Download patient preparation - Dr. Roberta Dev Anand

Survey
yes no Was this document useful for you?
   Thank you for your participation!

* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project

Document related concepts

Prenatal testing wikipedia , lookup

Medical ethics wikipedia , lookup

Dysprosody wikipedia , lookup

Patient safety wikipedia , lookup

Adherence (medicine) wikipedia , lookup

Electronic prescribing wikipedia , lookup

Patient advocacy wikipedia , lookup

Intravenous therapy wikipedia , lookup

Transcript
CHAPTER 2 Part 2
PATIENT PREPARATION
 IV CATHETERS: catheters are ideal for all anesthetic
procedures
 Can provide IV fluids for support during surgery (blood loss,




dehydration, prevent/treat hypotension)
Allows injection of medications such as antibiotics and
analgesics and allows constant-rate-infusions
Provides access to a vein in an emergency (cardiac arrest,
seizures ). Do not remove until animal is fully awake!
Allows irritating agents to be injected (ex: thiopental)
Allows injection of incompatible drugs
PATIENT PREPARATION
 IV CATHETERS: Choose catheter size based on patient’s size
and need
 Risks with catheter placement:
 AIR- always remove air from IV line before injecting
 BROKEN TIP- don’t repeatedly advance and retract the stylet
 OVERHYDRATION- can avoid by using infusion pump or
calculate drips/sec

signs of over-hydration: eye/nose discharge, swelling of conjunctiva,
SQ edema, increased lung sounds and respiration rate, dyspnea,
coughing, restlessness, hemodilution
 SEPSIS- wipe area of catheter placement with an antiseptic and
injection ports with alcohol
 HASTY INJECTION OF DRUGS – Just because the catheter is
there, doesn’t mean all drugs should be given IV
PATIENT PREPARATION
 IV FLUIDS: the patient’s infusion rate will depend on
body weight and procedure
 Fluids during surgery/anesthesia:

5-10 mL/kg/hr (10mL/kg/hr is typical)
 intended to compensate for vasodilation and fluid loss during
anesthesia/surgery
 The prescribed surgical fluid rate at VTI is
10mL/kg/hr
PATIENT PREPARATION
 IV FLUIDS: fluid rates can be adjusted for those patients
that are compromised
 CV disease
 Respiratory disease
 Fluid rates for these patients are often dropped to 5ml/kg/hr
 An animal with excessive hemorrhage or low blood pressure
during surgery can have fluid rates increased
 Dogs: up to 40mL/kg/hr
 Cats: up to 20ml/kg/hr
 A quick way to estimate amount of fluids to give:*Give ~3mL of
fluid for every 1mL of blood loss
PATIENT PREPARATION
 ANIMALS IN SHOCK: these patients need even more
rapid fluid rates
 Dogs: 50-90mL/kg/hr
 Cats: 40-60mL/kg/hr
 ¼ of the calculated dose is given over 15min and then
patient re-evaluated
 Animals in shock may show the following signs:
 Pale mucous membranes
 Low blood pressure
 Slow heart rate
PATIENT PREPARATION
 IV FLUIDS: drip sets (administration sets) help
determine how fast the fluids are administered
 Patients greater than 10kg use a macrodrip set
 Macrodrip sets are either 10gtt/mL or 15gtt/mL

VTI has 15gtt/mL sets
 Patients less than 10kg use a microdrop set
 Microdrip sets are 60gtt/mL
PATIENT PREPARATION
 IV FLUID ADMINISTRATION SETS
MACRO
MICRO
PATIENT PREPARATION
 IV FLUID ADMINISTRATION: most clinics have an IV
fluid pump. The pump controls how many drops of
fluid are delivered to the patient over a period of time.
 If no pump is available, the anesthetist will need to
calculate how many drops of fluid should be
administered to the patient in a period of time as well as
monitor the fluids closely.
PATIENT PREPARATION
MATH
 Step 1: Obtain the patient’s weight in kgs.
 If the patient’s weight was obtained in pounds, then you must
divide by 2.2
 Step 2: REMEMBER THE SURGICAL FLUID RATE:
10mL/kg/hr. Multiply the patient’s weight in kgs by 10. This
will give you how many mLs the patient should receive in 1
hour known as the infusion rate.
 Step 3: Determine the drip set necessary for the patient based
on weight.
 Step 4: Multiply the patient’s infusion rate by the drip set.
 Step 5: Divide the number from Step 4 by 3600 (because
there are 3600 seconds in 1 hour). THIS FINAL ANSWER
WILL TELL YOU HOW MANY DROPS OF FLUID EACH
SECOND THE PATIENT WILL RECEIVE WHILE UNDER
ANESTHESIA.
PATIENT PREPARATION
 Patient weighs 6 kg.
 Surgical fluid rate is 10mL/kg/hr: 6 x 10 = 60 mL/hr
 Patient needs microdrip set: 60 x 60 = 3600
 3600/3600 = 1 drop/sec
 Patient weighs 12 kg.
 Surgical fluid rate is 10mL/kg/hr: 10 x 12 = 120 mL/hr
 Patient needs a macrodrip set: 120 x 15 = 1800
 1800/3600 = 0.5 drops/sec
 0.5 drops/sec is impossible to count, but if we multiply by 10
it will tell us how many drops to administer in 10 seconds
 0.5 x 10 = 5 drops/10 sec
PATIENT PREPARATION
 REVIEW OF IV FLUID TYPES: Crystalloids vs. Colloids
 CRYSTALLOIDS: the most common fluid type. Used for
fluid replacement and maintenance. The 3 general
categories of crystalloids are:
 Balanced electrolyte solutions
 Saline solutions
 Dextrose solutions
PATIENT PREPARATION
 CRYSTALLOIDS: BALANCED ELECTROLYTE
SOLUTIONS
 Contain a solute profile similar to the extracellular
fluid since dehydration and many general diseases
and perioperative hemorrhage deplete the ECF
first.


This means higher concentrations of Na+ and ClExamples: Plasmalyte, Normosol, Lactated Ringer’s
PATIENT PREPARATION
 CRYSTALLOIDS: SALINE SOLUTIONS
 Contain ONLY Na+ and Cl Examples: Normal Saline & hypertonic Saline
 Normal Saline (0.9%): used to flush body cavities,
flush catheters, blood transfusions
 Hypertonic Saline (3%, 5%, 7%): very concentrated
and quickly draws water into the intravascular space
and supports blood pressure, but rapidly diffuses out
into the interstitial space. Used for profound
hemorrhage, shock, increased intracranial pressure
PATIENT PREPARATION
 CRYSTALLOIDS: DEXTROSE SOLUTIONS (2.5%,
5%)
 Used in cases of hypoglycemia, neonatal,
debilitated animals, hyperkalemia, patients
receiving insulin
 Don’t use as the sole fluid. The sugar is rapidly
metabolized to CO2 and water. The free water
diffuse out into the interstitial space.
PATIENT PREPARATION
 COLLOIDS: large molecules that do not readily leave
the intravascular space
 These are helpful in maintaining blood volume and
pressure
 Less side effects than hypertonic saline
 Rapidly pulls water into the intravascular space
 Examples: Plasma or blood, synthetic colloids, blood
substitutes
PATIENT PREPARATION
 COLLOIDS: PLASMA OR BLOOD
 Contains albumin, clotting factors, globulins
 Used in animals with acute blood loss, anemia,
hypoproteinemia
 Expensive
 COLLOIDS: BLOOD SUBSTITUTES
 Used for acute hemorrhage and anemias
 Oxyglobin contains molecules similar to red blood cells
that are able to carry oxygen.
 The benefit is that there is no cross-match required
 THIS PRODUCT IS NOT CURRENTLY AVAILABLE
PATIENT PREPARATION
 COLLOIDS: SYNTHETIC COLLOIDS (Hetastarch,
Dextran)
 More readily available than blood products
 Less expensive and longer shelf life than blood
products
 Used in cases of shock, hypoproteinemia
 Usually bolused slowly over 15-60 minutes