Download Series 300 Frequently Asked Questions Features

Survey
yes no Was this document useful for you?
   Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Document related concepts

Electrification wikipedia, lookup

Mains electricity wikipedia, lookup

Buck converter wikipedia, lookup

Switched-mode power supply wikipedia, lookup

Opto-isolator wikipedia, lookup

Alternating current wikipedia, lookup

Metadyne wikipedia, lookup

Voltage optimisation wikipedia, lookup

Stray voltage wikipedia, lookup

Distribution management system wikipedia, lookup

Pulse-width modulation wikipedia, lookup

Variable-frequency drive wikipedia, lookup

Islanding wikipedia, lookup

Electrical substation wikipedia, lookup

Three-phase electric power wikipedia, lookup

Switch wikipedia, lookup

Crossbar switch wikipedia, lookup

Resonant inductive coupling wikipedia, lookup

Relay wikipedia, lookup

Transcript
For G300 (1000-3000A)
How do I perform a transfer test?
Press transfer switch test button and hold it for 15 seconds or until the generator starts and a transfer occurs.
How do I set the transfer time delays?
Refer to table 4-1 for the corresponding adjustment. Click here for the DIP switch and Potentiometer location.
How does the transfer switch work?
(For detailed explanation, refer to section 2 of the operator’s manual)
For Non-Automatic Transfer Switches: Transfer switch operation is performed manually, as well as cranking
and starting of the generator; the transfer switch time delays are set the same as the automatic transfer switch.
DISCONTINUED
PRODUCT
The ATS controller monitors the voltage and frequency of normal and emergency. When the normal voltage
(utility voltage) fails (The voltage is below the drop-out setting), the controller waits 1 to 3 seconds before it
starts the generator. After the delay of 3 seconds, and normal voltage doesn’t pick-up (The voltage reaches the
pick-up setting), the ATS starts the generator and goes through another time delay (N/E timer) to monitor its
voltage and frequency. Once the timer expires, and utility voltage does not pick-up, the load transfers to
emergency. The load stays on emergency until utility power is restored. When utility power is restored, the ATS
initiates another time delay (E/N timer) before it retransfers to normal. After the time delay expires, the load
retransfers to utility and the generator goes to cool down cycle for 5 minutes. Then the generator automatically
shuts down.