Download DEVICES ARE PLUG AND PLAY READY.

MODEL
PL-1200AV2-PIGGY
DEVICES ARE PLUG
AND PLAY READY.
HomePlug AV2 devices are preconfigured with a common Private Network Name. Adding new HomePlug AV2 devices to an existing
network with the default Private Network Name is as easy as plugging the device into the power outlet. If you wish to have a unique
Private Network Name, simply follow the instructions below. This Easy Start Guide, the User Manual, and the HomePlug AV Utility
software is included in the Resource CD.
A Package Contents
C Setting up your HomePlug AV Network
The following items below are included in your PL-1200AV2-PIGGY
package.
PL-1200AV2PIGGY
Ethernet
Cable
B Device Overview
Resource CD
Easy Start
Guide
NOTE : You may use this AC
Pass-through as an extra
power outlet.
BOTTOM VIEW
Power LED
Reset
Button
Powerline
Activity LED
Ethernet
Activity LED 1
Ethernet
Activity LED 2
Simple
Connect
Button
Ethernet
Ports 1 & 2
STEP 1 :
In Room A, plug in your HomePlug AV2 device into the power outlet
and connect it to the modem router using an Ethernet cable.
NOTE: Ensure that your modem router’s internet connection is UP to
allow access to the internet.
STEP 2 :
In Room B plug in your other HomePlug AV/HomePlug AV2 device
into the power outlet and connect it to your computer’s Ethernet port
using an Ethernet cable.
STEP 3 :
2
Confirm that a connection has established on both HomePlug AV/
HomePlug AV2 devices. All three LEDs (Power , Powerline
, and
the corresponding Ethernet LED ) must be ON. Your Homeplug AV
Network is now ready to use and can now access Internet.
MODEL
PL-1200AV2-PIGGY
D Setup for an Existing Network Connection
If in case you have changed the Private Network Name of your
existing network, you may use the Simple Connect Button of your
PL-1200AV2-PIGGY and the other devices as indicated below:
Step 3
HomePlug X
HomePlug Y
(Your new HomePlug AV2)
(A HomePlug that
belongs to the existing
network)
Step 1
HomePlug X
3
HomePlug Y
(Your new HomePlug AV2)
(A HomePlug that
belongs to the existing
network)
Within two minutes, press the simple connect button of
HomePlug X for TWO SECONDS.
Step 4
1
Press the Simple Connect button of your HomePlug
X for 10 SECONDS. After you release the button, the
Power
and the Ethernet LED
will turn OFF and
turn ON.
HomePlug X
HomePlug Y
(A HomePlug that
belongs to the existing
network)
(Your new HomePlug AV2)
Step 2
HomePlug X
HomePlug Y
(Your new HomePlug AV2)
(A HomePlug that
belongs to the existing
network)
4
To confirm if the connection has established, check the LEDs. The Power LEDs
and the Powerline Activity LEDs on all HomePlugs would be ON.
NOTES:
Press the Simple Connect Button of HomePlug AV Y for
TWO SECONDS. The Power LED
will continuously blink.
If the Power LED did not blink, press the Simple Connect
button again for two seconds.
2
Press for 3 SECONDS
to perform factory
defaul reset.
• When joining an existing network, you only have
to pair it to one HomePlug AV that belongs to the
existing network.
• The Ethernet Activity LED
will only be lit if it is
connected to an Ethernet device (e.g. computer,
laptop, etc) through an Ethernet cable.
• To perform RESET to factory defaults, press the reset
button for 3 SECONDS.