Download DC Input Transducer(2 Output TYPE)TRP-K1A2

TRPK1A2
TAKEMOTODENKI
CORPORATION
DC Input Transducer(2 Output TYPE)TRP-K1A2
Plug-in Type, 1 input/2 outputs 4 Port Isolation
■ Specification
Output
Outline
Range
Load Resistance
1 st Output
2 nd Output
0∼ 5V
1∼ 5V
Over 500Ω
Over 500Ω
0∼ 10V
Over 2kΩ
Over 2kΩ
4∼ 20mA
0∼ 600Ω
0∼ 600Ω
This transducer converts DC voltage or current signals
into standardized signals by isolating them. There are
2 outputs isolated each other.
Type
ＴＲＰ−Ｋ１Ａ２−□□□−□
Installation
Input
[DC Voltage Input]
1： 0∼10mV
2： 0∼100mV
3： 0∼1V
4： 0∼10V
5： 0∼5V
6： 1∼5V
0：Specified Voltage
Power Supply:
85∼264V AC
[DC Current Input]
A： 4∼20mA
D： 0∼20mA
G： 0∼1mA
Z： Specified Current
85∼143V DC
50/60Hz
Approx. 6VA
Approx. 3VA
24V DC±10％ Approx. 3VA
Operating Temperature： -10∼ ＋60℃
Mass：Approx. 400g
Performance
Reference Accuracy：±0.1％
1 st Output
4： 0∼10V
A： 4∼20mA
5： 0∼5V
Z： Specified Current
Response Time：Less than 0.5 sec. (0→ 90％)
Connector Pinouts
6： 1∼5V
Power Supply
0：Specified Voltage
2 nd Output
A： 4∼20mA
Z： Specified Current
4： 0∼10V
5： 0∼5V
Input
Signal
6： 1∼5V
0：Specified Voltage
Power Supply
A： 85∼264V AC /85∼ 143V DC
D： 24V DC±10％
How to order
2nd Output Signal
1st Output Signal
・Type：TRP-K1A2-1A-A
・Specify input range
(※ )When current is input, input resistance R is attached
Input
Range
in the terminal parts.
Resistance
Range
Resistance
0∼ 10mV
Over 10kΩ
4∼ 20mA
250Ω
0∼ 100mV
Over 100kΩ
0∼ 20mA
50Ω
0∼ 1mA
1000Ω
0∼ 1V
0∼ 10V
0∼ 5V
Over 1MΩ
When its resistance R is embedded in the terminal
parts, the upper part have another extra 12 mm.
Outline Dimensional Drawing
See Figure B.
1∼ 5V
TRPK1 6/15