Download OT 50/220-240/10 Technical Information

OT 50/220-240/10
Electronical stabilized LED Power Supply
Technical
Information
Edition: Nov. 2005
subject to change
Technical data:
Reference:
for LED modules:
Line voltage, nominal:
Line current, nominal:
Line frequency:
Nominal output voltage:
Nominal module wattage:
Efficiency:
Partial load:
Perm. voltage fluctuations:
Power factor:
DC voltage operation:
Safety:
Radio interference:
Harmonic content:
Immunity:
Temperature range:
Galvanic insulation between
primary and secondary side:
Non-load proof:
Short circuit protection:
Overload protection:
Overheating protection:
Dimming
Wiring:
Wire cross section, primary:
Secondary:
Wire cross section, secondary:
Max. cable length
Voltage Drop Compensation
Geometry (l x b x h):
Approvals:
OT 50/220-240/10
With respect to the output conditions:
LINEARlight, LINEARlight Flex, BACKlight and
appropriate modules
220 – 240 VAC
0,260 Aeff @ 230 VAC
0/50/60 Hz
DC voltage 10,5 VDC
electronical stabilized, line ripple max. ± 0,2 V
50W
90%
0.4W – 50W
198 - 254 VAC
0.97
Yes (176 – 264 V)
EN 61347-2-2
EN 55015
EN 61000-3-2
EN 61547
-20 °C bis +50 °C
3 kVeff
Yes
Autom. shutoff, reversible
autom. output power reduction and shutoff, reversible
autom. output power reduction and shutoff, reversible
Possible with OT DIM
DIN 57281 H03VV-F 2x0,50; H03VV-F 2x0,75;
H05VV-F 2x0,75; Nym 3x1,5
3 pairs screw terminals
DIN 57281 H03VV-F 2x0,75; H05VV-F 2x0,75;
H05VV-F 2x1,00; H05VV-F 2x1,5; H05VV-F 2x2,5
10m with 2,5 mm² massive leads w/o OT DIM
7m with 2,5 mm² massive leads with OT DIM
Yes, max. 0,5V for remote mounting
220 mm x 46,2 mm x 43,6 mm
OT 50/220-240/10
Electronical stabilized LED Power Supply
Technical
Information
Edition: Nov. 2005
subject to change
Mounting Instructions:
There is the possibility of through wiring on the primary side, therefore the power supplies offer a second
line terminal. Be aware that not more than 10A can be connected through these terminals!