Cisco ONS 15454 MSPP Engineering Planning Guide, Release 4.0
... Chapter 1 – System Overview....................................................................................................... 24 Purpose...................................................................................................................................... 24 Contents............. ...
... Chapter 1 – System Overview....................................................................................................... 24 Purpose...................................................................................................................................... 24 Contents............. ...
6 Multi-layer Recovery Strategy in Resilient Packet
... Thus, the introduction of RPR-based metropolitan networks is gaining importance and it represents a very promising networking solution to transport data traffic in a short/medium term. In fact, the IEEE 802.17 RPR standard has been approved in June 2004 and thus, network equipments standard-complian ...
... Thus, the introduction of RPR-based metropolitan networks is gaining importance and it represents a very promising networking solution to transport data traffic in a short/medium term. In fact, the IEEE 802.17 RPR standard has been approved in June 2004 and thus, network equipments standard-complian ...
Chapter 9: Wavelength Routing Optical Networks
... The input optical signals are converted to electrical signals, from where the packets are extracted. Packets are switched using a packet switch, and then they are transmitted out of the switch in the optical domain. ...
... The input optical signals are converted to electrical signals, from where the packets are extracted. Packets are switched using a packet switch, and then they are transmitted out of the switch in the optical domain. ...
Lecture 8 - cda college
... Technologies Compatible with ATM B-ISDN DSL FDDI Frame relay Gigabit and 10 Gigabit Ethernet SONET and SDH SMDS Wireless communication ...
... Technologies Compatible with ATM B-ISDN DSL FDDI Frame relay Gigabit and 10 Gigabit Ethernet SONET and SDH SMDS Wireless communication ...
Document
... • Other two routers are drop routers connected to client devices. • Two connections from the network port at the ingress service router to two drop ports, one in each of the drop routers. Client device sends 50% of the traffic on one of these drop interfaces and 50% on the other (it is attached to b ...
... • Other two routers are drop routers connected to client devices. • Two connections from the network port at the ingress service router to two drop ports, one in each of the drop routers. Client device sends 50% of the traffic on one of these drop interfaces and 50% on the other (it is attached to b ...
The 5 MEF Attributes of Carrier Ethernet & Inter
... • Rapid recovery time when problems do occur; as low as 50ms. ...
... • Rapid recovery time when problems do occur; as low as 50ms. ...
Asynchronous Transfer Mode
... Provides service to the application layer Convergence sublayer deals with messages and interface to the application Segments varying length messages into 48 or 44 bytes(4 bytes for AAL info. Optional) each and assembles them at the other end Offers three types of services ...
... Provides service to the application layer Convergence sublayer deals with messages and interface to the application Segments varying length messages into 48 or 44 bytes(4 bytes for AAL info. Optional) each and assembles them at the other end Offers three types of services ...
Connection-oriented internetworking
... (to support CO internetworking) • Cisco 15454 and Movaz box – Can map all frames arriving on a port to a SONET circuit or wavelength • SDM ↔ SONET or WDM • Unsure whether Ethernet cards are capable of processing VLAN IDs or IP header fields to then decide which ones to map to a certain SONET circuit ...
... (to support CO internetworking) • Cisco 15454 and Movaz box – Can map all frames arriving on a port to a SONET circuit or wavelength • SDM ↔ SONET or WDM • Unsure whether Ethernet cards are capable of processing VLAN IDs or IP header fields to then decide which ones to map to a certain SONET circuit ...
Chapter 9: Wavelength Routing Optical Networks
... Features of the G.709 standard • Types of traffic: The standard permits the transmission of different types of traffic, such as: – IP packets and Gb Ethernet frames using GFP – ATM cells – SONET/SDH synchronous data. ...
... Features of the G.709 standard • Types of traffic: The standard permits the transmission of different types of traffic, such as: – IP packets and Gb Ethernet frames using GFP – ATM cells – SONET/SDH synchronous data. ...
A review on Gigabit Passive Optical Network (GPON)
... which assigns variable time length slots to each ONU for This informs the OLT that the grants for that T-CONT can transmission of its data bursts. The upstream frame be assigned to other T-CONTs. If an ONU has a long consists of multiple transmission bursts. Each upstream queue waiting in its buffer ...
... which assigns variable time length slots to each ONU for This informs the OLT that the grants for that T-CONT can transmission of its data bursts. The upstream frame be assigned to other T-CONTs. If an ONU has a long consists of multiple transmission bursts. Each upstream queue waiting in its buffer ...
DCN-II
... 37. In the OSI model, when data is transmitted from device A to device B, the header from A's layer 5 is read by B's _______ layer. A) B) C) D) ...
... 37. In the OSI model, when data is transmitted from device A to device B, the header from A's layer 5 is read by B's _______ layer. A) B) C) D) ...
Infrastructure Design for IPTV Services
... Divide into subgraphs with two sources and a destination Solve for each graph, and consolidate solutions ...
... Divide into subgraphs with two sources and a destination Solve for each graph, and consolidate solutions ...
ATM
... networks. The Simple and Efficient Adaptation Layer (SEAL), attempts to reduce the complexity and overhead of AAL 3/4. It eliminates most of the overhead of AAL 3/4. AAL 5 comprises a convergence sublayer and a SAR sublayer, although the SAR is essentially null. Streamlined transport for con ...
... networks. The Simple and Efficient Adaptation Layer (SEAL), attempts to reduce the complexity and overhead of AAL 3/4. It eliminates most of the overhead of AAL 3/4. AAL 5 comprises a convergence sublayer and a SAR sublayer, although the SAR is essentially null. Streamlined transport for con ...
ppt 3.8MB - Star Tap
... In a transient service environment protection is not as expensive – Telco thinking: 1+1 protection is expensive- I need to plan for twice the capacity, therefore I need to charge my customer twice as much (bronze service, silver service, platinum service, …) – Grid thinking: Provide as much protecti ...
... In a transient service environment protection is not as expensive – Telco thinking: 1+1 protection is expensive- I need to plan for twice the capacity, therefore I need to charge my customer twice as much (bronze service, silver service, platinum service, …) – Grid thinking: Provide as much protecti ...
The IEEE 802.3 Standard (Ethernet):
... send data at the same time. There are sophisticated techniques used to keep this from occurring on a regular basis. These techniques will be discussed later. When a node on an Ethernet network wishes to send information to another node, it first listens to the network to see if there is network tra ...
... send data at the same time. There are sophisticated techniques used to keep this from occurring on a regular basis. These techniques will be discussed later. When a node on an Ethernet network wishes to send information to another node, it first listens to the network to see if there is network tra ...
OTN Network Based on DWDM Network
... equipment within banded or mesh networks. Transmits SDH services, without termination of the signal at each network element, the signal transport is transparent including the clock and byte header. Easily combine multiple networks and services on a common infrastructure entirely in the optical domai ...
... equipment within banded or mesh networks. Transmits SDH services, without termination of the signal at each network element, the signal transport is transparent including the clock and byte header. Easily combine multiple networks and services on a common infrastructure entirely in the optical domai ...
Network and Service Discovery in Distributed Environments
... Second scheme: At the Wavelength Level [6] • applied to cross-connected mesh architectures • slower but more bandwidth efficient • Three variants: • link • fastest failure detection • recovery is local to one point (i.e. @ link level) • path • reroutes between two end nodes • full advantage of netwo ...
... Second scheme: At the Wavelength Level [6] • applied to cross-connected mesh architectures • slower but more bandwidth efficient • Three variants: • link • fastest failure detection • recovery is local to one point (i.e. @ link level) • path • reroutes between two end nodes • full advantage of netwo ...
Traffic Engineering in IP over Optical Area Environments
... Figure 2: Evolution path towards data-optimized networks............................................................................... 3 Figure 3: Weekly incoming/outgoing traffic from the Catalan R&A Network, November 2004, 8-15 ........... 12 Figure 4: Weekly incoming/outgoing traffic from the Ca ...
... Figure 2: Evolution path towards data-optimized networks............................................................................... 3 Figure 3: Weekly incoming/outgoing traffic from the Catalan R&A Network, November 2004, 8-15 ........... 12 Figure 4: Weekly incoming/outgoing traffic from the Ca ...
5_atm
... When transmitting many low/variable bit rate signals between two end-points using ATM, AAL 2 provides low packetization delay and high bandwidth efficiency at the same time AAL 1 used => low delay means low efficiency: ...
... When transmitting many low/variable bit rate signals between two end-points using ATM, AAL 2 provides low packetization delay and high bandwidth efficiency at the same time AAL 1 used => low delay means low efficiency: ...
Omni Switch/Router Sales presentation
... fully distributed, multi-protocol layer-three switching ASIC ...
... fully distributed, multi-protocol layer-three switching ASIC ...
PPT
... Overhead of setting up VCs (delay for first packet) Complexity of managing a pool of VCs Flexible bandwidth management Can use ATM QoS support for individual connections (with appropriate signaling support) Lecture #19: 11-08-01 ...
... Overhead of setting up VCs (delay for first packet) Complexity of managing a pool of VCs Flexible bandwidth management Can use ATM QoS support for individual connections (with appropriate signaling support) Lecture #19: 11-08-01 ...
Synchronous optical networking
Synchronous Optical Networking (SONET) and Synchronous Digital Hierarchy (SDH) are standardized protocols that transfer multiple digital bit streams synchronously over optical fiber using lasers or highly coherent light from light-emitting diodes (LEDs). At low transmission rates data can also be transferred via an electrical interface. The method was developed to replace the Plesiochronous Digital Hierarchy (PDH) system for transporting large amounts of telephone calls and data traffic over the same fiber without synchronization problems. SONET generic criteria are detailed in Telcordia Technologies Generic Requirements document GR-253-CORE. Generic criteria applicable to SONET and other transmission systems (e.g., asynchronous fiber optic systems or digital radio systems) are found in Telcordia GR-499-CORE.SONET and SDH, which are essentially the same, were originally designed to transport circuit mode communications (e.g., DS1, DS3) from a variety of different sources, but they were primarily designed to support real-time, uncompressed, circuit-switched voice encoded in PCM format. The primary difficulty in doing this prior to SONET/SDH was that the synchronization sources of these various circuits were different. This meant that each circuit was actually operating at a slightly different rate and with different phase. SONET/SDH allowed for the simultaneous transport of many different circuits of differing origin within a single framing protocol. SONET/SDH is not a communications protocol in itself, but a transport protocol.Due to SONET/SDH's essential protocol neutrality and transport-oriented features, SONET/SDH was the obvious choice for transporting the fixed length Asynchronous Transfer Mode (ATM) frames also known as cells. It quickly evolved mapping structures and concatenated payload containers to transport ATM connections. In other words, for ATM (and eventually other protocols such as Ethernet), the internal complex structure previously used to transport circuit-oriented connections was removed and replaced with a large and concatenated frame (such as STS-3c) into which ATM cells, IP packets, or Ethernet frames are placed.Both SDH and SONET are widely used today: SONET in the United States and Canada, and SDH in the rest of the world. Although the SONET standards were developed before SDH, it is considered a variation of SDH because of SDH's greater worldwide market penetration.SONET is subdivided into four sublayer with some factor such as the path, line, section and physical layer.The SDH standard was originally defined by the European Telecommunications Standards Institute (ETSI), and is formalized as International Telecommunication Union (ITU) standards G.707, G.783, G.784, and G.803. The SONET standard was defined by Telcordia and American National Standards Institute (ANSI) standard T1.105.