Download Power Supply Test Plan

Power Supply Test Plan
Test #
Engr. Spec.
#
Specification
(description)
Source
CN3
Mass
CN10
Operating time
Mass in grams
PASS: Mass is less than
800g
FAIL: Mass is greater
than 800g
Weigh the Power Pack
On Scale
2
ES8
Pass Fail Criteria
Test Procedure
1
ES3
Gathered Data
Assemble the vehicle
using Newer Generation
hardware.
Fully charge the battery.
Operate the vehicle like a
freshman
3
Observe total
operation time
Observe if the
power supply selfcontained
ES12
CN9
Power Source is
portable
Assemble the vehicle
with the power supply
4
Voltage in Volts
Fully charge the battery
as described in the
battery charging manual
ES20
Functionality
Supply voltage
5
ES20
6
ES21
ES4
ES5
ES6
Functionality
Functionality
CN4
CN4
CN4
Supply voltage
Power supplied
Length
Width
Height
Measure voltage at the
battery output after the
battery is fully charged
Fully charge the battery,
load the battery with 5.1
Ohm resistor and let it
discharge for 3 hours
After 3 hours, measure
the output voltage
Put the Power Supply on
a flat Surface and
measure width, length
PASS the vehicle can
operate longer than 1
hour
FAIL: the vehicle can
operate no longer than 1
hour
PASS: the power supply
is self-contained
FAIL: the power supply
is not self-contained
PASS: The voltage is
less than 9V but greater
than 6V
FAIL: The voltage is
greater than 9V or less
than 6V
Voltage in Volts
PASS: The voltage is
greater than 6V
FAIL: The voltage is less
than 6V
width, length and
height in cm
PASS: width, length and
height are all under 9cm
by 4cm by 4cm
and height
FAIL: width, length and
height are not all under
9cm by 4cm by 4cm