attach diagram.
 After the fold, step on the inflatable to try to get the balance of the air out of the unit.
 Roll the unit from the front to the rear toward the inflation/deflation tubes. This will allow all of the air to
come out.
 Tuck inflation/deflation tubes into the roll and attach the two (2) straps to the entire unit to secure.
 If properly deflated, the unit will fit in the storage bag.
 See attach diagram.
DO NOT HESIATE TO CALL IF YOU DO NOT UNDERSTAND THESE INSTRUCTIONS.
BE SAFE NOT SORRY.
410-836-0085