Kinetis KL46: 48MHz Cortex-M0+ 128/256KB Flash 64-121pin
... 1. PTB0, PTB1, PTD6, and PTD7 I/O have both high drive and normal drive capability selected by the associated PTx_PCRn[DSE] control bit. All other GPIOs are normal drive only. 2. The reset pin only contains an active pull down device when configured as the RESET signal or as a GPIO. When configured ...
... 1. PTB0, PTB1, PTD6, and PTD7 I/O have both high drive and normal drive capability selected by the associated PTx_PCRn[DSE] control bit. All other GPIOs are normal drive only. 2. The reset pin only contains an active pull down device when configured as the RESET signal or as a GPIO. When configured ...
Kinetis K22: 120 MHz Cortex-M4F up to 1MB Flash (144 pin)
... All digital I/O switching characteristics assume: 1. output pins • have CL=30pF loads, • are configured for fast slew rate (PORTx_PCRn[SRE]=0), and • are configured for high drive strength (PORTx_PCRn[DSE]=1) 2. input pins • have their passive filter disabled (PORTx_PCRn[PFE]=0) ...
... All digital I/O switching characteristics assume: 1. output pins • have CL=30pF loads, • are configured for fast slew rate (PORTx_PCRn[SRE]=0), and • are configured for high drive strength (PORTx_PCRn[DSE]=1) 2. input pins • have their passive filter disabled (PORTx_PCRn[PFE]=0) ...
Kinetis KL26: 48MHz Cortex-M0+ 32-128KB Flash 32-64pin
... 1. PTB0, PTB1, PTD6, and PTD7 I/O have both high drive and normal drive capability selected by the associated PTx_PCRn[DSE] control bit. All other GPIOs are normal drive only. 2. The reset pin only contains an active pull down device when configured as the RESET signal or as a GPIO. When configured ...
... 1. PTB0, PTB1, PTD6, and PTD7 I/O have both high drive and normal drive capability selected by the associated PTx_PCRn[DSE] control bit. All other GPIOs are normal drive only. 2. The reset pin only contains an active pull down device when configured as the RESET signal or as a GPIO. When configured ...
Kinetis K22: 120 MHz Cortex-M4F up to 1MB Flash (80 pin)
... All digital I/O switching characteristics assume: 1. output pins • have CL=30pF loads, • are configured for fast slew rate (PORTx_PCRn[SRE]=0), and • are configured for high drive strength (PORTx_PCRn[DSE]=1) 2. input pins • have their passive filter disabled (PORTx_PCRn[PFE]=0) ...
... All digital I/O switching characteristics assume: 1. output pins • have CL=30pF loads, • are configured for fast slew rate (PORTx_PCRn[SRE]=0), and • are configured for high drive strength (PORTx_PCRn[DSE]=1) 2. input pins • have their passive filter disabled (PORTx_PCRn[PFE]=0) ...
Kinetis KL16: 48MHz Cortex-M0+ 32-128KB Flash 32
... 1. PTB0, PTB1, PTD6, and PTD7 I/O have both high drive and normal drive capability selected by the associated PTx_PCRn[DSE] control bit. All other GPIOs are normal drive only. 2. The reset pin only contains an active pull down device when configured as the RESET signal or as a GPIO. When configured ...
... 1. PTB0, PTB1, PTD6, and PTD7 I/O have both high drive and normal drive capability selected by the associated PTx_PCRn[DSE] control bit. All other GPIOs are normal drive only. 2. The reset pin only contains an active pull down device when configured as the RESET signal or as a GPIO. When configured ...
microEFIS BACKUP ELECTRONIC ATTITUDE REFERENCE SYSTEM
... as a portable device, not permanently connected to the aircraft. Under the FAR’s for portable equipment carried in the aircraft, It is the pilot’s responsibility to verify that its use does not cause any harmful interference to any aircraft communications or navigation system. This equipment has bee ...
... as a portable device, not permanently connected to the aircraft. Under the FAR’s for portable equipment carried in the aircraft, It is the pilot’s responsibility to verify that its use does not cause any harmful interference to any aircraft communications or navigation system. This equipment has bee ...
User`s guide
... around the roll, pitch and yaw axis and also sense the aircraft orientation relative to the earth. Three gyroscopes are required to accurately determine aircraft attitude in a strap-down INS. This is required because the aircraft attitude determination requires yaw angular sensing whenever the aircr ...
... around the roll, pitch and yaw axis and also sense the aircraft orientation relative to the earth. Three gyroscopes are required to accurately determine aircraft attitude in a strap-down INS. This is required because the aircraft attitude determination requires yaw angular sensing whenever the aircr ...
TinyTrak4 Kit Hardware Manual v0.65
... TinyTrak4 is a radio controller similar to a packet TNC, which can transmit and receive signals over a two-way radio. It can receive and broadcast position reports from a GPS receiver, decode incoming packet tones, is field programmable, and more. The TinyTrak4 is interfaced to a radio transceiver s ...
... TinyTrak4 is a radio controller similar to a packet TNC, which can transmit and receive signals over a two-way radio. It can receive and broadcast position reports from a GPS receiver, decode incoming packet tones, is field programmable, and more. The TinyTrak4 is interfaced to a radio transceiver s ...
PG2325382543
... ISSN: 2248-9622 www.ijera.com Vol. 2, Issue 3, May-Jun 2012, pp.2538-2543 If very precise timing is not received in that case accidental situation arises. UTC time is obtained using several different methods, including radio and satellite systems. Specialized receivers are available for high-level s ...
... ISSN: 2248-9622 www.ijera.com Vol. 2, Issue 3, May-Jun 2012, pp.2538-2543 If very precise timing is not received in that case accidental situation arises. UTC time is obtained using several different methods, including radio and satellite systems. Specialized receivers are available for high-level s ...
Time transfer through optical fibers over a distance of 73 km with an
... the employed systems, but not necessarily the accuracy to compare epochs of the two (or more) clocks involved. In previous experiments [10] we demonstrated time transfer using optical fibers (TTTOF) on the PTB campus with a reproducibility of better than 100 ps. The two-way technique employed guaran ...
... the employed systems, but not necessarily the accuracy to compare epochs of the two (or more) clocks involved. In previous experiments [10] we demonstrated time transfer using optical fibers (TTTOF) on the PTB campus with a reproducibility of better than 100 ps. The two-way technique employed guaran ...
[device] datasheet
... Do not place device near water or other liquids! Install GSM/GPS antena below glass or plastic. Avoid installation below metal surfaces which can disturb GSM/GPS signal receiving and transmission! Supply device with voltage as described in this instrution manual! It is recommended to choose installa ...
... Do not place device near water or other liquids! Install GSM/GPS antena below glass or plastic. Avoid installation below metal surfaces which can disturb GSM/GPS signal receiving and transmission! Supply device with voltage as described in this instrution manual! It is recommended to choose installa ...
RI-12
... (a) To 10 degrees either side of the course along a radius of 18 NM from the antenna, and (b) From 10 to 35 degrees either side of the course along a radius of 10 NM. (See Figure 1-1-6.) 6. Unreliable signals may be received outside these areas. ...
... (a) To 10 degrees either side of the course along a radius of 18 NM from the antenna, and (b) From 10 to 35 degrees either side of the course along a radius of 10 NM. (See Figure 1-1-6.) 6. Unreliable signals may be received outside these areas. ...
VersaSync Rugged Time and Frequency Reference
... • Sensor support (radar, sonar, optronics, electronic warfare) • Communication networks • Offshore/DSO platforms • Buoys ...
... • Sensor support (radar, sonar, optronics, electronic warfare) • Communication networks • Offshore/DSO platforms • Buoys ...
Tri axis inertial measurement Analog Devices debuts tri
... Analog Devices chose Sensors Expo to extend its iSensor intelligent sensor product family with a motion sensor that allows industrial designers to easily and costeffectively equip their products with full-range, multi-axis inertial sensing. Leveraging Analog Devices’ iMEMS Motion Signal Processing T ...
... Analog Devices chose Sensors Expo to extend its iSensor intelligent sensor product family with a motion sensor that allows industrial designers to easily and costeffectively equip their products with full-range, multi-axis inertial sensing. Leveraging Analog Devices’ iMEMS Motion Signal Processing T ...
File - Lexus Pressroom
... determine the position and orientation of an object. The Global Positioning System (GPS) is a space-based satellite navigation system that provides location and time information in all weather conditions, anywhere on or near the Earth where there is an unobstructed line of sight to four or more GPS ...
... determine the position and orientation of an object. The Global Positioning System (GPS) is a space-based satellite navigation system that provides location and time information in all weather conditions, anywhere on or near the Earth where there is an unobstructed line of sight to four or more GPS ...
Final PosterPresentations-36×48
... facilities and amenities for the development of our project. We would like to thank our HOD Mr. Bhavesh Patel and Project Guide, Mr. Vishal Jethva for helping us in the successful accomplishment of our project and gave us constant guidance and support throughout this journey of turbulence. We are ex ...
... facilities and amenities for the development of our project. We would like to thank our HOD Mr. Bhavesh Patel and Project Guide, Mr. Vishal Jethva for helping us in the successful accomplishment of our project and gave us constant guidance and support throughout this journey of turbulence. We are ex ...
Women Security Assistance system with GPS tracking and
... sending message like (message sending to cell *********). GPS gives only the longitude and latitude values but by using Android application in the mobile we can easily get the location name from where the message has been sent. The controller takes the switch as its input i.e when some threat has oc ...
... sending message like (message sending to cell *********). GPS gives only the longitude and latitude values but by using Android application in the mobile we can easily get the location name from where the message has been sent. The controller takes the switch as its input i.e when some threat has oc ...
Interim Stations Review
... Write your name, date, and period number on your paper. Include your original station number at the top, left hand corner of your paper. Make sure you have evidence, in the form of a solved question and answer, for each standard. ...
... Write your name, date, and period number on your paper. Include your original station number at the top, left hand corner of your paper. Make sure you have evidence, in the form of a solved question and answer, for each standard. ...
GPS navigation device
A GPS navigation device is a device that accurately calculates geographical location by receiving information from GPS satellites. Initially it was used by the United States military, but now most receivers are in automobiles and smartphones.The Global Positioning System (GPS) is a satellite-based navigation system made up of a network of a minimum of 24, but currently 30, satellites placed into orbit by the U.S. Department of Defense. Military action was the original intent for GPS, but in the 1980s, the U.S. government decided to allow the GPS program to be used by civilians. The satellite data is free and works anywhere in the world.GPS devices may have capabilities such as: maps, including streets maps, displayed in human readable format via text or in a graphical format, turn-by-turn navigation directions to a human in charge of a vehicle or vessel via text or speech, directions fed directly to an autonomous vehicle such as a robotic probe, traffic congestion maps (depicting either historical or real time data) and suggested alternative directions, information on nearby amenities such as restaurants, fueling stations, and tourist attractions.GPS devices may be able to indicate: the roads or paths available, traffic congestion and alternative routes, roads or paths that might be taken to get to the destination, if some roads are busy (now or historically) the best route to take, The location of food, banks, hotels, fuel, airports or other places of interests, the shortest route between the two locations, the different options to drive on highway or back roads.↑