![ORBIS PRODUCT GUIDE](http://s1.studyres.com/store/data/015729759_1-940af9aefd2d9cb384542f2bd6f17aed-300x300.png)
A Designer`s Guide to Instrumentation Amplifiers
... All rights reserved. This publication, or parts thereof, may not be reproduced in any form without permission of the copyright owner. Information furnished by Analog Devices, Inc. is believed to be accurate and reliable. However, no responsibility is assumed by Analog Devices, Inc. for its use. Ana ...
... All rights reserved. This publication, or parts thereof, may not be reproduced in any form without permission of the copyright owner. Information furnished by Analog Devices, Inc. is believed to be accurate and reliable. However, no responsibility is assumed by Analog Devices, Inc. for its use. Ana ...
Negative Rail Input, Rail-to-Rail Out, Precision, 850
... – Single-Ended to Differential Amplifier – Differential to Differential Amplifier Differential Active Filters Differential Transimpedance for DAC Outputs DC- or AC-Coupled Interface to the ADC3xxx Family of Low-Power, High-Performance ADCs Pin-Compatible to ADA4932-1 (VQFN-16) ...
... – Single-Ended to Differential Amplifier – Differential to Differential Amplifier Differential Active Filters Differential Transimpedance for DAC Outputs DC- or AC-Coupled Interface to the ADC3xxx Family of Low-Power, High-Performance ADCs Pin-Compatible to ADA4932-1 (VQFN-16) ...
MAX9370/MAX9371/MAX9372 LVTTL/TTL-to-Differential LVPECL/PECL Translators General Description
... operation of the device at these or any other conditions beyond those indicated in the operational sections of the specifications is not implied. Exposure to absolute maximum rating conditions for extended periods may affect device reliability. ...
... operation of the device at these or any other conditions beyond those indicated in the operational sections of the specifications is not implied. Exposure to absolute maximum rating conditions for extended periods may affect device reliability. ...
Noise
... connections 200 ohms. When Zn = Zo, a and b only change phase if the reference plane is changed. • Wave noise parameters (i.e. (E) and (F) in previous figure) change when Zn is changed but Tn does not change. • An important case for (E) it that the input-to-output noise wave correlation coefficient, ...
... connections 200 ohms. When Zn = Zo, a and b only change phase if the reference plane is changed. • Wave noise parameters (i.e. (E) and (F) in previous figure) change when Zn is changed but Tn does not change. • An important case for (E) it that the input-to-output noise wave correlation coefficient, ...
VSOP383..
... • High immunity against ripple on the supply voltage • Output active low • IC manufactured in CMOS technology • Small QFN package with 2 mm width • Material categorization: for definitions of compliance please see www.vishay.com/doc?99912 ...
... • High immunity against ripple on the supply voltage • Output active low • IC manufactured in CMOS technology • Small QFN package with 2 mm width • Material categorization: for definitions of compliance please see www.vishay.com/doc?99912 ...
Microphone Measurements, Standards, and Specifications
... a twin-tone method in which two swept frequencies, separated by a fixed frequency interval, such as 1000 Hz, be applied to the microphone under test. Since the individual sweep tones are separately generated, they can be maintained at fairly low distortion; any difference tone generated by the diaph ...
... a twin-tone method in which two swept frequencies, separated by a fixed frequency interval, such as 1000 Hz, be applied to the microphone under test. Since the individual sweep tones are separately generated, they can be maintained at fairly low distortion; any difference tone generated by the diaph ...
A Designer`s Guide to Instrumentation Amplifiers
... All rights reserved. This publication, or parts thereof, may not be reproduced in any form without permission of the copyright owner. Information furnished by Analog Devices, Inc. is believed to be accurate and reliable. However, no responsibility is assumed by Analog Devices, Inc. for its use. Ana ...
... All rights reserved. This publication, or parts thereof, may not be reproduced in any form without permission of the copyright owner. Information furnished by Analog Devices, Inc. is believed to be accurate and reliable. However, no responsibility is assumed by Analog Devices, Inc. for its use. Ana ...
How to get the best ADC accuracy in STM32 microcontrollers
... Typical voltage source connection to ADC input . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 39 Noise observed on ADC input pin during ADC conversions . . . . . . . . . . . . . . . . . . . . . . . . 39 ADC simplified schematic of input stage - sample and hold circuit. . . . . . . . ...
... Typical voltage source connection to ADC input . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 39 Noise observed on ADC input pin during ADC conversions . . . . . . . . . . . . . . . . . . . . . . . . 39 ADC simplified schematic of input stage - sample and hold circuit. . . . . . . . ...
+5V-Powered, Multichannel RS-232 Drivers/Receivers General Description Next-Generation Device Features
... ROUT........................................................-0.3V to (VCC + 0.3V) Short-Circuit Duration, TOUT to GND ........................Continuous Continuous Power Dissipation (TA = +70°C) 14-Pin Plastic DIP (derate 10.00mW/°C above +70°C)....800mW 16-Pin Plastic DIP (derate 10.53mW/°C above + ...
... ROUT........................................................-0.3V to (VCC + 0.3V) Short-Circuit Duration, TOUT to GND ........................Continuous Continuous Power Dissipation (TA = +70°C) 14-Pin Plastic DIP (derate 10.00mW/°C above +70°C)....800mW 16-Pin Plastic DIP (derate 10.53mW/°C above + ...
AD9221 数据手册DataSheet下载
... The AD9221/AD9223/AD9220 combine a low cost, high speed CMOS process and a novel architecture to achieve the resolution and speed of existing hybrid and monolithic implementations at a fraction of the power consumption and cost. Each device is a complete, monolithic ADC with an on-chip, high perform ...
... The AD9221/AD9223/AD9220 combine a low cost, high speed CMOS process and a novel architecture to achieve the resolution and speed of existing hybrid and monolithic implementations at a fraction of the power consumption and cost. Each device is a complete, monolithic ADC with an on-chip, high perform ...
AD8271 数据手册DataSheet 下载
... Internal resistors, trimmed to be ratio matched, have ±20% absolute accuracy. Common-mode resistance was calculated with both inputs in parallel. The commonmode impedance at only one input is 2× the resistance listed. ...
... Internal resistors, trimmed to be ratio matched, have ±20% absolute accuracy. Common-mode resistance was calculated with both inputs in parallel. The commonmode impedance at only one input is 2× the resistance listed. ...
AD7868 LC2MOS Complete, 12-Bit Analog I/O
... The AD7868 is a complete 12-bit I/O port, the only external components required for normal operation are pull-up resistors for the ADC data outputs and power supply decoupling capacitors. It is comprised of a 12-bit successive approximation ADC with a track/hold amplifier, a 12-bit DAC with a buffer ...
... The AD7868 is a complete 12-bit I/O port, the only external components required for normal operation are pull-up resistors for the ADC data outputs and power supply decoupling capacitors. It is comprised of a 12-bit successive approximation ADC with a track/hold amplifier, a 12-bit DAC with a buffer ...
EE6303 Click here to
... when describing the theoretical concept, from there came the terms for SSI, MSI, VLSI, and ULSI. They began to appear in consumer products at the turn of the decade, a typical application being FM inter-carrier sound processing in television receivers. The next step in the development of integrated ...
... when describing the theoretical concept, from there came the terms for SSI, MSI, VLSI, and ULSI. They began to appear in consumer products at the turn of the decade, a typical application being FM inter-carrier sound processing in television receivers. The next step in the development of integrated ...
AD9221/AD9223/AD9220 Complete 12
... amplifier (SHA) is equally suited for both multiplexed systems that switch full-scale voltage levels in successive channels as well as sampling single-channel inputs at frequencies up to and beyond the Nyquist rate. Also, the AD9221/AD9223/AD9220 is well suited for communication systems employing Di ...
... amplifier (SHA) is equally suited for both multiplexed systems that switch full-scale voltage levels in successive channels as well as sampling single-channel inputs at frequencies up to and beyond the Nyquist rate. Also, the AD9221/AD9223/AD9220 is well suited for communication systems employing Di ...
MAX3222/MAX3232/MAX3237/MAX3241* 3.0V to 5.5V, Low-Power, up to 1Mbps, True RS-232 ________________General Description
... modems to be monitored using only 1µA supply current. The MAX3222 and MAX3232 are pin, package, and functionally compatible with the industry-standard MAX242 and MAX232, respectively. The MAX3241 is a complete serial port (3 drivers/ 5 receivers) designed for notebook and subnotebook computers. The ...
... modems to be monitored using only 1µA supply current. The MAX3222 and MAX3232 are pin, package, and functionally compatible with the industry-standard MAX242 and MAX232, respectively. The MAX3241 is a complete serial port (3 drivers/ 5 receivers) designed for notebook and subnotebook computers. The ...
Op Amps
... Op Amp Definition Op Amps use external power supply, at positive +VCC and a at the second negative -VCC voltage pin Not necessarily of same voltage, but usually absolute values are equal: |+VCC| = |-VCC| Common power voltages are + - 5 V to + - 15 V, rarely over 20 V Op Amps generally are u ...
... Op Amp Definition Op Amps use external power supply, at positive +VCC and a at the second negative -VCC voltage pin Not necessarily of same voltage, but usually absolute values are equal: |+VCC| = |-VCC| Common power voltages are + - 5 V to + - 15 V, rarely over 20 V Op Amps generally are u ...
MODEL SR850 DSP Lock-In Amplifier
... unless another person, capable of providing first aid or resuscitation, is present. ...
... unless another person, capable of providing first aid or resuscitation, is present. ...
Model No. KX-TG1711MEB KX-TG1712MEB KX
... 12.3. Terminal Guide of the ICs, Transistors, Diodes and Electrolytic Capacitors-----------------------------48 13 Schematic Diagram ---------------------------------------------49 13.1. For Schematic Diagram---------------------------------49 13.2. Schematic Diagram (Base Unit) -------------------- ...
... 12.3. Terminal Guide of the ICs, Transistors, Diodes and Electrolytic Capacitors-----------------------------48 13 Schematic Diagram ---------------------------------------------49 13.1. For Schematic Diagram---------------------------------49 13.2. Schematic Diagram (Base Unit) -------------------- ...
Heterodyne
Heterodyning is a radio signal processing technique invented in 1901 by Canadian inventor-engineer Reginald Fessenden, in which new frequencies are created by combining or mixing two frequencies. Heterodyning is used to shift one frequency range into another, new one, and is also involved in the processes of modulation and demodulation. The two frequencies are combined in a nonlinear signal-processing device such as a vacuum tube, transistor, or diode, usually called a mixer. In the most common application, two signals at frequencies f1 and f2 are mixed, creating two new signals, one at the sum f1 + f2 of the two frequencies, and the other at the difference f1 − f2. These new frequencies are called heterodynes. Typically only one of the new frequencies is desired, and the other signal is filtered out of the output of the mixer. Heterodynes are related to the phenomenon of ""beats"" in acoustics.A major application of the heterodyne process is in the superheterodyne radio receiver circuit, which is used in virtually all modern radio receivers.